Question about Hyundai Motor 2004 Sonata

1 Answer


Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,665 Answers

Procedure as follows:
1. Drain the coolant so its level is below the thermostat. 2. Remove the inlet fitting and gasket. 3. Remove the thermostat INSTALLATION 1. Check that the flange of the thermostat is correctly seated in the socket of the thermostat housing. 2. Install the inlet fitting. THERMOSTAT - a3b1369.gif Tightening torque Engine coolant inlet fitting bolt : 10 ~ 15Nm (100 ~, 7 ~ 11lb.ft) 3. Refill the coolant. INSPECTION 1. Heat the thermostat as shown in the illustration. 2. Check that the valve operates properly. 3. Verify the temperature at which the valve begins to open. Valve opening temperature : 80-84°C(176-183.2°F) Full opening temperature : 95°C(203°F)

Posted on May 29, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What may cause my 2004 hyundai xg350l to over heat?

1. Stuck thermostat
2. Low on coolant
3. bad water pump..

(#1 is best bet). .. FLUSH entire system when replacing the thermostat... check the hoses for wear..(they wear out from the inside.. look for bubbling, cracking, being soft inside.....replace if any questions...(not fun being stuck because of a $10 hose..!!!)
Hyundai XG350 Thermostat
Upper Lower Radiator Hoses Thermostat Replacement Hyundai Tiburon 2001 2008

Jul 14, 2017 | Hyundai Cars & Trucks

1 Answer

Were is the PCV Valve on a 1997 Hyundai sonnata 3L v6

To of the motor right side on side of the pluntum.

Mar 15, 2013 | Hyundai Cars & Trucks

2 Answers

I have hyundai sonnata 2006 4 cylinder. it has just completed 100000km.should i changet transmission oil now.

The transmission oil starts breaking down at 30000miles. Most car dealers change the transmission oil and filter at the second scheduled maintenance service at 60000miles. Changing the transmiosion oil is an insurance for the transmission. Make sure to use the specific transmission oil for your car.

Nov 05, 2010 | 2006 Hyundai Sonata

1 Answer

I have a 1999 tiburon and want to put a bigger engine in it. what engines will fit?

None.. You Could make a Turbo System.. it might be difficult to fit a 3.5L from a Sonnata in those car !

Aug 11, 2010 | Hyundai Motor 1999 Tiburon

2 Answers

How to replace thermostat

The thermostat is located behind the thermostat housing on which the ECT is installed.It is attached to the lower radiator hose. Remove the lower radiator hose and the housing attached to it you would get the thermostat.To replace the thermostat, you must remove the air cleaner box, remove the thermostat housing cover, replace the thermostat with a new gasket, clean off any old gasket material, reinstall the housing cover and air box, and then fill and bleed the cooling system.
Thank you !!

Jul 07, 2010 | 2004 Hyundai Elantra

1 Answer

Where is the thermostat located on the 2004

Follow the hoses from the top of the rad. out to the engine block, where the hose hooks to the engine is where the t-stat is located. look for sensors and a seam for a gasket.

Nov 07, 2009 | 2004 Hyundai Elantra

1 Answer

I need too now the timing for hyundai sonnata 2001

Call Hyundai or go to & register the vehicle (by VIN). Then you'll have access to the information you need.

May 02, 2009 | 2001 Hyundai Sonata

2 Answers

Engine light on, engine knocking 2004 6cyl Sonnata

I believe I check the oil before I moved the car.

Dec 01, 2008 | 2006 Hyundai Sonata

1 Answer

I have a 2004 Sonnata 6cyl. This morning I went to start it up and the engine made a loud knocking noise and the engine light came on. Could this be from low oil?

ok did the knocking noise speed up as you pressed the pedal? if so id check the oil first and see if that helps at all and if it continues to make the knockin sound you might have a thrown rod/piston. The oil can effect the the pistons being as it is the lubricant for the pistons to move up and down in the bores(cylinders) but the low oil would only cause the engine to start knocking if there hasnt been any oil added as needed for a long while. has you engine got hot or warmer than usual? the could also be a symptom of low oil.

Dec 01, 2008 | 2006 Hyundai Sonata

1 Answer

Cant find oxygen sensor

it should be located in the front of the motor by manofold or by the catilitic converter

Nov 15, 2008 | Hyundai Motor 2002 Sonata

Not finding what you are looking for?
Hyundai Motor 2004 Sonata Logo

632 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides