Question about 2006 GMC Sierra 2500HD 2WD

1 Answer

Change water pump 6.6 ltr duramax - 2006 GMC Sierra 2500HD 2WD

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Not too bad of a job, pull the fan and dampner. ive heard of guys saying they can do it without pulling the dampner (i dont know how?) it doesnt take long to get it off. dont put a cheap w/p back in, if the shaft seal goes out you will have alot of coolant in the oil.

Posted on Dec 03, 2010

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

polarcycle
  • 1392 Answers

SOURCE: water pump

Is it a 99 or an 03? Either way fairly simple. You will need to remove the splash shield on the passenger side wheel well. Removing tire is optional. If it is a 99, the pump should be located near the radiator. Loosen the bolts that hold the pulley on the pump before removing the belt. This will save you time later. Remove the belt, then remove the pulley. Take all the bolts out of the waterpump. Install in reverse order. If it is an 03, it is near the firewall side of the motor. Remove shield, loosen pulley bolts. The pulley will not come off until you get the water pump out, but you need to remove the bolts for it any way. Take the bolts out of the waterpump. You will need a pry bar to get the pump/pulley out. You can pry on the tensioner against the fenderwell and wiggle it out. Install in reverse order.

Posted on Mar 06, 2009

  • 532 Answers

SOURCE: how to change water pump

i suggest you buy a repair manual,there is too much to go over,

Posted on May 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel pump located on a 2001 gmc 6.6 turbo duramax deisel truck?


Hi Lone Ranger,

The first link offered has information to set you up US Diesel Parts Fuel Pumps Injection Pumps and Injectors GM Duramax LB7 . Now on to the location. Here is a quick feed to watch duramax cp3 pump swap . Lets finish with this gentleman's input and contribution. Duramax cp3 high presure fuel pump removal .


This will provide a look and see distant generalization of what you may be getting into and some live experiences of those who did. Fare. Well.

Jul 27, 2014 | 2001 GMC Sierra 2500HD

1 Answer

My 04' Chevy 5500 truck with 6.6 ltr. duramax lost power twice while climbing the highway in the Yukon territory. Pulled off the side of the road at idle, throttle would not take engine past 2000


Did the check engine light come on ?
Could have been a restriction in the fuel line or a problem with the throttle position sensor among other things.

Sep 14, 2012 | Chevrolet Cars & Trucks

1 Answer

1996 DODGE RAM 1500 4X4 5.9 LTR.. Problem is that


You have a blown heater core my friend. I have a quick fix and a permanent one. Quick fix is to unhook the hear lines from the fire wall and couple them together. That will stop it from over heating. 2 requires a friend and a full 6 hours. Remove the dash. I recommend getting a haynes manual for the dash removal. Hope this will point you in the right direction.

May 30, 2010 | 1997 Dodge Ram

2 Answers

Need to replaCE WATER PUMP 2002 GMC DURAMAX DIESEL how hard?


cardenderek,
This info is totally bogus.You obviousely have never changed a water pump on a 6.6 liter Duramax Diesel engine.1st off it isnt belt driven it is gear driven from the drive train inside the engine.You have to remove the fan shroud,clutch fan assem.,and harmonic balancer as one of the mounting bolts is behind the balancer.Also remove the left side inner fender for easier access.

catD8RII

Mar 12, 2010 | 2002 Chevrolet Silverado 2500HD

2 Answers

Labor time to replace a faulty water pump in 05 Gran Caravan 3.8


Try (repairpal.com) for estimate for your particular area. You may have to enter Grand Caravan to get the 3.8L engine .
I'm thinking 2 hrs.

Oct 05, 2009 | 2005 Dodge Caravan

1 Answer

Locate water pump on a 4.5 ltr engine


Follow the large diameter hose from the bottom of the radiator. This hose is connected to the water pump.

Jul 05, 2009 | 1995 Cadillac DeVille

1 Answer

How to change water pump


i suggest you buy a repair manual,there is too much to go over,

May 06, 2009 | 1994 Chevrolet Cavalier

2 Answers

6.6 duramax how many quarts of oil do I need for change


A 2003 6.6 duramax holds 10 quarts with filter. you must also use a high quality diesel rated oil such as shell rotella 15w 40

Feb 01, 2009 | 2003 Chevrolet Silverado 2500HD

1 Answer

Water pump on a toyota landcruiser 4.2 ltr diesel


Hi Scott_har892
In shortr yes,
If it's getting close to a timing belt change and or the water pump is about to fail do them both at the same time with the radiator removed (just makes it so much easier) while your are at it do the timing cover seals as well

Dec 04, 2008 | 1993 Toyota Land Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

375 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...