Question about 1995 Nissan Maxima

1 Answer

I put 2 front brakes shoes on my 1995 Nissan Maxima,what is the correct way to bleed my brakes?Is their any order that i need to follow?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Did you open the bleeder screws at all. If not you may not need to bleed the brakes just pump the pedal to bring the caliper pistons out and your pedal should feel fine. If you just want to blled anyways open all your bleeder srews and as the fluid level in your brake master cylider goes down refill with new dot 3 brake fluid (do not alow the master cylider to drain completely). Close bleeders when you get clean fluid through. Start at passenger rear corner and have a buddy press the brake pedal down. open bleeder, close bleeder after squirt of fluid then have buddy release pedal. Do this a couple of time per corner. Go from pass rear to drivers rear then pass. front ending with driver front. You just flushed your brake fluid. Hope this helps.

Posted on Oct 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 Maxima/ rear right brake not working/ new caliper,rotor,pads,and rubber line getting fluid when bleeding


I guess my first question would be are you getting a strong fluid flow at the bleeder screw ? Keep in mind I am not there in person - you should have an equalizer valve, probably in the master cylinder that could be restricting flow. Is there a chance something is going on with the ABS system ?

Sep 28, 2012 | 1995 Nissan Maxima

1 Answer

I am replacing the front rotors and pads on a 95 pathfinder. do I need to bleed the brake lines completely for all 4 rotors? Is there some order I need to do this?


Why wouldn't you bleed all 4?

You need to do that every 2 years on all vehicles

Aways start at the farthest
RR,LR,RF,LF

Feb 17, 2011 | 1995 Nissan Pathfinder

1 Answer

I have a maxima 1993 I change brake pump and booster and front pads and rear choose.. And the brake pedal keeps going down a little by little. It's like if was loosing some presure.. Some where.. Not so...


if you are losing peddle and their are no leaks in the system, meaning you have to keep adding fluid then you have an internal leak in the master cylinder . if it was just air in the lines, not bleed right you would have a spongey peddle meaning it would stop but the peddle would feel like rubber, or it would pull to one side

Oct 01, 2010 | 1993 Nissan Maxima

3 Answers

Brake to the floor in order to stop. they are new


make sure the rear shoes are manually adjusted up properly ,then is still no good renew the master cylinder because the seal between the front and rear chambers could have gone ,but i do feel that you should manually adjust the rear brakes up properly,slacken handbrake cable before you do this though

Dec 10, 2009 | 1995 Toyota Camry

1 Answer

Order to put wires on nissan maxima


For the 1993 Nissan Maxixa 3.0L:

Firing Order:
1-2-3-4-5-6

Cylinders:
......(back)
1.......3........5
2.......4........6
......(front)

Distributor Connections:
...(back)
............1
......6
5.................2
............3
......4
..(front)

Oct 20, 2009 | 1993 Nissan Maxima

1 Answer

Back right brake caliper leaking brake fluid


Sounds like the brake line is just rusted, you'll probably have to change the brake line and then bleed the brakes

Oct 15, 2009 | 1995 Nissan Maxima

1 Answer

What tools will i need to change the front and back brakes on a 95 mustang V6 would like to get the tools up before i jack up the car and take wheels off then have to put them back on to run to parts...


My 1995 mustang uses a 13 mm socket for the front calipers. I used a screwdriver to pry the pads back before removing the calipers, easier than using the C-clamp method.
As for the back brakes if you have the shoe type brakes you will need a brake shoe adjusting tool to loosen the adjusters.
Probably a good sized 2-4 pound hammer.
Slip joint plyers.
A 5/16 -3/8 wrench for the bleeder screws depending on the one you have. I didn't need to bleed mine as I was able to remove the shoes without disturbing the wheel cylinders.
If you need to bleed the brakes a good bleeding kit or 2 people that can work together pumping and bleeding the brakes .
hope this helps.
As always I would refer the a good shop manuals such as Motor, Haynes or Chiltons.

Jun 14, 2009 | 1995 Ford Mustang

1 Answer

Brake problem


Do you have a leak? If not try bleeding the ones that don't work. If you get no fluid pressure, replace the master cylinder.

Apr 02, 2009 | 2005 Nissan Maxima

1 Answer

Brake pedal stuck 1995 crown vic lx


did you bleed the brakes and get the air out of the lines and also if you have shoes on the back did you put the little shoe in the front and the largest in the back? and if you replaced the wheel cylinder or had any lines opened you have to bleed the brakes

Jan 15, 2009 | 1995 Ford Crown Victoria

1 Answer

1995 nissan max. callibers problems HELP PLEASE


Hi,You may have ,wrong (calipers) or not original rims, chech if you did not installed the right and left calipers in the proper order and be sure to bleed the brake lines properly .Hope this will help you.....

Aug 17, 2008 | 1995 Nissan Maxima

Not finding what you are looking for?
1995 Nissan Maxima Logo

Related Topics:

233 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...