Question about Ford Explorer

Open Question

How do i put in transmission fluid in 2006 ford explorer

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 93 Answers

SOURCE: 1993 ford explorer type of fluid

Five-Speed Manual Overdrive Transmission (Ford Manual Transmission) Motorcraft MERCON® Multi-Purpose Automatic Transmission Fluid XT-2-QDX or -DDX (E4XZ-19582-B) or Equivalent




the above are ford part #'s listed from the service manual.
ps your 4 thumbs up is appreciated!

Posted on Jun 17, 2009

Ad
  • 1 Answer

SOURCE: I need change the automatic transmission fluid Explorer 2002 E.B.

There IS a transmission drain plug on the 2002 Ford Explorer! It is, however, difficult to get the fluid back in as there IS NO dipstick (tube) to refill it. I installed the pan bolts far enough to hold the pan up (level) and then stuck a hose (attached to a funnel at top of engine compartment) through the opening between the pan and the bottom of the transmission. I was able to put five quarts in that way - no more as it will overflow (trust me). You can check other sites on how to check to see if that's enough and how to add more as needed. That's not simple either. Great idea Ford Motor Company (sarcasm) !!!!!!

Posted on Oct 13, 2009

Molson02536
  • 3854 Answers

SOURCE: Tire sensor fault on our 2006 Ford Explorer after new tires

2006 Ford Truck Explorer
NOTE: The tire pressure sensor training prcedure must be done in an area without radio frequency (RF) noise. RF noise is generated by electrical motor and appliance operation, cell phones, and remote transmitters.

1. Turn the ignition switch to the OFF position
2. Turn the ignition switch to the RUN position three times, ending in the RUN position. Do not wait more than two minutes between each key cycle.
3. Press and release the brake pedal
4. Turn the ignition switch to the OFF position.

Sequence:
1- Left Front Tire
2- Right Front Tire
3- Right Rear Tire
4- Left Rear Tire


5. Turn the ignition switch from the OFF position to the RUN position three times, ending in the RUN position. Do not wait for more than two minutes between each key cycle.
6. The horn will sound once and the TPMS indicator will flash if train mode has been entered successfully. If equipped, the message center displays "TRAIN LEFT FRONT TIRE." Place the magnet on the valve stem of the LF tire pressure sensor. The horn will sound briefly to indicate that the tire pressure sensor has been recognized by the TPMS module.
7.Within two minutes after the horn sounds, place the magnet on the valve stem of the RF tire pressure sensor. NOTE: If the TPMS module does not recognize any one of the four tire pressure sensors during the tire training procedure, the horn will sound twice and the message center (if equipped) will display "TIRE TRAINING MODE INCOMPLETE." If this occurs, the entire procedure must be repeated from Step 1.
8. Repeat Step 7 for the RR and LR tires. When the tire training procedure is complete, the horn will sound once and the message center (if equipped) will display TIRE TRAINING MODE COMPLETE.

This should help. For now, probably all Fords are like this. And I do not believe that Ford puts sensors in their spares (some GMs do).
Good luck

Posted on Nov 13, 2009

  • 85 Answers

SOURCE: 05 Ford Explorer Transmission

on the bottom of the transmission pan you will find a nut with a hex or torx in the middle you remove the center plug when the truck is hot and running on a level serface the trans fluod will dribble out if it does not dribble out it is low if it runs out fast a steedy streem it is over full now their is a part that screws into this for a fill if you remove the pan you will see how it works the pan has a pipe/ stack that when full of fluid the top of the pipe is at the full point if you remove the large nut the stack and plug will come out the best way to change the trans fluid is take it to some place that has a fluid exchange equment this will get all the fluid out including the torque converter

Posted on Dec 27, 2009

cmcduncand
  • 714 Answers

SOURCE: how can i check to transmission fluid level in 2005 ford explorer

Does not have a dip stick.

Start the vehicle set park brake

In the side if the transmission oil pan a bigger bolt with a small bolt in the center.

Remove smaller center bolt trans fluid should drip out at a fairly constant rate if not its low.

Hope this tip helps.

r/
David

Posted on Feb 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the automatic transmision filler or adding the fluid on 2006 ford explorer


Hi there.
You should take it back to either FORDS or any auto matic gear/box people and have it changed and refilled with new autotrans fluid

Jan 12, 2014 | 2006 Ford Explorer Sport Trac

1 Answer

1986 olds 88 trans slipping


Transmission gear assembly and transmission needs inspection.Also check the transmission fluid level.Also is the fluid getting leaked or its low.

