Question about 1994 Chevrolet S-10

2 Answers

Timing help 1994 chevy s-10 p/u with 2.2l - timing chain broke, had to replace the head, tries to start, but spits back thru throttle body. need some help on how to time up engine. have put the timing marks on the tab. am wondering if my rocker arms are not right?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Sounds like your crake and cam were not lined up properly, when you installed the timing chain/belt. I had this happen to a Mazda and had to take it all back apart. I was only off a tooth or two. When i put it back togeather it cranked up and ran fine.

Posted on Jul 07, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

For 9.99 i will tell you

Posted on May 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

WHERE IS THE FUEL PRESSURE REGULATOR ON 1994 CHEVY PICKUP


SKM, fuel pressure regulator is on top of throttle body. This could be the problem, could also be vacuum leak, faulty EGR, etc. You may want a good Tech, to diagnose and estimate repair. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
TBI 220 Fuel pressure regulator change 1
92 chevy truck missing at constant speeds The 1947 Present Chevrolet GMC...
Where is the fuel pressure regulator on 1994 Chevy truck 5 7 TBI fuel...
started stalling and dying when in gear

Jul 28, 2016 | Cars & Trucks

1 Answer

1994 Chevy Suburban K1500 5.7L v8 157 thousand miles.. replacing timing chain on the vehicle and after replacement truck ran steady at 1k RPMs. During idle in park the following day the truck died, re


First you need to retrace your steps...before you changed the timing chain and gears did It run ok ? what was initial problem, next put a fuel pressure gauge on your fuel line and cycle your key on to run pos, dont have to try start, just run and see if you have fuel press during the 3 sec or so pump cycles, should be around i think 35-45 roughly for tbi. so if you have good fuel pressure , then you say you have good spark, then your problem is either ingition or valve timing, did your dist.come loose, did you properly install chain & gears and align timing marks. did you have somethine else a part on it too like intake, dist, ? get back with me I'll try to help you.

Apr 09, 2012 | 1994 Chevrolet Suburban

2 Answers

I currently own a 1986 Ford Ranger 2.9 V6, RW Drive. Was driving like a charm!! I was driving it yesterday morning, no problems, I parked it after 10 minutes of driving... Last night I went to start it, it...


The cranking will usually sound different after the timing chain has slipped. Does it spit or backfire when you crank it? I suggest you rule out some easier things before going after the timing chain. If you are getting spark and fuel, then maybe I would take a peek at the timing chain to see if it has skipped on the sprocket.

Please see my tip at http://www.fixya.com/cars/r5821173-doesnt_car_start_gasoline_engines . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

Nov 25, 2010 | Ford Ranger Cars & Trucks

1 Answer

Have replaced fuel pump, relay & fuel filter.


have you checked to see if you have a bad came or lifter. that would make it backfire. if it kind of spits fuel it maybe cam. if it throws fire than it could be timing like a bad chain.

Feb 12, 2010 | 1986 Chevrolet S-10 Blazer

2 Answers

1994 chevy fuel problem


The last pieces in the chain are the fuel regulator and the injectors. The regulator is inside the throttle body, but it sounds that maybe the injectors are not firing. For nothing else, check out the connections to the injectors. Possibly they are clogged. Try a few treatments of injector cleaner.

Jul 29, 2009 | 1994 Chevrolet K1500

2 Answers

1992 Firebird wont crank


I believe i would check my module or rotor it may not be getting enough fire.to the moter.

Jul 21, 2009 | 1992 Chevrolet Camaro

1 Answer

94 chevy 5.7 2 wheel drive


computer wiring could be bad /computer bad..should be spitting codes....tired motor / internal damage ? timing chain/gear set up improper?

Nov 09, 2008 | 1988 Chevrolet K1500

1 Answer

Timing


please specify if your s-10 is pick up? or blaser, or 2 or 4 wheel drive, also engine size or at least how many cilinders the engine has, thank you

May 28, 2008 | 1994 Chevrolet S-10

Not finding what you are looking for?
1994 Chevrolet S-10 Logo

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...