Question about 1992 Mercury Sable

1 Answer

1992 merc sable wipers wont work clicking noise from behind dash when i work the switch have replaced motor with new one no help

Posted by on

  • Joshua Dempsey
    Joshua Dempsey Oct 06, 2010

    Do your wiper arms move freely like they are supposed too. If so check the wires or the switch


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 32 Answers

The arms have not been hooked up correctly and have most likey fell off

Posted on Oct 06, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to check temp blend door accuator 2000 merc sable

is it not working at all ? turn key on with motor off and switch to different positions and lesson for noises it may be the blender door is hitting a obstruction .... pen -pencil fell down vent

Sep 29, 2014 | 2000 Mercury Sable

3 Answers

1996 ford ranger wipers wont work fuse ok,new wiper motor,new switch, new relays. what else is there?

Do you have int wipers? If so check the int module its under the dash right side of the steering column I believe. Specifically check the solder joints.

Jun 14, 2014 | 1995 Ford Ranger Supercab

1 Answer

Windshield wipers won't work. It is not the motor, multi-function control switch, or the circuit breaker. Could it be the relay module, and if so, how do I get to it?

Ford likes putting these behind the glove box. you can lower the box by pushing up on the tab at the top, center of the box. There could be two modules there. the smaller one is the wiper control module.

Feb 13, 2011 | 1992 Mercury Sable

1 Answer

My wiper moter and spray quite i replaced the moter no change fuses look good as well 1992 mercury capri xr2

If both the wiper motor and the washer motor do not work, then it is the 25 amp fuse, or the wiper control module in the dash...possibly the switch in the steering column, but I doubt that...

Feb 06, 2011 | 1992 Mercury Capri

1 Answer

Wipers wont work on any speed fuses are good replaced motor all linkages are connected just here clicking noise from behind dash when I work the switch

it is probably a bad relay if you hear clicking in the dash. listen for the sound, its probably in the kick panel.

Oct 06, 2010 | 1992 Mercury Sable

1 Answer

1992 crown victoria wipers will not work .Clickin at a device under dash above gas pedal when switch is activated.All fuses test out .

can you grab the wipers and make them move with your hand? If so the linkage has come apart. The clicking noise would be something hitting.

Feb 06, 2010 | 1992 Ford Crown Victoria

2 Answers

Windshield washer will not operate , resevoir is full of solution 1992 mercury sable

The windshield wiper has a motor located in the hood.

This motor normally gets damaged within time and it might be repaired or replaced but wouldn't cost so much.

Take care.

Dec 14, 2009 | 1992 Mercury Sable

2 Answers

Need to know the fuse box diagram, what fuse pertains to the wipers... the wipers quit today and I do not have the manual. I opened the hood and see the fuses etc, but have no idea which one is for the...

fuse panel in car on driver side by left knee under dash

Visual Inspection Chart
Mechanical Electrical
  • Wiper linkage
  • Washer nozzles
  • Washer pump hoses
  • Central junction box (CJB) Fuse 211 (15A), Fuse 215 (30A)
  • Multifunction switch
  • Rear window wiper switch
  • Wiper run/park relay
  • Wiper high/low relay
  • Windshield wiper motor
  • Windshield washer pump
  • Rear window washer pump
  • Circuitry
  • Battery junction box (BJB)
  • CJB
  • Generic electronic module (GEM)

Dec 11, 2009 | 2003 Mercury Sable

1 Answer

I am having trouble with my '91 Miata wipers. They do not work at all on low or medium, and high makes them go, but jerkily. I am I looking at a switch, motor, what? Please help!! Jake Same...

The problem is the wiper motor. I have had this problem before. The motor is located on the passenger side on the firewall. It is a easy fix hard part will be finding the right wiper motor. You need to see which direction the motor itself points (the black canister).

Jan 04, 2009 | 1992 Mazda MX-5

Not finding what you are looking for?
1992 Mercury Sable Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

75117 Answers


Level 3 Expert

5474 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides