Question about 1994 GMC Sierra

Open Question

How to take out rear speakers in 1994 gmc sierra ie. interiors body panels

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1986 Answers

SOURCE: 2001 GMC Sierra C3 How to get front door panels off

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

Ad
Rayvin1943
  • 97 Answers

SOURCE: 1994 gmc rear axle removal how to

-Remove tire and brake drum
-put drain pan under axle housing
-remove rear axle housing cover (10 or 12 bolts)
-turn gear untiil the bolt for cross shaft shows and remov e the bolt
-remove the cross shaft.
-push axle in until you can remove "U" clip from axle and axle will pull out,
Remove seal, you need a pulller to remove axle brg.

Posted on Jul 26, 2009

  • 198 Answers

SOURCE: 2004 gmc sierra rear differential

remove cover.take off back wheels and calipers (or drums).turn differential to where you see small bolt/pin (5/16) horizontally (same direction as axles)on right side of differential.remove bolt/pin.A large pin (about 5"long 3/4"diameter) should slide out differential with ease ( you may have to tap one side of the large pin).turn differential to completely remove large pin.turn differential so you can see in the view window.push each axles in (they'll go in about 1 1/2"each) You may hear one of the axle C-clips fall.If not use a small telescoping magnet to remove the C-clips from the axles through the differential window.pull each axle out about 10"so they are out of the diff.Now remove the cap bolts(4-5/8"bolts) and remove the caps(mark the caps so they go in excactly the way they came out.be careful the diff might fall out.If not you may have to use a long bar or 2x4 to wedge and pry the differential out. Have a basket/crate w/rags in it to catch the diff.TIP:If you are removing the ring gear from the diff, the bolts are left handed bolts meaning you have to turn them clockwise to loosen and counter clockwise to tighten ; )

Posted on Sep 15, 2009

Testimonial: "thank you helped ALOT perfect instructions "

  • 255 Answers

SOURCE: how to remove rear door interior door panel

You should obtain a tool made specifically for removing door panels. They are attached by "snap" connectors, and by pulling on the door panel itself will invariably ruin it. Get the tool from a parts place and carefully peer into the slot between the door metal and the door panel. Use the tool slowly with resolution. You should really acquire a manual that guides you for your particular Jag.
Remember, to take the panel completely off, you need to remove the door handle. Look for a plug that has a screw under it. You'll need to pop the door window/lock control panel too, to access screws under there. This can be tricky, so be careful.

Posted on Nov 24, 2009

  • 1244 Answers

SOURCE: Replacing interior door handles on 98 Sierra

theres what they call horseshoe spring clips on the back side of the handles they make a special tool that pushes them off! but if you got a small piece of stiff wire take a pair of needle nose pliers and make a short!! gental hook on the end and push the door panel back far enough to see the clip and hook into it and pull straight out!

Posted on Jan 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I broke off the IAC valve in the throttle body in a 1994 GMC Sierra 4.3lt.. need to know how to get it out. Please help!


if accessible from a good angle Need to drill in to the broken part in the throttle body using a drill bit a bit smaller then the IAC thread as close as possible to the throttle body thread U need rethreading tap similar to the IAC valve if available in size and thread run thru to clean the throttle body thread and replace with new one if no access to it need take out throttle body U have to take Ur time.
Good Luck

Dec 21, 2016 | 1994 GMC Sierra

1 Answer

How do I remove the door assembly on a 1994 gmc Sierra k1500


Hello,

There's in usually two ways to remove a car door. Either the hinges bolt to the frame of the car, OR they bolt to the inside of the door. In some cases they are welded in place, but that's pretty rare. If you can open the door, look in the door jam snd you should see the bolts. If you don't, try removing the interior door panel and look on the inside of the door (towards the front) and you should see them there. I'm sure the window frame will have to be in the "up" position. Good luck.

Mar 01, 2015 | 1994 GMC Sierra

1 Answer

1994 GMC Z71 extended cab.... tail lights, interior lights not working but everything else is....What fuse or relay do i look for and where are they located on the truck?


The fuse panel is located under the driver's side of the dash. I'm not sure off hand which fuse controls these lights.

Feb 02, 2013 | 1994 GMC Sierra

1 Answer

Door speaker wiring diagram for 2002 sierra


2002 GMC Sierra C1500 Car Radio Wire Color Codes
Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black/White
Car Radio Illumination Wire: Brown
Car Stereo Dimmer Wire: Gray
Car Stereo Amplifier Location: Under the center console.
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

Dec 20, 2012 | 2002 GMC Sierra 1500

1 Answer

Wire harness to switch from stock stereo to cd player will not fit the wires that are supposed to? so what wires are the speaker wires


Not sure I understand your question. Did you buy a harness adapter for GMC, or are you trying to just cut the connector off the factory radio and solder it to your CD player? If the latter, below is the color code for your factory wiring.

1994 GMC Sierra C1500 Car Radio Wiring Schematic
Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black/White
Car Radio Illumination Wire: Brown
Car Stereo Dimmer Wire: Gray
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

Nov 20, 2010 | 1994 GMC Sierra

1 Answer

How to change 2001 GMC sierra speakers


sorry but the panel needs removed, go on be brave its not all that hard to do .adrian,,

Jul 31, 2010 | 2001 GMC Sierra Crew Cab

2 Answers

Where is the iat sensor located on a 1994 gmc sierra


IAC-passenger side of throttle body.IAT-located in the plastic intake duct directly after the air cleaner and before the throttle body.
hope this helps?

Dec 26, 2009 | 1994 GMC Sierra

1 Answer

How do you remove the interior rear panel/


In my 1997 S-10 extended cab, you have to take the upper torx bolt out for the seatbelt, the clothes hook above the extended cab window, and a few other minor screws. Should be easy to see.

Oct 06, 2009 | 1997 GMC Sierra

2 Answers

Factory radio wiring color codes


Here ya go. enjoy!
2002 GMC Sierra C1500 Car Radio Wire Color Codes
Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black/White
Car Radio Illumination Wire: Brown
Car Stereo Dimmer Wire: Gray
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: Under the center console.
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

May 14, 2009 | 2002 GMC Sierra 1500

Not finding what you are looking for?
1994 GMC Sierra Logo

Related Topics:

194 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...