Question about 2003 Chevrolet Tahoe

2 Answers

When i make a u turn it makes a clik - 2003 Chevrolet Tahoe

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chevrolet Master
  • 8,841 Answers

Usually caused by worn CV joints. Check axle boots for tears. When a boot tears, dirt gets in and causes the CV joint to wear out. You can also test by pulling the axle to see if there is play in the joint. If there is play or a torn boot, replace the joint or the entire axle. OK?

Posted on Oct 06, 2010

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 60 Answers

If it is clicking in speed with relation to how fast the tire is rotating, then it sounds like a bad front half shaft if this is a 4x4 model. If it is 2x4, the the click could be a number of thins. This could be the power steering hitting the full turn lock which is not a problem. It could be rear axle if it clicks faster the faster you go. I could be a lose tie rod, ball joint, control arm. I hope this helps!! Thanks!!

Posted on Oct 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Have a2006 pt light come on and the starter cliks some time it turns over slow what wrong with it

Battery may be weak or terminals not making good contact. Most auto parts stores can check this for you.

Feb 21, 2015 | Cars & Trucks

1 Answer

Why my 92 toyota celica wont start jus go clik clik is hot. The mechanich clooless

loosen the starter and try again. if its in a bind it will do this click click action. but if the starter motor is bad and the solenoid is good it will also make the clicking sound.

Jul 18, 2014 | 1992 Toyota Celica

1 Answer


Is the compressor turning on an off quickly ?
Could be a low pressure switch or problem with the ac clutch.

Jul 31, 2012 | 1999 Pontiac Grand Prix

1 Answer

My 95 buick lasabre just clik and don't crank we replace battery and started

If it just clicks make sure the engine isn't locked up by turning it by hand. If it turns freely it is possible that you have a defective starter motor provided all your connections to the starter and battery are clean and making good contact.

Jun 16, 2012 | 2002 Buick LeSabre

1 Answer

Flasher cliker always making noise even if flasher

My '02 Alero did the same thing every since I got the car 5 years ago. After 6 visits to the dealership and them telling me it was the hazard light switch which had gotten recalled, I just gave up. 2 years ago, I started dating a mechanic and he figured out what the problem was. The contact in the steering panel that controls the blinker was dirty. He took my car to work and fixed it. It's definitely something you could do at home if you have a little know how, me being a woman, cars aren't my thing so he did it. He used this link below as a step by step on how to do it. Although its for a Grand Am, its essentially the same car. Hope it helps!

Feb 27, 2010 | 2002 Oldsmobile Alero

1 Answer

I Need 1993 Dodge 3.3 Engine Fault Codes


Apr 30, 2009 | Dodge Grand Caravan Cars & Trucks

1 Answer

Clik,clik on the rigth side when making turn need to know what to avoid, and possible short cut to replace c/v joints [axle] on both side of 1995 saturn sl2 [automatic].thank you much.

There really is no short need to replace the half-axle on the right side (will get both inner and outer CV joints). Is driveable with noise, but may eventually fall apart.

Jan 22, 2009 | 1993 Saturn SL2

1 Answer


first check the battery, should have at least 10.43 volts under a load for about 10 to 15 seconds, are the cable ends clean and tight and corrosion free, is the ground cable connected to a good ground and is it frayed or partially cut anywhere. also how old is the battery, 4 or 5 years old, it may be time to change it. If all of the above is good, then its a good possibilty you need a new starter. two factors here, the age of the vehicle and the milage, if it is high. most japanese models, especially hondas will make a click at the starter and solenoid if the starter is defective, but only one click each time the key is turned. good luck and let me know if you have any other problems. thanks

Sep 17, 2008 | 1995 Honda Passport

Not finding what you are looking for?
2003 Chevrolet Tahoe Logo

191 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides