Question about 1991 Dodge Dynasty

1 Answer

Just put a new fuel tank and fuel pump in the car, the new fuel pump is not working now, is there a safety switch or something? If so where is it?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 8,273 Answers

There is a fuel pump fuse and relay in the engine compartment relay box. Check that first.
You can check the relay socket using my tip at http://www.fixya.com/cars/r6022358-relay_check . These are generic instructions.

Was there an accident? If yes, I will see if I can find an inertia switch in your car diagrams.

Posted on Oct 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Tecumseh OHV130 206810C. It sat idle for 2 years and was gummed up. Cleaned everything up but can only get it to run by spraying gas into the air intake. Could there be a fuel pump problem an


You follow the hose from the bottom of you fuel tank right to the fuel pump. If you don\'t have a pump, that same hose will go to your carburetor. Either way disconnect the hose from the carburetor. Put a can under hose and turn over engine. If gas flows your pump is OK. Next remove bowl off bottom of carburetor, ( with can under bowl), I believe you will find crap & water in the fuel bowl. I would drain all fuel from tank, hoses, and pump. Clean fuel bowl , you may need new bowl gasket, put in fresh fuel, try to start. Water in the fuel is a very common problem when you hear NO START. Caution when dealing with fuel, remember SAFETY, SAFETY, SAFETY, and did I forget to mention SAFETY. GOOD LUCK FRIEND.

Sep 27, 2014 | Cars & Trucks

1 Answer

Electrical problem for the fuel no power


A lot of newer vehicles have a fuel pump cutout switch on the engine. If the engine shuts down for any abnormal reason, it loses oil pressure and one of the things that happens is the fuel pump is cutoff. This is a safety item in case of an accident which shuts off the engine. Check for the oil pressure cutout switch on the engine, which is usually different from the oil pressure gauge or light switch. Can't say exactly where it is, sometimes on the upper rear part of the engine behind intake manifold or on lower side of engine right into the block. The fuel pump run circuit is different from the fuel gauge circuit although they usually run in the same wiring harness if the fuel pump is in the tank. If the pump is not in the tank then the fuel level sender in the tank is probably defective and should be replaced.

May 12, 2013 | 2001 GMC Savana

1 Answer

After running for about 10 minutes the car stops and turns off. turns back on but when you put it on drive it turns off again after about 10 minutes it runs again.


This problem can cause by combine of few parts.
Loose linkage and / or bad / failing neutral safety switch.
Check for free play on shift and linkage to the transmission. Check for worn / loose mounting bolts around the neutral safety switch.
========
A weak fuel pump can also cause stalling.
Fill the tank above 3/4 tank and see does it problem still occur.
A weak fuel pump will not effectively delivery fuel when the fuel level is below 1/3 tank.

Aug 10, 2011 | 1994 Pontiac Sunbird

1 Answer

How to replace fuel module regulator


to replace the fuel pump module.first you need to relieve the fuel system pressure.turn off radio first, then disconnect the negative battery cable.drain fuel from fuel tank.then then safely raise support car on jack stands. make sure sitting on solid level ground then remove the fuel charcoal canister hoses and vent line remove disconnect fuel pump. disconnect fuel pump electrical connector and remove fuel filler hose from fuel tank then remove the fuel tank from the vechicle.the heat shield and the rear exhaust system may have to be remove if you problem dropping the fuel tank.once fuel tank dropped you need snap ring pliers to remove the fuel pump module retaining ring.disconnect the fuel pump sending unit.disconnect the fuel pressure sensor and fuel pump module electrical connector .if you need help to replace the fuel level sending unit.you need a haynes repair manual.it has instruction how to remove and replace the fuel level sending unit.but most of the time the whole new fuel pump module come with new fuel level sending unit.if you are replacing fuel pump.when done put every thing back visa versa. be very careful working around gasoline and fuel tank.dont smoke.becareful dont make no sparks with wrenches when removing gas tank.wear safety glasses and have a helper at all times. dont work under vechicle by your self.

Apr 11, 2011 | 1999 Oldsmobile Alero

2 Answers

Something is going wrong with my feul system. I put it on the front tank and it works a little then it acts like I am getting no feul. I switch to the back tank and it works better. The back tank is...


It could be the valve,that switches the tanks,or the fuel pump in that tank you are having the problem with,it is most likely the fuel pump in that tank that is the problem.If this was helpful,please rate,thank you.

Jun 10, 2010 | Cars & Trucks

2 Answers

I put a new fuel pump on a 94 Mazda and now it won't work in the car but runs fine when I take it off and try it. Is there a relay or something like fuel cutoff? If so where is it


There are fuses for the fuel pump and should be located under the hood.You should not run the pump out of the fuel tank the fuel keeps the pump cool and it only takes about 15 seconds to destroy a new pump when running it out of the tank.Chances are you might have ruined the pump by running it out of the tank.

Feb 17, 2010 | 1994 Mazda 323

2 Answers

How to replace fuel pump on 96 Subaru legacy


the fuel pump is located in the fuel tank, that tank must be pulled to do this. the procedure for removing the tank and pump are very little changed from car to car, here are a good set of general instructions with photos.

http://www.aa1car.com/library/fuel_pump_replace.htm

Nov 12, 2009 | 1992 Oldsmobile Cutlass

1 Answer

I cannot get the car started.


most likely the fuel pump will need to be replaced. only way to replace is to drop the fuel tank and remove the pump from the top. the 92 camaro did not come with the emergency fuel cutoff switch. best way to find out is to turn the ignition on and listen at the fuel fille spout you should be able to hear it pretty good from there if it is working. to drop the tank ... you will need a jack, 2 jack stands and a standard socket set ... just jack up the car and support it by the stands. make sure you put something in front of the front wheels. remove the 2 fuel tank straps and lower the tank ... installing the tank will be easier if it is empty ... just drain the gas into a clean garbage can or small pail depending on how much fuel you have in it. just make sure you strain he fuel before putting it back in or you can look to possibly replacing the fuel filter.

Apr 19, 2009 | 1992 Chevrolet Camaro

1 Answer

Putting in a new fuel pump in a 1991 RS camaro V8 5.0L


hi yes you have to remove the gas tank to get to the pump.once tank is out remove ring holding the sending unit.then remove unit replace pump then reinstall in tank then put tank back in. and try to start.

Feb 05, 2009 | 1991 Chevrolet Camaro

Not finding what you are looking for?
1991 Dodge Dynasty Logo

196 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...