Question about Peugeot 405

1 Answer

Engine wont start and ignition makes a clicking noise.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Peugeot Master
  • 7,772 Answers

Please see my tip at http://www.fixya.com/cars/r6222268-engine_doesnt_crank_turn_over . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

Posted on Oct 04, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car wont start but lights work


Please provide with more detail. Does it make a click sound when turning the ignition? Does it crank?
Have you tried to jump the battery with jumping cable or tried it on a know good batteries?
- If the car does make a cranking noised then the starter is good but weak battery.
- If there is no noise or clicking, then dead battery.
- If you can hear the clicking when turning the key to start, then check for battery GROUND.
- If battery were tested and it read 12.5 - 14.0 DCV. Then your starter are bad.

There also other thing to check like security alarm system with ignition switch kill... But most common problems with fail to start are mention above.

Jul 07, 2014 | 2005 Hyundai Elantra

1 Answer

Oldsmobile alero 2001 making clicking noise wont stop


There can be a LOT of reasons for this. I assume you've been all through the car and found no loose objects, so the next best suspects are loose mechanical or electrical connections. If the noise is deep inside the dashboard, or under the car, you can TRY to locate and fix it, but should probably go to the dealer. If the noise is from the engine area, maybe it's an ignition wire arc-ing out (does the motor idle any rougher than it used to?). You can check by pulling into a garage or other dark place, opening the hood, and looking for a spark-light that makes the click. A handy person can fix this by installing a new wire set, maybe $50 or less. As long as THAT's happening, you might as well change the plugs, distributor, rotor and any other ignition bits requiring regular maintenance.

Apr 21, 2014 | 2001 Oldsmobile Alero

1 Answer

Santa fe 2007 wont start makes a single click noise


May be ab bad starter solenoid, or corroded/loose connection at starter, or (ground). Could also be a bad ignition switch. Start from the load; the starter. Test for 12V at starter, OK. Connect short wire from starter and touch sylenoid connection..

Nov 09, 2013 | 2003 Hyundai Santa Fe

1 Answer

Engine wont rotate when attempting to start


Most of the time is a bad connection from battery to starter.Clean and tighten battery posts...Check wire harness to starter.Does it make any noise at all when trying to start...A clicking sound? Could be a starter relay fuse..Could be a bad ignition switch...Please give more feed back...Any sound at all?

Aug 22, 2013 | 2007 Chevrolet Cobalt Coupe

2 Answers

Car makes a ticking noise & wont start when i try to start it, what might it be?


Possible that the sound can be that the fuel pump is starting up to pump but cannot be observed as a fault. So unless you check for the fuel pressure and the ignition spark the engine's failure to start cannot be confirmed.Also you need to make sure there is no problem with the fuel, fuel filter.Check for error codes that might help to confirm. Finally the battery must be good and should be cranking well with enough voltage for the ignition circuit.

Dec 22, 2011 | Honda Accord Cars & Trucks

1 Answer

I have a 2000 chey tracker and there is no spark going to the spark plugs. the engine cranks over just fine.. but wont start. the spark plugs use a coil pack the ignites it but they dont seem or look bad.....


check by listening to see if your starter is clicking over the engine and if not then you might have to replace the starter. My starter went out on me and did not make a clicking noise that turned over the engine which told me the same problem that your having too. Ok if the engine cranks over just fine but wont start is a statement that is not true whatsoever so please explain which one is it thanks.

Jun 04, 2011 | 2000 Chevrolet Tracker

1 Answer

How to tell if your starter is bad


WHEN STARTER GOING BAD.SOME TIMES YOU TURN IGNITION NO SOUND FROM STARTER.WHEN STARTER GO BAD IT WILL TURN ENGINE OVER VERY SLOWLY LIKE YOU HAVING A WEAK BATTERY.BAD STARTER SOLENOID MAKE CLICKING NOISE ENGINE WONT CRANK.BAD STARTER WILL MAKE NOISEY GRINDING NOISE IF DRIVE PINION GEAR DAMAGED.

Aug 28, 2010 | 2006 Dodge Charger

1 Answer

98 chev blazer wont start or make any noises...


Listen for a click from under the steering column when you turn the key on. If you hear no electrical click then your ignition switch could be bad. If you hear an electrical click the you starter soleniod is bad.

Jul 13, 2009 | 1998 Chevrolet K1500

2 Answers

1994 lincoln wont start and does clicking noises


do you know ware the clicking noise is comming from? maybe relay? maybe bad sellinoid? the sellinoid is my guess.

Jan 02, 2009 | 1994 Lincoln Continental

2 Answers

Wont start


is the earth cable giving a good engine and body contact.does your starter have two terminals and if so are they the right way around?is the battery any good?Is the engine able to be turned over by hand Make sure you have agood 12v supply to the starter solenoid when cranking the engine An engine test probe/light would be of a lot of use for you to do that test

Oct 07, 2008 | 1993 Ford Escort 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...