Question about 2005 Subaru Outback

Open Question

How to set the subaru drive side power window auto up. when i use auto up when the window reach top and will come down to half automic

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

shadtremonky
  • 353 Answers

SOURCE: electric windows bounce back down when the y reach the top

if it just fell, it came out of its track.

if it went down slowly it must have a intrapment feature, that makes the window reverse when something it in the way.
if this is it ,the window will need to be adjusted

Posted on Jun 24, 2009

  • 20 Answers

SOURCE: subaru impreza/ manual side window stuck

You are having a problem with the "window regulator" remove the door panel, see if the window regulator bolts fell out. they are usually in between the plastic door covering and the door or inside the door on the bottom. they are four bolts that a 10 mm wrench fit, they are short about 1/4 of an inch long, if they fell out you can simply put them back in (I recommend using lock tite on them) These bolts are located in the middle of the door a little towards the front. If your bolts are still in place you probably need a window regulator.

Posted on Aug 28, 2009

  • 1 Answer

SOURCE: Window on auto touch goes up then half way down by itself

Sounds like the pinch system needs to be reset. instructions are in the manuale takes about 5 mins

Posted on Oct 24, 2009

  • 1 Answer

SOURCE: the drivers side window auto up/down quit

1. Start the car and leave it idle.
2. Hold the window button down all the way, until the window is completely down.
3. Let go and push it down again and hold the window button for 2 to 3 seconds then let go. (You should be able to hear or feel (very faintly) the motor/sensor reset.)
4. Pull up on the window button and roll the window up until it is all the way up, when it is up let go.
5. Pull the button up again for 2 to 3 seconds. (You should be able to hear or feel (very faintly) the motor/sensor reset.)

Posted on Nov 04, 2009

Testimonial: "Outstanding!"

  • 1 Answer

SOURCE: 2004 Saab 9-3 Window reset

I had the problem of the drivers window rolling back down. This was fixed by removing the electrical connector located behind the door hinge. It looks like an oblong block. You have to prise the top ribbed part right up then pull the block out. Leave out for about 1 minute. Replace it

Posted on Sep 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Window wont go all the way up


one of 2 problems , either slide not inline anymore , or cable ready to break

Mar 25, 2013 | Cars & Trucks

1 Answer

S auto window goes up then half way down on my 2006 altima.


It could be something wrong with the switch but sometimes when I triple click my unlock button on my wireless chain they let down half way

Jan 29, 2013 | 2006 Nissan Altima 2.5

1 Answer

Colorado power window


Try & spray WD40 or a similar lube into the window channel on both ends of the glass, It may have just needed lubrication. It also may be a tired motor or faulty switch.

Jan 10, 2012 | Cars & Trucks

1 Answer

I changed my oil last night with my boy friend who does frequent oil changes. Afterwords, my transmission started shifting extremely hard and late. Please help. I do not believe he drained the tranny...


e: subaru legacy transmission dipstick Transmission dip stick is behind the engine in front of driver side firewall. Move a few hoses out of the way, look down and you'll see it has a yellow top.
Other side (passenger) lower down yet, again move a few hoses aside, yellow top handle, you'll find the shorter differential dip stick.
In either case, if your gaze reaches the ground, you've gone too far.

May 21, 2011 | 2000 Subaru Legacy

1 Answer

Have abroken power steering belt on 2003 Subaru Forester need to replace it, how do you do it?


Removal & Installation
  1. Remove the accessory drive belt cover, if equipped.
  2. Loosen the lock bolt (bottom) of the front belt tensioner.
  3. Loosen the slider bolt (top) of the front belt tensioner.
  4. Remove the front side belt.
  5. Loosen the lock bolt (bottom) of the rear belt tensioner.
  6. Loosen the slider bolt (top) of the rear belt tensioner.
  7. Remove the rear side belt.
To install:

NOTE Wipe off any oil or water on the belt and pulley.

  1. Install the rear side belt, then tighten the slider bolt until the belt reaches the specified tension. Please refer to the following topic: “Accessory Drive Belts”, “Adjustment.”
  2. Tighten the lock nut of the rear belt tensioner to 18 ft. lbs. (25 Nm).
  3. Install the front side belt, then tighten the slider bolt until the belt reaches the specified tension. Please refer to the following topic: “Accessory Drive Belts”, “Adjustment.”
  4. Tighten the lock nut of the front belt tensioner to 17 ft. lbs. (23 Nm).
  5. Install the accessory drive belt covers.

May 24, 2010 | 2003 Subaru Forester

2 Answers

Window goes up then down half way on drivers side


I know this answer is going to sound strange but I had exactly the same problem on a 2007 93 convertible. When you closed the window it would reach the top and then go back down half way. You could edge the window up slowly but as soon as it reached the top it opened again. This was solved by taking to a dealer and upgrading the software for the windows under the manufacturers warranty. There is a firmware update that adjusts the sensitivity for the sensors and solved the problem instantly and i've had no problems for over two months.
Hope this helps.
James Pomeroy MBCS www.BISAS.co.uk

May 28, 2009 | 2004 Saab 9-3

1 Answer

Window goes up then comes down by it self


some cars do this when a door is open by its self. im not sure if your does this. usually it does it to protect the window if there is no frame on the door. when the door is closed it usually closes its self. but usually its on the newer newer cars. hmmm

thats all i can help with. cause i dont have much else to work with. more infor on the exact situation may help?

Michael

Feb 09, 2009 | 2001 Subaru Legacy

1 Answer

Toyota window one touch


The switch may need "reinitialized". Turn the key on. Press & hold the one-touch in the down position, after the window lowers, keep holding the switch down for 10 seconds. Then, pull up on the switch and hold it 10 seconds after the window reaches the top. This is the renitialize proceedue.
If this does not work, try lubricating the window run rubbers with silicone spray.

Sep 13, 2008 | 2002 Toyota Land Cruiser

Not finding what you are looking for?
2005 Subaru Outback Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...