Question about 1994 Ford Thunderbird

1 Answer

1. BEEPING BEHIND GLOVE COMPARTMENT WHEN KEY IS OFF WILL BEEP UNTIL THE BATTERY GOES DEAD? 2.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I have a '94 Thunderbird also and the beeper is on when the key is removed and the drivers door is open, but goes off when I close the door.

Posted on Oct 17, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can i access my trunk in my 2006 impala if my battery is dead


Rear Compartment Lid Release
The rear compartment lid can be released by depressing the rear release button in the glove box or holding either front power door lock switch to the unlock position for a minimum of 2 seconds or by pressing the rear compartment release button on the key fob. The transmission must be in the PARK position for the rear compartment to release. No Key lock on the trunk ?

Dec 07, 2015 | 2006 Chevrolet Impala

2 Answers

Where are the fuse boxes on fiesta zetec s petrol 2009


Fuse box is located in the glove compartment. Empty the glove compartment, then the side will pop out for access to the fuses.
25025230-onzbdthlkhwu0gpquek0abow-4-0.jpg

25025230-onzbdthlkhwu0gpquek0abow-4-2.jpg

Aug 28, 2014 | 2010 Ford Fiesta 1.25

1 Answer

Where is the cabin air filter on a 03 dodge ram


Cabin air filters are typically found in 1 of 2 places. Either behind the glove compartment, youll have to push the sides of it inward until they pop past the stops, and therell be a rectangular cover on the filter, pop that off and itll be hiding in plain sight! Or from outside the vehicle, around the wiper blade on the passenger side, therell be a removable panel to get to it. Chances are its inside, behind the glove compartment.

Aug 16, 2014 | Cars & Trucks

1 Answer

Under the glove compartment is a beeping noise?


what is the make and model and year ?

Dec 28, 2012 | Cars & Trucks

1 Answer

In the 2006 STS is there a place in the car where the key fob can be inserted to turn the car on if the battery is dead? In the XLRV there is a place in the glove compartment


Hello: If you are talking about the battery in the key fob then yes, there should be a slot in the glove compartment that you can insert the key fob and it should work. If you are referring to the main car battery then no, you will have to charge, jump or replace the battery.

Jun 14, 2011 | Cadillac STS Cars & Trucks

1 Answer

I need to change my door codes on my 92 nissan maxima


1991-94 Nissan Maxima key less entry reprogramming:

1. The *original code found on the gold box under the glove compartment by the left kicker panel
(there should be 3 sets of codes on the gold box the code u want begins with the letter F and has 7 digits.) (_EXAMPLE_ F# S1234567 )

2. Close and lock all of the doors,
enter the 7 digit code ( make sure you have your key in your pocket not inside any key hole).

3. Once the code is entered correctly you will hear a long beep.
While the beep is sounding ... ENTER your NEW 4 digit code, (you will then hear random beeps)
>>>>>>>>>>>>>Do not touch anything until the beeping stops.
________After the beep is over______
4. T
ype: S or ST (Clear) and the New 4 digit code and the door will open automatically.
~~~~~~~> NOW YOUR DONE YOUR CODE HAS BEEN RESET.
5. If you forget your new code. Just enter the original one and start all over.
Its really simple I hope it helps...............

Mar 21, 2011 | 1993 Nissan Maxima

1 Answer

How to reset 93 nissan maxima keyless pad when there is no code to be founded or is it somewhere on the car.


1991-94 Nissan Maxima key less entry reprogramming:

1. The *original code found on the gold box under the glove compartment by the left kicker panel
(there should be 3 sets of codes on the gold box the code u want begins with the letter F and has 7 digits.) (_EXAMPLE_ F# S1234567 )

2. Close and lock all of the doors,
enter the 7 digit code ( make sure you have your key in your pocket not inside any key hole).

3. Once the code is entered correctly you will hear a long beep.
While the beep is sounding ... ENTER your NEW 4 digit code, (you will then hear random beeps)
>>>>>>>>>>>>>Do not touch anything until the beeping stops.
________After the beep is over______
4. T
ype: S or ST (Clear) and the New 4 digit code and the door will open automatically.
~~~~~~~> NOW YOUR DONE YOUR CODE HAS BEEN RESET.
5. If you forget your new code. Just enter the original one and start all over.
Its really simple I hope it helps...............

Jan 29, 2011 | 1993 Nissan Maxima

1 Answer

Need to replace heater blower motor. How do I get to it?


Behind the glove box. Please see my tip at http://www.fixya.com/cars/r6234839-doesn_t_heater_or_air_conditioner_blow . These are generic instructions. If you get stuck, please get back to me.

See instructions from autozone.com below.


REMOVAL & INSTALLATION


With Air Conditioning
See Figures 1, 2 and 3

  1. Disconnect the negative battery cable.
  2. Remove the glove compartment door and glove compartment.
  3. Disconnect the blower motor wires from the blower motor resistor.

jturcotte_62.gif
Fig. Fig. 1: Disconnect the blower motor wires from the blower motor resistor-1988 Escort
  1. Loosen the instrument panel at the lower right-hand side prior to removing the motor through the glove compartment opening.
  2. Remove the blower motor and mounting plate from the evaporator case.
  3. Rotate the motor until the mounting plate flat clears the edge of the glove compartment opening and remove the motor.
  4. Remove the hub clamp spring from the blower wheel hub. Then remove the blower wheel from the motor shaft.
jturcotte_63.gif
Fig. Fig. 2: Unbolt the mounting plate from the case


jturcotte_64.gif

Fig. Fig. 3: The motor can now be removed from the case


To install:

  1. If removed, assemble the blower wheel to the motor shaft and install the hub clamp.
  2. Install the motor and blower wheel assembly.
  3. Secure the instrument panel at the lower right-hand side.
  4. Connect the blower motor wires at the blower motor resistor.
  5. Install the glove compartment door and the glove compartment.
  6. Connect the negative battery cable.
  7. Check the system for proper operation.

Without Air Conditioning

  1. Disconnect the negative battery cable.
  2. Remove the air inlet duct assembly.
  3. Remove the hub clamp spring from the blower wheel hub. Pull the blower wheel from the blower motor shaft.
  4. Remove the blower motor flange attaching screws located inside the blower housing.
  5. Pull the blower motor out from the blower housing (heater case) and disconnect the blower motor wires from the motor.

To install:

  1. Connect the wires to the blower motor and position the motor in the blower housing.
  2. Install the blower motor attaching screws.
  3. Position the blower wheel on the motor shaft and install the hub clamp spring.
  4. Install the air inlet duct assembly and the right ventilator assembly.
  5. Connect negative battery cable.
  6. Check the system for proper operation.

Nov 05, 2010 | 1989 Ford Escort

2 Answers

Where's the battery? Behind/under the back seat? The battery is dead. 3 doors and the glove compartment are locked and the key won't even unlock them. Help! Thx


in the trunk. you will need to get under the hood if the trunk wont open to charge the battery. There is a post on top of the intake manifild

Nov 26, 2009 | 1997 BMW 5 Series

1 Answer

TAURUS KEEPS BEEPING FROM GLOVE BOX AREA


The beeping noise is coming from the airbag module located behind the glove box. It will require a trip to a mechanic to get the issue resolved.

Nov 13, 2009 | 1992 Ford Taurus

Not finding what you are looking for?
1994 Ford Thunderbird Logo

Related Topics:

281 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...