Question about Chrysler Voyager

1 Answer

Need to know where the water pump is on a 95 chrystlar voyager

Posted by on

  • yadayada
    yadayada Oct 03, 2010

    what engine do u have?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 5,332 Answers

What motor?

3.0 it is timing belt driven and located in the center of the passenger side of the engine under the timing cover.

3.3 and 3.8 liter it is located on the passenger side of the vehicle. you'll nee to jack up the passenger side, remove the tire, remove the splash shield, and then you'll be able to see it on the lower right of the engine. It will have the smooth pulley with four bolts holding it on. You can also follow the lower hose the the back of the water pump.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Posted on Oct 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

New fuel pump for 95 voyager still wont work. what am i doing wromg?


The 15A FUEL PUMP fuse could be open or the fuel pump relay could be defective.

Nov 07, 2016 | 1995 Plymouth Voyager

Tip

95-2001 plymouth voyager water pump


For all dodge minivans 94 to 2001 (and others) with 3.0 ltr V-6. You're driving on the freeway your temp gauge starting to go up. You get off the freeway. when the engine is cooled down you discover that the coolant in gone. You refill the radiator and look for a leak but can't find one. You check the oil but its not foamy, so no coolant there. If all seems to be operating normally, check under the vehicle when the engine is warmed up. There may be a slight coolant leak on the passenger side near the front tire .When the water pump on these engines typically coolant will leak out of the pump thru a "weep hole" located at the bottom of the pump. Most of the loss occurs while driving so your only indication may be that small drip of coolant. The water pump is powered by the camshaft timing belt and is located under the timing belt cover and can not be seen, however any coolant leak, no matter how small, in the area just to the rear of the crankshaft pulley is almost surely a failed water pump and must be addressed immediately

on Jan 06, 2010 | 2000 Plymouth Voyager

1 Answer

Water pump for a 3.0L Plymouth Voyager


go under your car and is on the right side of the crankshafth pulley.

Sep 10, 2012 | 1998 Plymouth Voyager

1 Answer

Slow Leak in Water Pump-1999 Plymouth Voyager


What's probably happening is the weep hole on the water pump is leaking water. The weep hole is a warning sign that the water pump needs replaced. You don't have any heat because the impeller in the water pump is no longer circulating water.

Apr 23, 2010 | 1999 Plymouth Voyager

1 Answer

Want to know if it is a timing belt or timing chain that is required for a 2002 chrysler voyager


It's a belt. Cost is about 800 to replace belt, water pump and front main seal. You'll want to have the water pump and front main seal done while they r in there, will save headache later. Timing belt runs the water pump so if 1 goes, then so does the other.

Feb 17, 2010 | 2002 Chrysler Voyager

1 Answer

I need to know how to change to water pump on my 2000 plymoth voyager mini van


Need to loosen bolts for the water pump pulley. Remove belt and then remove pulley. Should be 5 10mm bolts holding the pump on. Remove the bolts. Reinstall in reverse order. Refill with new coolant.

May 12, 2009 | 2000 Plymouth Voyager

1 Answer

94 Plymouth Voyager Water Pump


thw water pump stuff you need is here

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c15280215d73

The heater stuff is here

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c15280216054

Hope this helps! good luck!

Sep 15, 2008 | 1994 Plymouth Voyager

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

80668 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...