Question about 2000 Chrysler 300M

1 Answer

How to replace window motor on chysler 300m - 2000 Chrysler 300M

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 343 Answers

I will step you through this completely. Now are you sure it is the motor and not the switches? I will elaborate on any part of process if needed, just reply.Having some one around would be a plus, but not necessary. Here you go, these are the basic steps:
1.remove door panel: scews somewhere near arm rest pull possibly a couple along sides/bottom, factory clips can be popped by using thin,stiff flat tool (narrow putty knife),check release handle trim or handle itself. Some vehicles switches pop out not ,others undo harness after you start to pull panel away. Lift door panel up and toward you
2.Remove plastic water sheid and note how it probably tucks in at bottom
3.Window regulator assembly has three or four bolts in door frame, mark well as position affects alignment (paint works well), make sure window is up most motors of this type have a slot for screw driver in end of shaft or another way to manually raise/ lower. if you can get enough access now your very lucky, otherwise just hang in there.
4.Undo wires to motor.Remove all bolts in regulator, careful not to let window fall. Now you may have to retract assembly back to down position to slide the rollers or guide out of the track attached to the glass and then slide out thru the largest opening in door frame.
5. unbolt motor from regulator assembly, bolt in new, lubricate mechanism test new motor for operation before installing and all switches
6. Reverse the procedures and your done.check alignment/ operation before closing.... silicon sealant adheres the plastic well, duct tape rips/tears, broken clips from auto parts store in "help"section, Napa, etc
7. Forgot to say check and lubricate lock/handle linkages while you're in there and lithium or silicon on plastic window regulator pieces
Please let me know how it went and if my directions were clear enough....MK

Posted on Oct 04, 2010

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: how to replace the map lights? Chysler 300m

There is a screw in the plastic towards the front end of the overhead console towards the windshield,remove that.Then use a trim tool or a flat screwdriver and gently pry down the console from the back end.Your all set, change the bulbs and put it back together.

Posted on Aug 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My autostick chysler 300M will not manually downshift


That may be a safety feature, Ron - it SHOULD refuse to downshift if downshifting would cause excessively high engine RPMs.

Aug 13, 2014 | 2000 Chrysler 300M

1 Answer

How to find the rear back botls for sturts on the chysler 300m 1999


Possibly under the trunk floor/ carpeting . Are there humps on either side of the rear of the trunk? look under the carpeting.

Mar 21, 2014 | Chrysler 300M Cars & Trucks

1 Answer

My a/c switch is running on high all the time, will not cut off . 1999 chysler 300


Check your blower motor relay... The most likely cause of an issue with fan speed.

Jun 20, 2012 | 1999 Chrysler 300M

1 Answer

Where is the fuel filter in a 300m chysler


The fuel filter is not replaced except when the in tank electric fuel pump is replaced, it all comes as one piece. There is no "in line" filter. This is true of all late model Chrysler cars and trucks and vans.

Jan 18, 2012 | 2000 Chrysler 300M

1 Answer

I have a 1999 chrysler 300m. i run the diagnostic on the automatic temp. controll and get code 36 got that code to clear and now it shows code 23 can anyone tell what this is and who to fix it thanks


Hi,

Chysler HVAC code 23 = Front Mode (Blend) Door - Range too Large.

Possible causes:

- Actuator circuit test faults preset
- Overcurrent faults present
- Mode door or A/C Heater housing components warped, worn, damaged or broken.
- Mode door actuator
- A/C Heater Control (ATC)

Nov 08, 2011 | 1999 Chrysler 300M

1 Answer

How to change a 2000 chysler 300m headlight


See my note to Thrasher. Says it all.

Mar 01, 2011 | 2000 Chrysler 300M

1 Answer

Does a chysler 300M has a access panel?


a fuse panel inside of car below dash or down by brake pedal

Dec 10, 2010 | 1999 Chrysler 300M

1 Answer

How to replace the map lights? Chysler 300m year 2000


There is a screw in the plastic towards the front end of the overhead console towards the windshield,remove that.Then use a trim tool or a flat screwdriver and gently pry down the console from the back end.Your all set, change the bulbs and put it back together.

Dec 03, 2009 | 2000 Chrysler 300M

Not finding what you are looking for?
2000 Chrysler 300M Logo

1,022 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...