Question about 2004 Dodge Stratus

Open Question

Location oil pressure sensor 2004 dodge stratus se 2.7

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75822 Answers

SOURCE: 2004 Dodge Stratus 2.7 thermostat location

Finding the thermostat: Follow the LOWER radiator hose to where it meets the engine. It's in there. Most cars that I've worked on have the thermostat at the end of the upper radiator hose, but not this car. Replacing the thermostat: You need to remove the thermostat housing. (It's the piece that the lower radiator hose connects to.) - You do not need to remove the radiator hose from the housing. - First remove the bolt that is holding a bracket. This bracket just holds some wires in place. - Now remove the three bolts that hold the housing to the engine block. These bolts can be fairly hard to turn, but just keep trying. - Gently pry the housing away from the engine block. You can use a flat-head screwdriver to help pry, but do not scratch the mating surfaces of the housing and the block. - Pull out the thermostat, noting that the spring end goes into the engine. - When you put the new thermostat in, you probably want to use a new black rubber gasket, but you might be able to use the old one if you have no choice. Also, I didn't add any permatex or anything and it seems fine. - I tightened the bolts to 22foot pounds, but this might be a little high. Whatever you do, DO NOT overtighten the bolts. Couple other notes: I first removed the air cleaner cover and tubes to get a little more working room. I also unplugged one wiring harness to make more room. Otherwise, I was able to get my big hands in there. A new thermostat did not fix my problem. Here is a description of the problem I was having and the solution: Problem: The temperature gauge was spiking occasionally, all the way into the red. It would spike up and come back to normal. It would spike usually while in idle, but sometimes while driving. Usually about once every twenty minutes. Things I checked first: - The plastic reservior for the radiator was full to the top. - The electric fans were running, and running on high speed. - The car had working heat. - Replaced the thermostat. Did nothing to help the problem. Problem Found: - Vapor lock. Even though the reservior was full of fluid, it had previously gotten too low and the system sucked in some air. Once that happens, it doesn't matter if the reservior is full, the cooling system will not draw in the coolant. This is because filling the plastic reservior does not pour coolant directly into the cooling system. The coolant is sucked into the cooling system through a tube, like drinking soda through a straw. So the reservior, where they tell you to add coolant, was full but the cooling system (radiator, engine, pump, etc.) was almost out of coolant and wasn't able to draw in any more. Solution: When the engine is cool, open the metal radiator cap that's sticking right up out of the engine. It can be found by following the upper radiator hose to the engine. There is a tall metal tube with a metal cap on it. Pull that cap off (when it not hot) and fill it up with radiator fluid. (I use radiator fluid that's pre-diluted and designed for all makes and models of cars). Idle the car, in park, for about thirty seconds. Stop the engine and put the cap back on. If you're lucky, all the air bubbles are out of the system and you're all set.

Posted on Dec 02, 2008

  • 1861 Answers

SOURCE: MAF Sensor 2004 Dodge Stratus

If your car has a MAF (Mass Air Flow) sensor, it would be located in the air delivery tube that runs from the air filter box to the throttle plate assembly on the intake manifold. It will have a wiring connector going to it, also. The MAF does exactly what it is called: It "senses" the volume, or "mass" of the air-flow; thusly it needs to be in the intake air tube. If you do NOT have such a device in the air-tube, you have a MAP sensor, (Manifold Absolute Pressure); this is another way of measuring the same air volume, albeit older technology. You will commonly find this device on the firewall, with a vacuum line running to the intake manifold.

I hope that this sheds some light on your question.

Thanks for choosing FixYa for advice!

Posted on Mar 06, 2009

polarcycle
  • 1392 Answers

SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?

it is located on the right side of the motor, in the trans area. Actually in the bell housing.

Posted on Jun 23, 2009

  • 1 Answer

SOURCE: oil pressure sending unit location

oil pressure sending unit show location on 2000 dodge caravan V-6

Posted on Nov 28, 2009

  • 1810 Answers

SOURCE: my oil light wont go out where is the oil sensor

usualy it is located in the side of the oil pan or just above it

try reseting the computer by disconecting the battery for a few minutes it might do a self reset on the switch if you get luckey

Posted on Dec 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to know location of oil pressure sender on a 2001 Dodge Stratus SE with 2.7L engine


It will be on the engine block close to the oil filter. It will have a wire connected to it.

May 18, 2017 | Dodge Cars & Trucks

2 Answers

Diagram of where a camshaft sensor is on a dodge stratus 2.4L 4 cylinder


2003 model
not confirmed
crank angle sensor might be near the stater motor on the block


26233366-qzmmc3ihqjw1j4mumdlnccct-4-0.gif

26233366-qzmmc3ihqjw1j4mumdlnccct-4-2.gif

Jul 07, 2016 | Dodge Cars & Trucks

1 Answer

Where is the oil pressure sensor located on a 2014 Dodge Charger SE


Kelli, on 2.7 motor it is by oil filter above steering rack, in the eng. block, I think some may behind alternator and bracket also.
If these location do not seem to be right, do a online search with your info. and engine size.

Dodge Magnum oil pressure switch oil pressure light
Chrysler 300 2 7L oil pressure sensor location

Mar 20, 2016 | Dodge Cars & Trucks

2 Answers

Where is bank 1 sensor 2 located at on 2003 dodge stratus wit a 2.4 engine ?


    Dodge Chrysler - YouTube

    ? 2:54
    https://www.youtube.com/watch?v=vs2DuvehVGA
    Oct 31, 2013 - Uploaded by 1A Auto Parts
    I want to know about a Dodge Stratus 2002 sensor. ... I have a 05 Chrysler 300 2.7 engine with a fault code ... images for Where is bank 1 sensor 2 located at on ...


    More images for Where is bank 1 sensor 2 located at on 2003 dodge stratus with a 2.4 engine

    Where is bank 1 sensor 2 located at on 2003 dodge stratus wit

    www.fixya.com/cars/t26025690-bank_1_sensor_2_located_2003_dodge
    22 mins ago - SOURCE: check engine light is on...bank 1 sensor1 oxygen sensor. if u have one .... 2.7L dodge stratus/ #1 bank #2 sensor location? on 2004 Stratus. Oct 24 ... How can I set the timing on a 1996 dodge stratus 2.4l engine.

    P0137 02 Sensor Circuit Low Voltage - OBD-Codes.com


Dec 28, 2015 | Dodge Cars & Trucks

2 Answers

My dodge stratus 2004 the oil light is going on and off but the oil is not low


Could be a problem with the oil pump, the oil pressure sensor, clogged oil lines, or something more major.

Oct 18, 2014 | 2004 Dodge Stratus

2 Answers

Lwhere is oil pressure sending unit on 2006 dakota v6 located?


Location of the OPS unit is at the rear of engine near the distributor. (OPS) oil pressure sending

Jul 11, 2014 | 2004 Dodge Stratus

1 Answer

2.7L dodge stratus/ #1 bank #2 sensor location? on 2004 Stratus


on the exhaust pipe just below the catalytic converter

Oct 24, 2011 | 2004 Dodge Stratus

1 Answer

Oil filter location on 2004 dodge stratus


on the pass. side of the car, it hangs down on the backside of the engine

Oct 14, 2009 | 2004 Dodge Stratus

1 Answer

Oil pressure sending unit location


oil pressure sending unit show location on 2000 dodge caravan V-6

Mar 23, 2009 | 1997 Dodge Stratus

Not finding what you are looking for?
2004 Dodge Stratus Logo

Related Topics:

670 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...