Question about 2004 Chrysler Voyager

Open Question

2004 Grand Voyager 2.5 td Have lost 5th gear completely, and there is a whiny noise when I disengage the clutch. Have been told that there is no problem with the clutch but the fault is with the gearbox. Please help

Posted by on


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 67 Answers

SOURCE: how to replace a rear wheel bearing on voyager

this is a one piece part hub and bearing assy. even if auto parts sales you bearing separated highly recommend to replace whole unit

Posted on Nov 19, 2009

  • 913 Answers

SOURCE: chrysler grand voyager 2004 gone in to limp mode,

get diagnostic codes to get a starting point for repairs required

Posted on Apr 26, 2010

  • 827 Answers

SOURCE: I have a 2000 grand

From the information you have provided, I am assuming the "header tank" is in fact the one which is connected to the radiator and should not have oil, but only coolant in the tank - in other words you have oil in the engine coolant tank... If this is true, then you most likely have a blown head gasket and or warped head or otherwise a crack in the head or the block of the engine whereas the oil is seeping from the oil lubricated areas of the engine inner areas and into one of the "streams" where the coolant circulates...

Seeing that the vehicle is 10+ years old, you may need to look at the value of it to determine if it would be worth investing into the repair as the problem will not get better, only worse with further operation until it is repaired... You may be able to get a used engine and have it replaced, or have the existing one repaired, either way it is not that uncommon for an engine to run this way in this state, however unfortunately, it will not be much longer before it totally craps out....
Best regards

Posted on Jan 15, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Car will not engauge into 1st or 2nd gear

the gear grinding noise is because the clutch plate is not fully disengaging and the input shaft is still driving. If you did not use the same length of push rod then the slave cylinder is not moving enough to disengage the clutch. Check it out that with the pedal on the floor the piston in the slave cylinder should be almost to the edge of the slave cylinder . That is where It should be to be working properly

Jan 13, 2014 | 2004 Pontiac Grand Am

1 Answer

Lost speed.5th gear stoped working

old car. 5th gear? is this M/T? 1987 ?
A/T? is 4speed

what does stopped working mean .
1: shifter fails to select 5 gear H pattern slot.
2: grinds?
3: cant force it to 5th with clutch depressed.? is free play at spec?
4: raise front wheels off ground, can you get in to 5th now? keyout and running?
5: can you get into 5th parked engine off, and select 5th and then start car in 5th with clutch depresses first step. then slowly very slowly attempt to move car starting in 5th, but dont finish, just feel the gear, feel that its there and not neutral.

not working ,says nothing at all.

Sep 13, 2013 | 1987 Honda Prelude

2 Answers

Just bought a 2004 Elantra (93000 miles) with 5 speed tranny. With the hood up and my daughter behind the wheel I noticed a rattling sound (in neutral) coming from the clutch/transmission area when the...

I would be checking the throwout bearing. But, if the clutch isn't slipping, maybe leave it for now?

If you put it in 5th gear, let out the clutch with handbrake applied and it stalls--the clutch isn't slipping for sure.

Jan 31, 2011 | 2004 Hyundai Elantra

1 Answer

My 95 Camry cant go into 5th gear. I was told that it was the clutch because it was making a grinding noise. I got the clutch fixed but even after that its not taking 5th gear and its still making the...

If the clutch is bad it would make the same noise in every gear, because the clutch does always the same engage and disengage the trans and its different gears. So if there is a noise in a specific gear the problem is the trans-axle ( if the noise is coming from the trans axle.)

Jan 03, 2011 | 1995 Toyota Camry

1 Answer

Plymouth 1998 Grand Voyager /I have a whining noise

Check your power steering fluid. If low it whines and is related to engine speed.

Good luck, TD

Apr 05, 2010 | 1998 Plymouth Grand Voyager

1 Answer

Im having a problem going into reverse and 2 and 4th gear but 1st 3rd and 5th gear is fine i have a 2005 saturn vue with 80,000 miles on it i really have to use both hands to feed the stick into thoose...

Sounds as if you may be having a problem with the clutch. It could be that the clutch plate is worn out and no longer disengages from the flywheel completely.

Jan 20, 2010 | 2003 Saturn VUE

1 Answer

I have a ford escort r reg td,the trouble is the gears is hard to go in to second.i have been told it might be the release bearing.what do u think? CLUTCH CABLE BEARING SELECTOR?

Pretty hard to tell you it's a release bearing without hearing it but unless release bearing is in very bad shape & making lots of noise, it's very unlikely that is the culprit here. Does the clutch disengage properly, as in car doesn't creep when pedal depressed? Check master cylinder & slave cylinder movement, perhaps bleeding slave will help, but if it's only in second gear that the problem is occurring then I'd give linkages a real good coat of lubricant & see if that helps at all.

Sep 09, 2009 | 1998 Ford Escort

1 Answer

1997 Grand Voyager transmission slipping

low on fluid!!!!
thats why its HUNTING !! & the whine is the pump !
Check it for burnt smell & disclouration!
as that could indicate burnt clutches & or bands!
Cheers Rob.

Jul 28, 2009 | 1997 Plymouth Grand Voyager

Not finding what you are looking for?
2004 Chrysler Voyager Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides