Question about 1991 Toyota Camry

1 Answer

Car starts up and drives well. After the car has warmed up and then been parked (shut off). It stalls while idling. Cat will eventually restart and drive. Check engine light is not on except when the car is stalled (all lights)

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

You probably have a vacuum leak. If you do have a leak, its small. It maybe a hose that has cracked or a seal that has failed.

Posted on Oct 06, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Rough idle after engine is warm


Dirty air filter, dirty throttle body...try 2 bottles of gas line fuel injector cleaner...has your car been parked for awhile? Heet gas additive will work on any low gas tank sludge that you may have. Hope this helps.

Mar 24, 2014 | 1999 Mazda 626

1 Answer

1996 mercedes c280 dies when put in drive


Engine stalls or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Oct 15, 2012 | 1996 Mercedes-Benz C-Class

1 Answer

Changed cat conv, changed o2 sensors, code PO420 keeps showing up so does check enginelight????? new problem now, when exitiing the freeway car shuts completly off??? its done this a few times now. i have...


Some cars can not have a generic converter put on them. Replacing this and the 02 sensors should have fix the code problem. Depending on your car I would check the converter. And if you had it done at a shop take it back. If your car has to have a specific converter and it got a generic one, this would eventually cause the car to stall.

May 20, 2011 | Lincoln LS Cars & Trucks

1 Answer

1991 5.7 TPI trans am wont start back up after warming up


This is my own take on your problem, i don't think thats enought pressure from fuel pump, thats pressure you get from throttle body injection. I believe fuel injection should be around 60 psi. Just a few pounds below that it won't run right.

Feb 09, 2009 | 1991 Pontiac Firebird

1 Answer

1995 Taurus Engine Stalls


Here is the most common cause of surges and stalls and low idle, it is the idle speed control air-bypass valve and throttle valve, they get full of gunk over the miles and cause idle issues (stalls) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Dec 08, 2008 | 1995 Ford Taurus

2 Answers

Stalling excessivly and rough idle


check the pcv lines for a vacum leak

Dec 04, 2008 | 2001 Lincoln Town Car

1 Answer

Fine idle on startup can stall when warm


change your oxygen sensor thet is whyoillight lights on

Oct 23, 2008 | 1992 Lexus Sc 400

Not finding what you are looking for?
1991 Toyota Camry Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...