Question about 1999 Buick LeSabre

1 Answer

Ho do you replace the rear transmission mount on a 1999 buick lasabre

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 343 Answers

Unbolt mount from transmission while supporting with jack. Jack up slightly. Unbolt old mount from cross member. Replace in reverse order, do final tightening with jack removed. A few vehicles require the cross member to be removed from frame to access the lower bolts/nuts.

Posted on Oct 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace engine mount on 2000 buick


Put car on jackstands so you can work under car. Put 2 inch thick 5": x 5" wood board on jack under oil pan. Jack up slightly. Unbolt broken mount & replace with new one.

Oct 22, 2013 | 2000 Buick LeSabre

1 Answer

Cant find mounting bolts to 1999 buick lesabre starter


the mounting bolts are at the rear of the starter and go upwards through the starter into the engine block.when looking at the starter solenoid were the wires are connected to the starter follow it towards the rear away from the wires towards the transmission.this is were you will find the mounting bolts at the bottom of the starter(closest to the ground).they are 9/16(15mm) bolt heads.

Jun 10, 2011 | 1999 Buick LeSabre

1 Answer

Why transmission mount broke at 43,000 and 58,000 miles on Buick LaSabre 2004 No Syptoms noticed just found by dealer. One driver, both highway and town miles equal


It all depends upon where you are driving your car. My motor mount went at around 50K miles, but I drive into and around NYC often, and that will be enough to take out the whole underside of any car, given the pot holes and the like.

-a.

Jul 13, 2010 | 2004 Buick LeSabre

1 Answer

I replaced the starter in a 1997 Buick Lasabre. It crank right up and drove for 1 day then wouldn't crank. When turning the ignition the dash lights flicker and I get the clicking noise. Thanks.


ho ho ho! bad battery earth or you left the joints loss have you looked under to see if its still a good tight fit? its a pre ingaged type it should still click but its not getting volts from your battery or its not earthing out to the motor

Oct 23, 2009 | 1997 Buick LeSabre

1 Answer

How to remove transmission from a 2000 Buick


jack the car as high as you can, then remove the driver side suspension and tie the brake caliper out of the way, remove the coolines and connectors and linkage from top and sides of trans, put a transmission jack (u can rent these) under the pan of the trans and loosen the trans mounts, then jack the trans up and pull it out, this is a bugger of a job with a lift so good luck

Oct 15, 2009 | 2000 Buick LeSabre

1 Answer

How to change tail light bulb on 1999 buick lasabre


Remove cover from rear of trunk to access nuts. Remove tailight all 4 nuts. Pull tailight out. You will see the bulb sockets behind the tail light assembly. Turn counter clockwise to remove socket. Install same way.

Jul 26, 2009 | 1999 Buick LeSabre

1 Answer

99 Buick lasabre


If you have a "load leveling " system, the actuator arm is either disconnected or the actuator itself is malfunctioning.

Jan 29, 2009 | 1999 Buick LeSabre

1 Answer

Where is crank sensor located on 1993 Buick LaSabre located?


Under hood, passenger side, lower engine area, rear of crankshaft pulley, mounted in timing cover

Jul 23, 2008 | 1990 Buick Riviera

Not finding what you are looking for?
1999 Buick LeSabre Logo

Related Topics:

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...