There are few very helpful links with solutions to troubleshoot these problem.

========
I suggest you to refer these links.

Click the link below:-----

2000 Toyota Camry: Transmission slipping and Stuck up? http://whatisbyme.blogspot.in/2012/05/2000-toyota-camry-transmission-slipping.html
-----------
Transmission Slips out of 2nd gear? http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

----------
Car engine Overheats and transmission starts slipping? http://schematicsdiagram.blogspot.com/2011/12/car-engine-overheats-and-transmission.html

-------------
2006 Ford Explorer: Engine Vibrates and gears slipping? http://whatisbyme.blogspot.in/2012/06/2006ford-explorer-engine-vibrates-and.html

---------------
Clutch slipping problem? http://howtobyme.blogspot.in/2012/03/clutch-slipping-problem.html

----------
Dodge Anti slip System is not operating? http://whatisbyme.blogspot.in/2012/07/dodge-anti-slip-system-is-not-operating.html

----------
OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

------------
Transmission fluid leaks near radiator on ford windstar?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

-------------
Ford Windstar transmission fluid leaking? http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-----------

These details will help.
Thanks.

Nov 24, 2012 | Cars & Trucks

1 Answer

Trans starting slipping after modulator replaced


Transmission gear assembly and transmission needs inspection. Also check the transmission fluid level. Also is the fluid getting leaked or its low.


There are few very helpful links with solutions to troubleshoot these problem.


========

I suggest you to refer these links.


Click the link below:-----


2000 Toyota Camry: Transmission slipping and Stuck up? http://whatisbyme.blogspot.in/2012/05/2000-toyota-camry-transmission-slipping.html

-----------
Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

----------
Car engine Overheats and transmission starts slipping?

http://schematicsdiagram.blogspot.com/2011/12/car-engine-overheats-and-transmission.html

-------------
2006 Ford Explorer: Engine Vibrates and gears slipping?

http://whatisbyme.blogspot.in/2012/06/2006ford-explorer-engine-vibrates-and.html

---------------
Clutch slipping problem?

http://howtobyme.blogspot.in/2012/03/clutch-slipping-problem.html

----------
Dodge Anti slip System is not operating?

http://whatisbyme.blogspot.in/2012/07/dodge-anti-slip-system-is-not-operating.html

----------
OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

------------
Transmission fluid leaks near radiator on ford windstar?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

-------------
Ford Windstar transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-----------


These details will help.

Thanks.

Nov 24, 2012 | 1986 Oldsmobile Delta 88

1 Answer

How do you add transmission fluid to a 2006 ford explorer eddie bauer


the fill hole is on top of the transmission. you will need a long rubber hose

Nov 17, 2012 | 2006 Ford Explorer

1 Answer

2006 Ford Explorer Automatic Transmission requires servicing at 60,000 miles. Does it require Mercon or Mercon V fluid and does it require 11 or 13 quarts?


Every Ford after 2001 requries mercon V and alldata states 11 but i would put 10.5 then bring the car up to operating temp and fill as needed

May 18, 2011 | 2006 Ford Explorer

1 Answer

How do you add transmission fluid to a 06 Ford Explorer that does not have a dip stick?


With truck on level ground and at normal running temp, climb under it unscrew filler screw and fluid should just trickle out.

Jan 02, 2011 | 2006 Ford Explorer

2 Answers

How do you change the transmission fluid in a 2007 ford explorer? I've already drained it, can't take it to a dealer now.


if you drained it then you need to look in your owner's manual for the right amount of fluid that your transmission takes then put fluid through the transmission fluid dipstick. If you got any question plz feel free. Good luck

Dec 29, 2010 | 2007 Ford Explorer Eddie Bauer

2 Answers

My 1994 Ford Explorer Limited 4X4 had a really bad leak after driving it and all the transmission fluid drained out when i put the vehicle in gear. Is that the front seal? maybe the water pump?


If your having to add transmission fluid and not coolant, then the water pump is ok, fill with transmission fluid look under truck, if fluid is coming out of between engine and transmission housing, then bad front transmission seal.

Nov 11, 2010 | 1994 Ford Explorer Limited

1 Answer

Transmition oil change fill plug


most transmissions don't have drain plugs any more. Have to drop oil pan to drain fluid.
Some don't have dip sticks either.

Dec 26, 2009 | 2006 Ford Explorer

3 Answers

Transmission slips bad on 2006 ford explorer


u will need to get a new one n i could help u out if my dad stills have one from my old ones its still in good shap

Sep 21, 2009 | 2006 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...