Does the antenae go down or come off so I can go through a car wash? Or will it be OK?

YOU NEED TO TAKE TO AUTO REPAIR SHOP SO THEY CAN ERASE THE CODES OF THE SISTEM DID YOU BY MISTAKE INSERT WRONG KEY IN IT IF YES DO THAT IF NOT THEN YOU HAVE A BAD SIGNAL AT YOUR IMMOBALISER ANTENA WISH ITS LOCATED AT YOU STERING COLOM OK LET ME KNOW IF I CAN HELP MORE OK

If it's an electric antenna, it should retract when you turn the radio off. If not either the relay or the drive motor has failed. if its a "fixed" antenna, you don't do anything and just leave it in place.

Only from the dealer.

Replace the antena mas

on the radio there is a cable that is for Power Antena you might have to set a cable out to the area you are instslling the antena if this car already had a power antena you only need to hook up the leds from the old if not then like i said you need to get positive cable out to the antena and ground it to chassis

Jeep grand cherokee ltd, 1996 The radio is not working, when I switch the power on the antena motor makes a noise although the antena is always up, there is no sound from the radio what so ever, it says WAIT 2 1/2 hours but nothing happens, no tape radio cd, switch the radio off the antena makes a noise then the radio switches off.

Well radio surpretion is very hit and miss the first thing to do is make shure your aerial (antena) is propaly earthed to the body where it is mounted.

Also that the set itself has it.s own good earth and not useing the antena ae an earth if the set is modern and you obseve these thins you shuldn't get any problems! O.K.?

turn on the stereo so the antena will come up and where the antena goes in to the fender u will have to go under the hood and look through one of the holes in the inner fender to see the antena motor or u can take the plastic inner fender off from inside of the wheel well to get to antena motor then when u can get to the motor u will see a black fairley large wire wich is the antena wire it self and u should see one more small wire just unplug small wire or clip with wire cutters and tape the ends off with electricle tape as so it wont arc out any where

im guessing the antenna has been replaced and wires were mixed up. take the rear panel off in the trunk to give access to the antenna motor and look at the wiring there should be 2 small wires and one larger black wire. the black wire is the reception wire the other two are the power wires. switch the positions on the two power wires. say wire A is in plug 1 and wire B is in plug 2. final position should be A in 2 and B in 1. that should take care of it. good luck

most of time the antena power is blue coming from radio, locate the one in the car going to antena and conect the blue antena wire to it