An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has answered 20 questions.
Re: removing front door panel
There will be two bolt that are hidden under your arm rest they will probably be hidden little caps that just pop off most likely a star screwdriver you will need a window handle remover tool if you have power windows dont worry about it but you will also need a door panel clip remover tool or you can get by with a screwdriver covered in a cloth insert at bottem of the door an gently pry untill the door clip start to pop and release you will also need to remove a screw where you open the door from the inside hope you get it off if you break any of the door clips(happens all the time) just take broken one to the dealer or canadian tire or parts jobber hope this helps
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I have info on a 96 power door glass.....should be very simular. the triangle piece at the top front is just clipped on, the plastic piece around the opener handle is just clipped on. in the pull handle there are two screws, and the plastic piece just pops up. under the red reflector the is a screw. There is a "U" clip behind your window crank, remove this clip and the crank will pull straight out. (use a screw driver to open the gap between the crank and the door panel, to see the clip, Use a hook tool too remove the clip...you can also use a cloth or panty-hose in the gap and turn the crank, the cloth will grab the edge of the clip and pop it off)
after removing all the clips and screws the door panel is held on with plastic plugs, just pull the panel sraight out toward youself.
hope this helps.
Pretty easy. remove the plastic cover above the door panel and there should be 3- 10mm nuts holding the assy on. You may have to remove a plasticfoam seal to see the nuts. If it's a power mirror, you may have to remove the door panel to unplug it.
There are a combination of screws and push pins. You have to pop out the red reflector on the bottom toward the back and remove that screw. There is a screw in the trim piece is around the handle. There are 2 more screws in the front of the arm rest and one in the back. After that you need a tool that looks like a screw driver with a tip on it that splits in a v shape to pop out the push pins. they are located down the back ,along the bottom, and up the front. I think there is around ten of them.
there are screw and bolts hidden around the handle and the rear reflector to door there is a phillips screw underneath it. The power window switch pulls straight up and unclips then just unplg it. once all the bolts and screws are out of the way, you will now have to pull panel towards you, it is held on with plastic clips the do hold well. so you will have to pull hard. Start from bottom front of the panel and work your way up. once you are at the top you may have to lift the very top to get around the hooks holding the top uf the door.
These are bad about those Cable operated window devices .. If it is bad get on ebay and get one ordered its your best bet.. Just take a flat screwdriver and go around the bottom of the door panel and pop it loose and up the sides .. there might be a hidden screw or two in the middle around the handles.. good luck ..
rt rear door panel should be easy their may be screws in and around the trim panel check for little top covers take off and screws are underneath them. know when you pull the trim off its mounted by retainers so be careful pull at bottom and work your way to the top pull upward and then take off you should be able to see after that