Question about 2009 Ford F-150

Open Question

The fan on the climate control will not adjust the speed of the air flow up or down. It appears to be stuck on one speed. I have a 2010 supercrew lariat F150.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
jim9813
  • 124 Answers

SOURCE: 2004 Supercrew Lariat no driver power seat or pedal adjust

Maybe, you can diag yourself with a test light and an ohmmeter. These will cost less at sears than having a dealer diag it. Check fuse 109 in the cab, that's the fuse for the driver's seat module. If that fuse is ok, then check power at the module. It's a little black box under the driver's seat with i think 3 connectors. Back probe the dark green wire at the connector with a test light, you should have power, even with the key off. If not, repair the circuit. Clamp the test light to battery positive and back probe the black wire, if the light does not light, repair that ground circuit. Test the memory set switch by measuring with an ohmmeter points 7 and 2, 7 and 6, 7 and 5 resistance should be less than 5 ohms, if not replace it. If all these tests pass, disconnect the connectors from the module and give 12v to the red and white wire. If the seat moves, have the module replaced at the dealer, it will have to be programmed.

Posted on Aug 10, 2009

Ad
  • 59 Answers

SOURCE: getting p 1502 diagnostic code which speed sensor

Defective wheel speed sensor.

Posted on Oct 09, 2009

  • 3 Answers

SOURCE: program a new fob to my 2002 f150 supercrew lariat

if it is a ford remote or ford factory alarm remote cycle the key from off to run(usually 8 times) untill you hear door locks activate. at this exact time key needs to be in the on position.touch unlock or lock on all remotes being programmed and make sure door locks respond to remotes. then turn key off ending programming mode.then try your fobs they should work

Posted on Nov 06, 2009

leedavidian
  • 1420 Answers

SOURCE: how do you adjust the emergency brakes on a 2001

If you have disc brakes, there is no adjustment and the emergency/parking brake as no effect on pedal travel. The emergency/parking brake uses regular drum type shoes working in a small drum inside the rotor and is independant of the service brakes.

Posted on Dec 24, 2009

  • 5522 Answers

SOURCE: Off light is lit on backup sensor button in dash

Push on the button and see if the light goes out. It can be a simple off-on switch.

If that does not work the owners manual will have info on using your MENU function in your instrument cluster. When you get into the correct screen there will be listings of HORN alert with the remote, and AUTOlock for your doors. The backup function is just another item to select. Most likely someone was looking to reset the oil warning interval and accidently reprogrammed the menu.

Posted on Jan 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The heat only blows warm air on driver side it's always cold on passenger side. it doesn't have dual climate control.


It appears the control door is not opening. It may be stuck, or the vacuum is disconnected. It may also have a blockage in there preventing the door from opening.

Feb 15, 2016 | 2010 Dodge Journey SXT

1 Answer

My heater quit working but makes a sound like it's trying to blow. What could be my problem?


the heater works from hot coolant flowing through it so if it stopped working but was working recently , the problem will be in the heater control tap not turning on ( control module )
the blower works of electrical and trying to blow air indicates a problem in the fan speed control ( again a control module module)
if you have a climate control system in the car It may be the climate control module that is faulty as it controls both

Dec 16, 2015 | Cars & Trucks

1 Answer

No air flow


With the engine running do you have vacuum to the vacuum control switch in the heater control?

Apr 16, 2014 | 1994 Oldsmobile Ninety Eight Regency

1 Answer

Replace climate control panel lights 05


take out the control box, check linkage and voltage both before and after the switch if you have voltage before the switch and not after then the switch is bad and needs to be replaced

Dec 11, 2013 | Volkswagen Jetta Cars & Trucks

1 Answer

1998 dodge intrepid auto climate control. My heater will not turn off, and the fan is stuck on high, and also stuck on the cold temp. I replaced the climate control module and checked all the wiring....


the fan speed control not adjusting usually means the 'resister' is no longer working. Stuck on cold means the 'blend door actuator' is no longer functioning.

Dec 10, 2013 | 1998 Dodge Caravan

1 Answer

TOYOTA HIGHLANDER A/C CLIMATE CONTROL NOT FUNCTIONING


Based on the limited information provided, it would appear you have a bad climate control control board. This controls all heater/AC functions including climate control. If you're unable to change temperatures and/or fan speeds, the board is most likely bad and needs replacement.

Nov 16, 2011 | 2003 Toyota Highlander

2 Answers

I have a 1993 dakota, the climate control only blows though the window area. I cannot get air flow to move from the window to any other setting, floor or dash. Wondering what the issue may be and how to...


wakow4u, What you have to do is look for a vacuum line that comes from the engine and enters the passenger compartment through the firewall. This vacuum line controls the climate control. A small rubber hose that fits tightly will suffice as a good and quick repair. Good luck with this.

May 16, 2011 | 1993 Dodge Dakota

1 Answer

Heat and Air blower does not work


hey there cjwalker,,did you try the blower ressistor its located beside the heatermotor ,,it controlls the speed of the motor ..should be easy to remove ,,,either 2 screws or else it just clips in,,,,,

Apr 19, 2009 | 1999 Mercury Grand Marquis

2 Answers

Fan speed switch only works on #5


Call your local GMC Dealer and see if they have the climate control panel in stock. What happens is the circuit board on the back of the panel shorts out. The panel comes as an assembly and is very easy to replace. Don't go with a wrecking yard piece. I made that mistake once and it didn't work either. I got one from the Chevy dealer and it worked perfectly.

Aug 21, 2008 | 2002 GMC Sierra

Not finding what you are looking for?
2009 Ford F-150 Logo

Related Topics:

204 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...