Question about Dodge Magnum

1 Answer

Transmission will not shift first gear at stop Code P2767 05 Dodge magnum

Posted by on

  • meulink Oct 03, 2010

    Thanks, set me in the right direction.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 14,036 Answers

CODE P2767 - TRANSMISSION INPUT SHAFT SPEED SENSOR TURBINE SHAFT SPEED TSS SENSOR B NO SIGNAL.POSSIBLE CAUSE SHORT IN WIRE CONNECTOR OR FAULTY TSS SENSOR OR TURBINE SPEED SHAFT SENSOR.

Posted on Oct 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My sxt 2005 magnum won't shift or reverse it will only move in low gear


if it is the one with the mercedes transmission,chyrsler calls NAG1,you brake switch is more than likely bad.It does more than show the lights.Also if you can acess shifter area stick and pencil easer end ,below shifter at base where shift points are wrote.And press a little level to move shifter.

Jan 22, 2014 | 2005 Dodge Magnum

1 Answer

Hey Todd I have a 2005 5.7 dodge magnum and it won't change gears as i speed up while driving also speedometer stopped working


EASY ONE.... Your VSS (Vehicle SPEED SENSOR) stopped working and it is this Sensor that gives the PCM/ECM the information to change gears. Once you change your VSS, and get it working, the Transmission will start working again...

I am Assuming that the Transmission stopped working at the same time the Speedometer did? Is that right?

If it is, then this is a easy fix. 1 bolt and one Wire Connector and DONE....

Apr 04, 2013 | 2006 Dodge Magnum

1 Answer

Dodge magnum transmission won't shift gears


This is what you should do.... PRAY that it is low on fluid. If not, then there are a few questions that I need to ask

a. When you Shift, does the handle go to each gear?
b. Can you feel the Detent on each gear?
c. If the Cable Broke... Easy Fix
d. If your car goes into each gear but does not move... MONEY $$$

To correctly answer your question, I need more information.. Is it not shifting gear when moving or Won't allow you to select gears?

Apr 04, 2013 | Dodge Cars & Trucks

1 Answer

My gear shift on my 2007 dodge magnum will not get out of park. Is there a way to temporarly fix it till i can get to a mechanic!?


The BTSI (Brake Transmission Shift Interlock) has a small spring retainer on the park safety. A small plastic tab breaks & releases the spring. This requires the shifter to be disassembled in order to be repaired.

If you are lucky, your brake interlock is the only problem. There is a bypass switch located beside the gear selector. Remove the small "cubby" bin located next to the gear shift by simply lifting up to remove. You will note a small access port and a pink button contained therein. Press the pink button to override the brake interlock.

If you still cannot shift into park, then the shifter must be removed for the spring repair. Even if yours is still under warranty, you will get another shifter that will eventually fail due to poor engineering

Sep 20, 2010 | 2007 Dodge Magnum SRT8 Wagon

2 Answers

My 2005 dodge magnum will not come out of park


I was having the same problem with my Firebird. make sure the brake pedal is fully compressed when trying to shift gears. if it still will not budge it may be caused by the transmission lock, which is an anti-theft mechanism. the solenoid in the mechanism may not be functioning correctly. when i had this problem i just removed the lock from the transmission.

Aug 30, 2010 | 2005 Dodge Magnum

2 Answers

1997 Dodge Ram 4x4 1500 transmission shifting problems.


good day, you may try replacing your automatic transmission fluid, a good run will be noticeable, hope this helps, have a nice day

Feb 08, 2010 | Dodge Ram 1500 Cars & Trucks

2 Answers

I have a 1994 dodge dakota V6 magnum SLT just replaced fuel pump, water pump, transmission line. I was noticing the transmission was running slugish from 1st to second gear, every time you make a complete...


there are pressure sensors inside your transmission which tell it when to shift and whether to shift up or down. i would bet it is has something to do with those. if you take it to a shop, its probably 150-200 to fix, but better than having to rebuild the transmission, which could be around 800. the shop can plug a reader in and drive it around the block and tell you if the sensors are out.

Oct 20, 2009 | 1994 Dodge Dakota Club Cab

1 Answer

I have a 2005 dodge magnum sxt that will not shift from park.it's lock in the park position.how do I fix this problem.


If this vehicle was equiped with the brake safety system, you have to have the brake depressed to change gears, then you will need to start by looking to see if somehow the brake sensor came loose. I assume this has a console shifter, remove enough of the console that you can visually see if the actuator is actually moving up when you pull the shift release in to move the shifter. If this is working and there is nothing under the vehicle in teh way of the shifting arm the transmission needs to be serviced.

Sep 09, 2009 | 2005 Dodge Magnum

9 Answers

1996 Dodge Ram Transmission shifting problem


I had the same problem with my 96 Ram 1500. I thought I was going to have to pull it out and get it rebuilt or just replace it. That was at 134,000Km it's now got 210,000 and shifting like a dream. What I did to solve the problem was this, as follows:
1. No lucas transmission Fix makes things worse.
2. Get your self a new transmission filter and gasket
3. Grab Gunk transmission medic 12oz
4. Grab 7 Liters of Valvoline ATF+4 transmission fluid (Made for chrysler transmissions)
5. Drop the trans pan and drain all the oil, clean pan and magnet
6. start truck for 5 seconds and the pump will pour out another 1 liter
7. re-install filter, gasket and pan, then add your Valvoline ATF+4
8. Add, the valvoline, transmission medic and make sure you have the right level of fluid

That solved my transmission problems, instantly it was shifting better, I no longer had to let off the gas to make it shift. Now if you have large pieces of metal on the magnet, and it's totally covered in filings, you might want to consider rebuilding the trans. My magnet had usual clutch.         

Anyhow good luck, let me know if it did the trick for you.
Justin

May 16, 2008 | 1996 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

569 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...