Question about 1997 GMC Jimmy

1 Answer

Blinkers light up don't blink. where is switch ?

Where is switch located for blinkers on 1997 gmc jimmy 2 door

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 46 Answers

In the steering column attached to your blinker arm.

Posted on May 28, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to repair not working rear lights 1997 gmc jimmy


brake lights not working - 1997 GMC Jimmy - RepairPal

repairpal.com > Questions > GMC > Jimmy > 1997 GMC Jimmy
Jan 11, 2011 - hi about 2 days ago i realized my brake lights were not working but my turn signal lights were working and parking lights as well but no brake ...

Tail Lights don't work but third brake light does, not fuses ...

answers.edmunds.com > Edmunds Answers
Sep 23, 2009 - 97 GMC Jimmy 4x4 blinkers work, reverse lights work, above window ... I just lost hazard lights and rear brake lights, they were working 2 days ... If it is a frayed wire or solder point, then you can repair it, but not any worn contacts. ... Does anyone have any suggestions on 1997 Honda Accord tail & brake lig.

Nov 19, 2015 | GMC Cars & Trucks

1 Answer

Blinkers not working 97 gmc jimmy


You may need a voltmeter to check if power is going into the turn signal switch. Start at the turn signal fuse and see if power there, with key on.

Jan 12, 2014 | 1997 GMC Jimmy

1 Answer

Dome light and courtesy light stays on in my 1987 S-15 GMC Jimmy even when car is off and doors are closed


courtesy lights have a 3 position switch 1 is for doors open --on /off 2 is for light off permanent and 3 is for light on in car permanent for reading etc. Other than that check the door switches for a permanent earth fault.

Apr 23, 2013 | 1997 GMC Yukon

1 Answer

Dome light and key in ignition tone won't quit.


Yes, I would lean toward a stuck drivers door latch. Your door open switch is located in the latch itself and the ding is a reminder your key is in the ignition so you don't lock them in the vehicle when you lock the door. even though your door is shut, the truck still thinks it is open. sometimes spraying the latch with some WD-40 will get it freed up and working again, but a new latch might be in your future.

Apr 21, 2013 | 1997 GMC Jimmy

1 Answer

With my 1997 Pontiac Trans Sport, the blinkers come on but they don't blink. Is the switch bad?


Could be dirt in side the switch.You have to take off,I did on 99 grnd am.

Apr 09, 2013 | 1997 Pontiac Trans Sport

1 Answer

Where is shift actuator located on 1999 Jimmy 1999


I had the same problem with my 1999 Silverado which would blink several times on the mode I selected then go back to the 2 wheel High. I found the switch module to be defective, after replacing it I have never had the problem again.

Nov 22, 2010 | 1999 GMC Jimmy

1 Answer

1997 gmc jimmy 2 door 4wd i was driving 40mph the spedometer went to 0 the anti-lock brake light came on Ishifted to 2 and could only go about 35mph after a short time the problem cleared up and it ran...


sounds like the electronic speed controle sensoe is going out. it is located either on the transmisson or rear differntal. or take it to a transmission shop and let them hook to a didnostic machine. berrydalewolf

Oct 29, 2009 | 1997 GMC Jimmy

1 Answer

Blinker blinks all the time lights work normaly


Hello, its sounds as if you have a multifunction switch going out.The turn signal swich. This switch will cause all your lights to go haywire.Thank YOu

Feb 21, 2009 | 1997 GMC Jimmy

1 Answer

Blinkers not working on 97 jimmy


located uner dash near centre must pull down all plastic inder dash there should be more then one flasher module there should be right in front of centre concole.

Jan 02, 2009 | 1997 GMC Jimmy

1 Answer

Brake light not working


I had to replace the multi function switch which is the blinker switch on the stearing column. This switch controls the rear brake lights. Had to replace this switch 2 times.

About $250.00 - $300.00 from a US dealer.

Good luck

Aug 10, 2008 | 1997 GMC Jimmy

Not finding what you are looking for?
1997 GMC Jimmy Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...