Question about 1997 Mitsubishi Eclipse

Open Question

1997 mitsubishi eclipse manual engine wont turn over

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 87 Answers

SOURCE: turn signal will not turn off

You May need to replace the turn signal Switch/lever assembly on your car , do the turn signals work at all ? if they don't try the 4 way flasher , if the 4 way flasher's work suspect the turn signal switch .

Hope this helps

Posted on Dec 19, 2008

Ad
dustyboner
  • 338 Answers

SOURCE: self diagnostic test codes

anytime you do the self-diagnostic you will almost always get those 2 codes.

12 - direct power input to the PCM has been disconnected within the last 50 key-on cycles

55 - End of error messages

Posted on Jan 25, 2009

canbruce75
  • 1776 Answers

SOURCE: where is the turn signal flasher for a 1997

The turn signal flasher unit in the Mitsubishi Eclipse should be located behind the air conditioning and heater control panel in the center console. Hope this helps you and best wishes.

Posted on Jul 24, 2009

  • 6 Answers

SOURCE: code 1494

Did you mean p1494? If so then its your evaporative emission ventilation switch or a mechanical fault, probable causes:

  1. Evaporative Emission Ventilation Solenoid failed
  2. An open or short circuit.
  3. Vacuum hose clogged.
  4. PCM Failed
Check the following:

  1. Check the following connectors: A-109, B-76, B-63, A-107. Repair if needed. If its ok then check:
  2. Check the harness wire between the Evaporative Emission Ventilation Solenoid connector. If its ok then:
  3. Replace PCM
This information was retrieved from AllData :

Posted on Sep 15, 2009

  • 18 Answers

SOURCE: 1997 mitsubishi eclipse gst wont start it looks

Remove the bottom of your back seat. Turn the ignition on without cranking the car. You should hear the fuel pump prime for a few seconds and shut off. If you don't hear that sound, there are two relays on the right side of the firewall next to the master cylinder that are part of the fuel system. I had one go bad on me (the contact corroded) and didn't know which one it might be so I bought the cheaper of the two. Haven't had a problem since!

Posted on Jan 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1997 Mitsubishi Eclipse i took the battery out and put it back on now car wont start i charged battery and everything i believe it has someting to do with the Security system it has chip key when...


your very correct it is the Security System. The only way to fix this is have it towed to the dealer and have them reprogram the key to the car. its simnple and quick and should cost under $100

Apr 14, 2010 | 1997 Mitsubishi Eclipse

2 Answers

Engine propblem


usually when you get white smoke its because ur head gasket blew mixing antifreeze and engine oil look at ur oil and see if its a milky white color.car will not start beacuse ur loosing compression threw the gasket blowing..

Mar 22, 2010 | 1997 Mitsubishi Eclipse

1 Answer

Temp. gauge not working on my 1997 eclipse


check to make sure the temperature sending unit wire is still connected ,turn key on and disconnect temp wire from sensor to see if you have any voltage,if you do replace the unit.

Dec 26, 2009 | 1997 Mitsubishi Eclipse

1 Answer

PUT IN A NEW CYLINDER BLOCK NEED TO TIME IT NOW


This is a complex job. You could try and get the Hanyes manual. Because, if you make a bad adjustment, the engine is totalled!

In the meantime, you put in a new timing-belt, water-pump, and torque the head. The Crank-pulley and the cam-sproket must be lined up in proper positions. That's why you need a good manual.

Oct 29, 2009 | 1997 Mitsubishi Eclipse

1 Answer

Car overheated now wont star


Need more details, But something that would help me is if you would do a compression test. This may give me info of a possible blown headgasket. If this is the case it could be the reason for the broken hose along with the blown headgasket.

Sep 09, 2009 | 1997 Mitsubishi Eclipse

2 Answers

I have 1993 eclipse and when i try to start it the cams wont turn why wont they turn?


Hi there had the same problem, if the motor still turns over and the cam's do not move you might have the oil pump freeze up on you>>

Jun 28, 2009 | 1997 Mitsubishi Eclipse

1 Answer

1997 2.0 y code engine mitsubishi eclipse


P1390 - Timing belt skipped 1(or more) tooth

0b673e2.jpg

(click for full size)
cfc747a.jpg

Jan 21, 2009 | 1997 Mitsubishi Eclipse

1 Answer

Self diagnostic test codes


anytime you do the self-diagnostic you will almost always get those 2 codes.

12 - direct power input to the PCM has been disconnected within the last 50 key-on cycles

55 - End of error messages

Dec 27, 2008 | 1997 Mitsubishi Eclipse

Not finding what you are looking for?
1997 Mitsubishi Eclipse Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...