Question about 2007 Jeep Commander Rocky Mountain

Open Question

I have a 2008 Jeep Commander, and the horn blows for no reason. Is there a reason why this is occouring?

Posted by on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75051 Answers

SOURCE: commander horn fuse

don't have a owners manual? go here.

http://www.jeep.com/en/owners/manuals/

the fuse u want is in the underhood fuse box
Fuse #16 a 20 Amp Yellow fuse
Horn

Posted on Jun 03, 2010

  • 58 Answers

SOURCE: 2008 Jeep Commander with 5.8l Hemi problems with instrument panel

Have shop run an OHM test on your transmission sensors -- then have them replaced and rerun the OHM test. -- it's more than likely an input speed sensor that is not working properly and telling the jeep to go into "limp mode" hence your speed isn't changing but it can't read the actual speed.

Posted on Jun 22, 2010

  • 1 Answer

SOURCE: I have a 2006 Jeep Commander and the horn blows

I just had the same problem the horn would blow for 30 seconds every 3 minutes. The dealership just told me I need a new horn pad and that it was not covered under the "bumper to bumper" warranty. He also said it would be $460 and be at least 4 days.

Posted on Nov 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I reset the Anti Theft system on a 2008 Jeep Commander.


why not tell the problem first
then ask for help. and not guess on the solution
you reset it every time you key on.!
what is wrong?, for sure we'd never guess.
RKE key fob dead. lost one?
doors locks fail?
alarms go off for no reasons?
engine only runs 3 seconds with the SKIM lamp glowing>?
what/?
it is a very complex car, do say what's up doc, first.

Jan 23, 2017 | 2008 Jeep Commander

1 Answer

My 2008 jeep commander is cranking but when u drive it an cut it off it won't crank unless you charge the battery the battery is good an i had my alternater tested it's good I put a new battery in it...


You may have fried the fuseable link that comes off of the positive battery terminal. Disconnect it from the post as well as the negative cable from the battery. Check the continuity along the length of the cable anywhere thrre is no continuity the link has blow, replace it or the entire cable.

Aug 07, 2014 | 2008 Jeep Commander

1 Answer

WHERE IS THE #7 CYLANDER LOCATED ON 2008 JEEP COMMANDER LIMITED


google firing order diagram for 5.7 hemi
than google jeep comander forums to get a solution to the misfire code

Feb 05, 2013 | 2008 Jeep Commander 5.7

1 Answer

We have a 2008 jeep commander, check engine light is on. ran a diagnostic because of engine noise, it said cylinder 4 misfire. so far we replaced the or, sparkplug, and coil for cylinder 4, it still h


google jeep commander forums join one and post youre question there if no luck than google grand cherokee forums and try there it is basicially the same vehicle

Feb 05, 2013 | 2008 Jeep Commander

1 Answer

I have a 2006 Jeep Commander and the horn blows for no reason. It is as if the alarm is going off.


I just had the same problem the horn would blow for 30 seconds every 3 minutes. The dealership just told me I need a new horn pad and that it was not covered under the "bumper to bumper" warranty. He also said it would be $460 and be at least 4 days.

Oct 30, 2010 | 2007 Jeep Commander Rocky Mountain

1 Answer

Commander horn fuse


don't have a owners manual? go here.

http://www.jeep.com/en/owners/manuals/

the fuse u want is in the underhood fuse box
Fuse #16 a 20 Amp Yellow fuse
Horn

Jun 03, 2010 | 2007 Jeep Commander Rocky Mountain

1 Answer

Hello, i want to know how can i read the engine number of my jeep commander 2008.


located betwween sump at bottom and 1st engine block.below dip-stick g/luck

Jul 16, 2009 | 2008 Jeep Commander

Not finding what you are looking for?
2007 Jeep Commander Rocky Mountain Logo

Related Topics:

102 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...