Question about 1990 Mitsubishi Galant

Open Question

What's the standard carburetor primary & secondary jet numbers of galant 90 ss a/t? How do I know its the primary barrel? tnx. nasjo

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

86 toyota 4x4 22r boggs on primary side secondary side does fine


The carburetor may have dirt in the main jet, rebuild it.

Dec 20, 2016 | Toyota Cars & Trucks

2 Answers

Why four barrels do not open 65 4100 carb


The choke linkage is not properly hooked up or adjusted. The throttle linkage is not adjusted properly or there isn't enough vacuum. The choke linkage has a tab that prevents the 4 barrels from opening when the choke is engaged. There is a tab on the throttle linkage from the front 2 barrels that will engage the secondaries when they rotate past a certain point. Vacuum opens the top plates on the secondaries.

Sep 19, 2014 | 1965 Ford Mustang

1 Answer

86 ford 460 cu. in. Ford w/ Holly four barrle carborator secondary


On most models, the secondary barrels would only work if the primary are in wide open position, and even then the range of opening is small.
The engine should run past 3000 RPM on just the front barrels, so you may have something else going on.

Aug 23, 2012 | Cars & Trucks

1 Answer

Acceleration is too slow from 0 to 25 mph


i would assume that your engine still runs on carburetor. have your primary jets(in the carb) replaced. normal carb primary/secondary jetting for 1.6cc engine is 105/135. primary jets basically is responsible to acceleration, secondary jets are for speeding.

Aug 06, 2011 | 1987 Toyota 4Runner

1 Answer

1991 Cutlas Calias with 110,000 miles on it. When it gets up to high rpm's it falls on its face. Sometimes it will stall. If you drive slow its ok. When you put it to the floor and heads up to high...


is your car still running on carburetor engine? if yes, have your carburetor cleaned. while cleaning, replace the secondary jet in your carb. the normal primary/secondary jet for a 1.6cc engine is 105/135.

Aug 05, 2011 | 1991 Oldsmobile Cutlass Calais

1 Answer

Have a 90 corsica...fuel pump is fine...****** is fine but wont go over 35 mph...acts like its not getting enough fuel...please help


1st, try to ask a mechanic to check if the timing of your engine is correct. the timing might be a little "delayed" so the engine cannot work properly on high speeds.

is your engine still uses carburetor? if yes, replace the primary and secondary jetting of your carburetor. normally, the standard primary/secondary jets for a 1.6cc engine is 105/135.

if your engine already works on direct fuel injector, replace injectors with bigger size. go up 1 size at a time.

i believe the culprit here is the timing in your engine.

Aug 05, 2011 | 1991 Chevrolet Corsica

1 Answer

I have a 1982 Pontiac Trans Am, everything is


What type and model Carb is it? You may have vacuum operated secondaries.

May 09, 2010 | Cars & Trucks

2 Answers

I have a 1982 Pontiac Trans Am, everything is basically stock on the car besides my K&N filter, magnaflow exhaust, and edelbrock valve covers. It is equipped with a 4 barrel carb. My problem is that...


That carburator most likely has vacuum secondaries, meaning that the secondaries won't open until there is enough vacuum for them to operate, usually mid or full throttle. You can try to operate them by hand to confirm that the shaft isn't stuck.

Mar 17, 2010 | 1998 Pontiac Trans

1 Answer

2001 ford mustang 3.8, standard. no secondary


not sure on this because no mustangs in spain but from the symptons described ??had similar with escort and focuses and the only soloution was the dealer ,its the factory immobilisor playing up now i know how to by pàss it ,but not every customer wants it by passed so then its dealer job with dealer prices and i just smile when they tell me how much they paid

Sep 08, 2009 | 2001 Ford Mustang

Not finding what you are looking for?
1990 Mitsubishi Galant Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...