Question about 2002 Jaguar X-Type

2 Answers

The fuel heater light on my xtype started flashing and the ABS lights. After a few more short journeys the ignition engine warning light is now on and staying on . I've also noticed a loss of power and poor acceleration. 2006 Xtype 2.2l diesel with only 35kmiles

Posted by on

  • Anonymous Mar 22, 2014

    when accelerating get to 2500rpm heater plug light starts to flash and no power

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

I had a very similar problem (did not have the abs light) but had the other lights. Changed fuel filter as the problem seemed to be a fuel pressure problem. Turbo was back and no flashing heater light, engine light will go out after about three cold to hot starts as long as no other problem exists. It's worth a try as it is a cheap and relatively easy repaire to do. If not the answer take to a garage who can interrogate the computer.

Posted on Jan 02, 2013

  • Keith Cockrill Jan 02, 2013

    I had a very similar problem (did not have the abs light) but had the other lights.
    Changed fuel filter as the problem seemed to be a fuel pressure problem.
    Turbo was back and no flashing heater light, engine light will go out after about three cold to hot starts as long as no other problem exists. It's worth a try as it is a cheap and relatively easy repaire to do. If not the answer take to a garage who can interrogate the computer.

  • Keith Cockrill Jan 17, 2013

    Very helpfull

×

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 25 Answers

Take it to a jaguar dealer for the check engine light. They are the only place to get the codes really read then go from there

Posted on Oct 06, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car goes into limp mode when starting if previous journey had been short, however, starts fine if previous journey was long enough for engine to reach normal temp. No warning lights come on and no


Go to a local auto parts store or your mechanic and have them read the code. This can usually lead you in the right direction and assist you in diagnosing your problem.

Feb 08, 2015 | Cars & Trucks

1 Answer

Abs light stays on and is flashing a i think acode


hi Robert

you can check the ABS fault code as following:

switch ignition on and wait for the abs light to start to flash.
it will flash in long and short flashes, long flash stands for ten, short flash stands for one, there is a short pause in between, and long pause after each code, take a note of the code and Google it
good luck
9ba390f1-ca01-44ac-85b4-4603e1244a3a.jpg

CODE 12 CODE 21

Jan 17, 2014 | 1993 Ford Ranger SuperCab

1 Answer

Check engine light came on then flashed on motorway journey


the flashing light it is a warning that something is not right and could cost you if you dont pay attention to it.take it to kia for a diagnostic test.to determine the problem it could be one of many problem.these cars are full of sensor units which pick up faults and transfers this to the computer which in turn alerts you there is a problem by flashing the warning light.

May 28, 2013 | 2005 Kia Carens 2.0

1 Answer

Ford 2003 escape codes readed


Cauases or fault codes are not cut and dry, but here are the possible causes of codes P0316 and P0306 which are related codes.
P0316 - Engine Misfire Detected on Startup
Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
- Engine fails to start
- Engine runs rough Possible causes - Crankshaft Position (CKP) sensor harness is open or shorted
- Crankshaft Position (CKP) sensor circuit poor electrical connection
- Faulty Crankshaft Position (CKP)
- Ignition System
- Fuel Injectors
- Running out of fuel
- Fuel Quality
- Faulty Engine Control Module (ECM) P0306 - Cylinder 6 Misfire Detected Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
- Lack/loss of power
- Hard start
- Engine hesitation
Possible causes - Faulty spark plug 6
- Faulty ignition coil 6
- Ignition coil 6 harness is open or shorted
- Ignition coil 6 poor electrical connection
- Clogged or faulty fuel injector 6
- Injector 6 harness is open or shorted
- Injector 6 poor electrical connection
- Improper spark plug 6
- Insufficient cylinder 6 compression
- Incorrect fuel pressure
- Intake air leak

Jan 17, 2012 | Cars & Trucks

1 Answer

ABS light comes on... but no noticble degradation in operation etc.


Most likely a wheel speed sensor, hopefully... The only thing that will change when the ABS light is on is that the ABS will not function as long as the indicator is on. I hope this info helps.

When the airbag system is in functioning condition, the airbag warning light will remain on for about 7 seconds and go out when the ignition switch is set to ON .

If there is any malfunction, the airbag warning light will either stay on or off continuously. In such cases, perform on-board diagnostic in accordance with the specified procedure to determine trouble codes.


  1. Turn ignition switch ON (with engine OFF ).
85091723



  1. Connect DIAG. terminal to No.2 terminal of diagnosis connector located inside lower cover.
  2. Check in accordance with the trouble code indicated by the AIRBAG warning light, and record the trouble codes.
  3. Turn the ignition switch "OFF " and remove the DIAG. terminal from No.2 terminal of diagnosis connector.
85091724


HOW TO READ TROUBLE CODES
The ABS lamp flashes a code corresponding to the faulty parts.

The long segment (1.2 secs on) indicates a "ten", and the short segment (0.3 secs on) indicates a "one".





NOTE: This is the only information provided by the manufacturer for clearing diagnostic trouble codes.

97511505


CLEAR MEMORY
After eliminating problem as per trouble code, clear memory as follows:

Make sure ignition switch is ON (and engine off). Connect one DIAG. terminal (1) on diagnosis connector (2) terminal No.1.

where warning light is flashing, connect the other DIAG. terminal (3) on terminal No. 2 for at least three seconds . After memory is cleared, normal warning light flashing rate resumes. (Warning light flashes every 0.6 seconds (ON-OFF operation.) Memory cannot be cleared if any problem exists.

After clear memory and then DIAG. terminals (1) and (3), extract from diagnosis connector (2)

Jul 27, 2011 | 1999 Subaru Legacy

1 Answer

Jag xtype 2.0D 2004 Glow plug light flashing.Engine malfunction light on .No loss of power.Hhappened just after refuelling


jaguar x-type 2ltr diesel 2004 the glow plug warning light flashing, was told dirty fuel on fault code all fuel changed and filters. No problems for 20 miles untill engine was put under power on high revs went into limp mode, warning light glow plug falshing again? any ideas thanks.

Feb 09, 2011 | 2004 Jaguar X-Type

1 Answer

Amber warning lights on.


I have a 2001 xtype and the same lights came on my dash, i had it plugged up to diagnostic and it was down to a split reluctor ring on the rear wheel, this set off the abs light which in turn sets off the management light. Will cost £200, but looks quite easy to repair by self

Aug 14, 2009 | 2002 Jaguar X-Type

1 Answer

Cruise Control not active, engine light and ABS light


I have the same problem with the Cruise Control not available coming up but I had a smiliar problem with the ABS and Engine light coming on when battery was pretty much dead, it was hard to steer and brake.. may be something different with your car..

May 23, 2009 | 2003 Jaguar X-Type

2 Answers

When i start my car it just cuts off again this happens a few times then works fine, also after a few miles of driving the abs warning light comes on my car is an N reg audi A4 automatic 1.8


Hi, I had the same problem. it is the imoboliser, it reads a code in your key while starting. you need to get the code in the key reprogramed. if that wont work you will need to get a new ignition barrel. Audi dealer will reprogram your key.

May 18, 2009 | 1996 Audi A4

Not finding what you are looking for?
2002 Jaguar X-Type Logo

373 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

yadayada
yadayada

Level 3 Expert

75807 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...