Where is the map sensor located where i can find a diagram

Before making any change get the help from service and repair manual with diagram it will provide you step by step help to locate and fix the problem easily and you will get the manual from the given link https://toolsnyou.com

check this wiring digram

http://www.bigcee.com/faq/KLR650-color-wiring-diagram.jpg


You can also buy a wiring diagram from the following site..

http://www.ahdol.com/ford_wiring_diagrams.html

Hi Alvin,here's a link to a picture of your engine and your sensors,just click on the sensor and it will show you what it look's like. 3800 V6 Engine Sensor Locations Pictures and Diagrams

Many public libraries have manuals or subscribe to on line services such as Alldata.

Remove the throttle body.

Disconnect the MAP sensor electrical connector.

Remove the MAP sensor (1) from the intake manifold (2).

1996 Chevrolet Truck G10 1/2 ton Van 5.0L SFI 8cyl

The MAP Sensor is located: Front seating area, center, under engine cover, rear passenger side of intake manifold, above valve cover, mounted on bracket.Here's a link to what it look's like Brad. MAP Sensor at AutoZone com Best MAP Sensor Parts for Cars Trucks SUVS

http://www.gmpartseast.com/diagrams/large/56C/2-3-intake-manifold-tx0302801.png
Number #5 in the diagram is the Map Sensor

For exact location and replacing procedure of VW jetta MAP sensor,click the link below and follow the details with diagrams:-----Where is MAP Sensor Located on VW Jetta http://technoanswers.blogspot.com/2012/11/where-is-map-sensor-located-on-vw-jetta.html
---------These will help.Thanks.

Here is a diagram of where the map sensor is located on this particular vehicle, i have also included the removal and installation procedures as well

Hope this helps....

REMOVAL PROCEDURE

1. Remove the air cleaner outlet resonator.
2. Disconnect the manifold absolute pressure (MAP) sensor.
3. Remove the MAP sensor attaching screws (1).
4. Remove the MAP sensor vacuum hose (2).

INSTALLATION PROCEDURE

1. Connect the vacuum hose (2).

NOTE: Refer to Fastener Notice in Service Precautions.

1. Install the MAP sensor attaching screw (1).

Tighten
Tighten the screw to 6.5 N.m (5.7 lb in) .

1. Connect the MAP sensor connector.
2. Reinstall the air cleaner outlet resonator.

Hi...

On a 2.2 L. the map sensor is located Near the throttle body assemble. on intake manifold.

On a 3.0 L. Is located near the ECM on top of the intake manifold..

OK.. I hope you found if Not. Let me know .
I will looking for diagram to send.


Thank you for use fixya.