Question about Kia Sedona

2 Answers

I have a 02 kia carnival with central locking and i wont to fit a steel mate 386m key less entry system. Where do i connect it in on the carnival ? I don't have a wiring diagram for the car. Any advice would be appreciated.

Posted by on

  • pcradtke Oct 07, 2010

    Thanks Joe,

    I was kind of hoping to install it myself but by asking around
    that's the same conclusion that I seen to come to every time.
    So to make sure not to mess it up that's the way to go.

    Thank you for your help, it is good.

    Cheers
    Peter

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Kia Master
  • 22,326 Answers

I would forget adding a boy boy racer gizmo ,these kias are very susceptable to being played with and then the immobilisor will come on and only a dealer can reset it becaue the diagnostic plug is under the bonnet and the OBDII inside the vehicle is all for show .The best antitheft device i can recommend is a steering wheel lock /bar that goes throught the spokes of the steerinig wheel ,i must answer at least two or three questions in an hour or two about cars not starting and how to remove these things . If someone wants to steal it they will break into your house and get the keys or just lift it with a breakdown truck and no one will even bat a eyelid .You are just creating a big proble and headache in a year or two when it packs up

Posted on Oct 07, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,865 Answers

Hello. Your best bet is to locate the nearest autoelectric repair shop in the area. These shops have access to all of the wiring diagrams and the diagnostic equipment necessary to do an alteration such as the one you are planning. Joe

4 thumbs up please. ty

Posted on Oct 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Central locking


Please check owners manual for testing or resetting your key-less entry. Knowing the year and model will always save time. If you have time watch this youtube vid for 2016`s
How to Use the 2016 Honda Fit Key Fob I hope this helps you!

Feb 05, 2018 | Honda Cars & Trucks

2 Answers

Locks on Back Doors, and more...


This is because your master switch on the drivers door may have corroded oxidation on the contacts inside the switch and that master switch is the feed for all inside door lock switches your remote and keypad work because those electrical signals go through the driver door module you must clean all contacts on the master switch get them shiny you can use 4/0 steel wool and alcohol and also take the lock switch apart and clean the button contacts inside the switch for this use alcohol and 1000 grit sandpaper glued to a pencil and lightly spin in your fingers to shine the contacts sometimes just an eraser works but it depends on the quality of it so go with the sandpaper glued to the pencil or any circular object that will fit inside after this blow out the switch and use the alcohol to clean out and let dry

Feb 11, 2018 | 2002 Ford Expedition

1 Answer

Code p2187 and engine kight


I have checked the data sheet and I have no reference for the code you have given. All I can tell you is that it could be a poor or no connection to the air heater element or a wiring harness fault near the air intake air pipe.

Apr 27, 2013 | 2006 Kia Carnival 2.9

1 Answer

Kia carnival 2002 lost keys


You must seek out a dealer or a local well equipped locksmith, since you have no working key this will be very expensive.

Aug 07, 2012 | Cars & Trucks

1 Answer

Electrical


Try disconnecting the battery negative cable for 5 minutes and see if the body ontrol module resets. If that doesn't happen you will need to seek the assist of a Kia dealer service dept.

Jul 02, 2012 | 2006 Kia Carnival 2.7

4 Answers

2003 330XI keyless entry. wont open or close.


The transponder is not effective any longer sometimes the battery of the remote is very low which needs to be replaced

Jan 17, 2018 | BMW 330xi Cars & Trucks

1 Answer

Key less entry stopped working


poss low charge in battery in keys..... nearer you get lower the battery life.....

Feb 23, 2010 | 2003 Mitsubishi Lancer

1 Answer

Car alarm not activating central locking


It means that the remote is not passing the signal to the car . The alarm has triggered because the system has detected an illegal entry. Replace the remote batteries

Sep 10, 2008 | 2006 Mitsubishi Colt

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

yadayada
yadayada

Level 3 Expert

80531 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...