Question about Toyota RAV4

2 Answers

Toyota RAV4, 2004, engine 1cd-ftv, cold starting ok, when hot does not start, only when pushed

Posted by on

  • Dick Yskes Oct 04, 2010

    tried your solution, starter and battery ok. did not work.

  • Dick Yskes Oct 04, 2010

    the above solution allready tried. Did not work, battery and starter ok

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,865 Answers

Hello. Over time, the ignition switch wears and won't pass enough current to operate the starter solenoid. I added a 12V relay, available at Radio Shack and other places. Remove the small wire that runs from the switch to the solenoid, and connect it to one side of the relay coil. Connect the other side of the relay coil to ground. Now, find a 12 volt source (I came off the big terminal of the starter with a 14 ga. wire), and hook it to one of the contacts that moves when the solenoid is energized. Run a wire from the contact that the movable contact hits when the solenoid is energized, and connect it to the small terminal on the starter that you removed the original switch wire from. Check all of your connections, and turn the key. Should start every time, cold or hot. Good luck.

Posted on Oct 04, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,299 Answers

The engine has to turn over at 400 rpm's during cranking to start. When the engine is warm, it takes more amperage to turn the engine over. Usually when an engine won't start when it is warm, then it is either the battery or the starter. The next time it will not start when it is warm, you can try to jump start it. If jump starting doesn't work, then more than likely it is your starter.

Posted on Oct 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On a Toyota dyna 14b cylinder head,what sizes are inlet and outlet valves take?


hi this is a 2kd-ftv engine the clearance will be for exhaust 0.35mm, 0.45mm cold, for inlet it is 0.20mm , 0.30mm cold

Dec 18, 2016 | Toyota Cars & Trucks

1 Answer

How do i fix rav4 2002 refuse to start when hot but very ok when engine is cold


keep it from getting HOT Which might mean water pump , thermostat, fans not working properly , and the list goes on .

May 20, 2015 | 2002 Toyota RAV4

1 Answer

How digits do 2004 toyota corolla have


all engine have this number
all engines in a different spot or different by COUNTRY (LAWS)
so, no engine stated, nor country, FAIL.
the FSM covers this on page 1
factory service manual.
if luckly , alldata.com has this.
log in and read;.

Gen 9 car
E120? or 130?>
now the line up ,just gen 9 , engine line up ( showing many there are)

1.4L I4 4ZZ-FE
1.5L I4 1NZ-FE
1.6L I4 3NZ-FE
1.6L I4 1ZR-FE
1.6L I4 3ZZ-FE
1.8L I4 1ZZ-FE
1.8L I4 2ZZ-GE
1.4L I4 1ND-TV D-4D diesel
2.0L I4 1CD-FTV D-4D diesel

posted 100s of times, not one person
ever disclosed, country of engine
nor opened hood, looked up , saw , EPA sticker and engine size in plain view. not one.
cars really are not simple , and 10x that on a world scale.
sorry

Jan 13, 2015 | 2004 Toyota Corolla

1 Answer

How is the timing set on a 2006 Toyota Corolla accent


cam or spark? what engine and what country?
why not tell job first, then ask a question
if you had read the FSM book , it be done now.
factory service manual
or alldata.com
GEN 10/ E140? guess 2, Has this line up

NO ENGINE Stated, impossible TO GUESS. WORLD WIDE.

1.3 L I4 2NZ-FE
1.4 L I4 4ZZ-FE
1.5 L I4 1NZ-FE
1.6 L I4 3ZZ-FE
1.6 L I4 1ZR-FE
1.8 L I4 1ZZ-FE
1.8 L I4 2ZR-FE
2.0 L I4 3ZR-FE
2.4 L I4 2AZ-FE
1.4 L I4 1ND-TV D-4D diesel
2.0 L I4 1CD-FTV D-4D diesel

Jan 08, 2015 | Toyota Cars & Trucks

1 Answer

2010toyatohiace can you tell me where is the ignition mogul stuvated


010 Toyota what>? hi-ace? ok,
mogul stuvated.
my guess is the engine Ignition coils.
no engine type stated,cars have engine opens,
we open the hood and go ahh, its and xxxx engine.
see this
http://en.wikipedia.org/wiki/Toyota_HiAce

see all them engines.
yours has one engine, pick one.
here is the list. all work different , all have unique parts and LOCATIONS. (where)

2.0 L 1TR-FE I4
2.7 L 2TR-FE I4 149hp
2.5 L 2KD-FTV I4 101hp
3.0 L 1KD-FTV I4 170hp
3.0 L 5L-E I4 91hp

Jun 18, 2014 | 2007 Toyota Hi-Ace 220

1 Answer

Can anyone please tell me where the cam sensor and crankshaft sensor are located on a 2002 RAV4 2.0 D4D...116BHP Problem is wont start when engine is hot.


this a diesel. (our is 2.4Lgas(petrol)
cold starts fine,runs perfect cold RIGHT?
common rail system.

the PCM will tell you when those are bad, cranking for 5sec or running.
does your run,. ? if yes for get them. and scan engine PCM.
some sensor takes major work to reach.

get the FSM on that car. y
so get the FSM for your car, your engine and your country
The DI chapter covers this. read that yet? diagnosis?
did you use the scan tool an see what up's up or not ?


your engine really is.
1CD-FTV I4 (diesel)
that is the correct name, so study only that)

no start hot.
its too much fuel or tool little?
to little?
did you try test fuel to see if loss of fuel is the problem?
on diesel it's poor compression
or lost fuel , hot starts.
easy huh , no spark to check , there is no spark
some diesels have 1 sensor for injector timing.
if flooding , you get black smoke out the tail pipe, so id suspect
you'd have noticed that and did not see it.
test fuel, tests.
if this fails, a full hot compression test. its not the cam belt slippped
if runs ok cold,

i bet the injectors are shut down
the PCM tell you why, so let it.
SCAN it. after 5 seconds cranked.
almost all PCM report 1 bad pulse of 10 in all speed sensors.
(CKP or CMP )




Feb 24, 2014 | 2002 Toyota RAV4

1 Answer

Engine cold can not start


runs hot,ok, restarts hot ok
just dont start , cold, but it must because how do you get to 2hours?
from hot?
my guess, is it sometimes does start cold.
ever tune it up at the critical 60k mile service, ever, this decade?
that covers 99% bad cold starts. so , we do that first.
diagnosis is like 10x a tune up, so........ $$$$$

Feb 02, 2014 | 1994 Toyota Corolla

1 Answer

Check timin cheing luck


cam or spark
tell the tool used, or where you saw such bad timing.
what 03 engine option, there are many engines used.
displacement and cyl . counts.
2.0 L 1AZ-FE I4 (petrol)
2.0 L 1CD-FTV I4 (diesel)
2.4 L 2AZ-FE I4 (petrol) are you messing with the cam?
say so.....



Dec 26, 2013 | 2003 Toyota RAV4

1 Answer

Over heating, not thermostat. Lower hose not hot but upper hose is. How does one check the fwn clutch or the radiator to see it they are working properly?


You can check the fan clutch by feel. When your engine is cold (and off) try to turn the fan with your hand. Warm the engine to normal operating temp. and try to spin the fan by hand again. If you notice a lot more resistance when the motor is hot then it is OK. You can also listen to the fan when you start a cold motor. At start up you should easily hear the fan pushing air for about the first 30-60 seconds. You shoul take the radiator in for a pressure test. Hope this helps.

Jul 05, 2009 | 1988 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

552 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...