Question about 2006 Chrysler PT Cruiser

Open Question

Where is the fuel pump relay located on a 2006 pt cruiser

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

66 chrgr
  • 1011 Answers

SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?

the crank sensor is located on back right side of engine by were the trans. bolts the no start when could or hot?

Posted on Jan 25, 2009

  • 2984 Answers

SOURCE: Location of powertrain control module on 01 PT Cruiser?

The PCM attaches to a bracket welded on the dash panel


Posted on Oct 31, 2009

  • 4 Answers

SOURCE: fuse box


Posted on Oct 22, 2008

  • 290 Answers

SOURCE: chrysler pt cruiser fuel filter location?

Under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module

Posted on Mar 27, 2009

  • 986 Answers

SOURCE: What type of special coolant is needed for the

Please use a 50/50 mix of any kind that is formulated coolant I use texaco

Posted on Nov 30, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where to locate the fuel relay shut off

There isn't any . The totally integrated power module controls the fuel pump . Do you know about automotive electronics ? Suggest you take your vehicle to a ASE certified repair shop that has the tools to diagnose this properly .

Mar 10, 2016 | 2006 Chrysler PT Cruiser

1 Answer

Head lights dont work on my chrysler pt cruiser 2006

What have you checked with the lights.........
1. globes not burnt out?
2. Fuse for Headlights?
3. The headlight relay?
Check in your owners manual for the location of the fuses and relays for your PT Cruiser..

Sep 23, 2015 | 2006 Chrysler PT Cruiser

1 Answer

How to install a fuel pump relay for a pt cruiser

i'm not sure where it is located on that car but most always it is in the engine compartment in a box with other relays and some fuses but to replace it just pull it out and install the new one, often there is also a fuse in the regular fuse box.

Jul 31, 2014 | 2006 Chrysler PT Cruiser

1 Answer

Location of fuel cut off switch on 96 astro van.

Only Ford products use a cut off switch, called an inertia switch.
If your fuel pump is not getting power, the pump relay is the first place to start testing.

Jun 02, 2013 | 2006 Chrysler PT Cruiser

1 Answer

06 pt cruiser no start/no fuel presure

fuel pump fried need new fuel pump check your fuel pump relay make sure its good.

Feb 17, 2013 | 2006 Chrysler PT Cruiser

1 Answer

2009 pt cruiser fuel pump relay location

most fuel pump relays are under the hood in the power distribution box. Owners manuals may give a diagram on what fuse is what. Alot of the time if the relay goes the pump isn't far behind or vise versa.

Sep 10, 2012 | 2006 Chrysler PT Cruiser

1 Answer

Where is fuel reset switch or fuel relay on 2006 pt cruiser located

Relieving Fuel System Pressure


CAUTION Relieve the fuel system pressure before servicing any components of the fuel system. Service vehicles in well ventilated areas and avoid ignition sources. NEVER smoke while servicing the vehicle!

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove the fuel pump relay from the Power Distribution Center (PDC).
  3. Start and run the engine until it stalls.
  4. Turn the ignition key to the OFF position

May 08, 2012 | 2006 Chrysler PT Cruiser

1 Answer

Where is the fuel pump relay on a 06 pt cruiser

I do not see a specific fuel pump relay on this vehicle.. The auto shutdown relay however is located on the drivers side firewall right below the windshield. If you are standing at the drivers side fender.. look toward the engine and it will be on your right hand side.. Hope this helps.. There is a starter relay in this location too...The ASD relay will be on the right hand side..

Aug 18, 2011 | 2006 Chrysler PT Cruiser

1 Answer

Where is the fuel pump cut off switch located exactly and how could I reset it.

The fuel pump relay is located in the Power Distribution Center (PDC) under the hood. The inside top of the PDC cover has a label showing relay and fuse location. The relay supplies battery voltage to the fuel pump. A buss bar in the Power Distribution Center (PDC) supplies voltage to the solenoid side and contact side of the relay. The PCM controls the fuel pump relay by switching the ground path for the solenoid side of the relay on and off. The PCM turns the ground path off when the ignition switch is in the Off position. When the ignition switch is in the On position, the PCM energizes the fuel pump. If the crankshaft position sensor does not detect engine rotation, the PCM de-energizes the relay after approximately one second.

Sep 19, 2009 | 2006 Chrysler PT Cruiser

1 Answer

Fuel Filter

the filter is part of the fuel pump module and isnt serviced separately

Dec 13, 2008 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
2006 Chrysler PT Cruiser Logo

Related Topics:

1,087 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides