At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
That engine was used in both models. As long as the model number, year of manufacture and generation of the engine match you should be able to do the swap. An obvious suggestion is to take a very good look at your engine and take photos, then go to look at the replacement engine. Compare the two. If your not sure take someone with you that knows engines.
Engine light, take it to an auto parts store & have it scanned for codes. Timing belt about every 30,000 mi. How, put a floor jack under the engine, take off front motor mount, take off the crank pulley & anything else thats in the way, take timing cover off, loosen tensioner, keep marks lined up & replace belt.
You will need to take the dashboard apart and then take all of the heating duct off. Unhook the 2 hoses to the engine cooling system in the engine bay. Then take the duct apart to take the heater core out . After all that just take everything back together. It,s a big job for sure!!!
Difficulty of replacing a blown head gasket is relative to the type of engine. There are several steps necessary, from taking off hoses to disconnecting engine belts. It may take several hours.
You have to undue all the pipes, and connections(be sure to label each pipe and wire to prevent further headaches upon re installation.) Drain all fluids out of engine and transmition. (might as well do a coolant flush through the entire coolant system while the engine is out through the pipes that lead to and from the radiator.)
Depending on if you have a 3sgte mr2 you may have to remove the turbo to make the engine easier to remove (you have to take the engine, and transmition out through the bottom of the car. remove rear axles if you can, may have to just remove them from the car's suspension and take them out with the engine and transmition
Thats what you have to do to remove the engine. to replace just the engine you will have to remove the transmition from the engine, buy a new engine-transmition seal, replace it, and bolt the old transmition to the new engine.
Repeat the removal steps in reverse to install the drive unit again
you can take of the ground of the battery of the car for 30 minutes and the computer will reset. if you drive around without reseting the computer might figure it out after 30 miles.
You're going to need an engine hoist to hold the engine up and use a transmission jack to lower the transmission. This is hard to do, because the engine hoist's legs roll underneath the car, blocking access to dropping the transmission. It is easiest, to me, to just pull the engine and the transmission completely out of the car through the hood of the car as one unit. Separate the two while it's on the ground. Replace the clutch. Put the engine and transmission back together, and replace engine and transmission as one unit.
To pull everything out will take you one full day. Putting everything back usually takes two days. Note: take the radiator out as an un-headache precaution!
Many internal engine problems, such as a blown head gasket, cracked head or cracked piston, can be repaired without having to replace an entire engine.
Potential
While taking the time to replace an engine may seem labor-intensive and costly, it will add years to a vehicle's life and will save a car owner from the cost of having to buy a new car.
Benefits
Taking a car to a mechanic and replacing an engine with a used engine can cost between $1,000 to $2,000 for parts and labor.
Solution
Car owners interested in replacing their engines with new ones can expect to pay anywhere between $2,000 to $4,000.
Speculation
For those interested in doing the engine replacement themselves, purchasing specialized tools needed for the job is a cost to consider in addition to the price of a replacement engine.
×