Question about 2000 Chevrolet Impala
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: chevrolet impala 2000
I had this problem this too and it was the connector of braid electricity on the left front wheel and i could replace all the braid or just try to fix it
Posted on Jul 03, 2008
Pop off the black ring around ignition lock small screwdriver willl do. Remove dashboard plastic to expose 2 bolts holding ignition assy. Can be tedious. IF you can turn the key turn it to Start. In the plastic housing there's a 1/4 by 3/8 hole. push in a screwdriver which will push in a button on ignition cylinder and allow you to slide it out. The hole is located at 4 o'clock if we agree that the 2 wiring harness plugs are at 6 o clock and its 1 and 1/4 inches below the face of ignition cylinder. If you dont feel that the screwdriver is pushing in that "button" rotate your key until it does. Then just slide the cylinder out.
Posted on Apr 12, 2009
It sounds like you might need to replace your motor mounts, or get a tier allignement done. The allignment you cannot do yourself but the motor mounts you can this requires you to place a jack under you engine and undoing the motor mounts then replace them and take away jack.
Posted on Jan 30, 2010
YOU NEED A HAYNES REPAIR MANUAL WITH PHOTOS TO SHOW YOU HOW TO REMOVE STEERING WHEEL AND DISABLE AIRBAGS.YOUR IGNITION SWITCH IS IN THE STEERING COLUMN.
Posted on Jul 07, 2010
Tips for a great answer:
J 6083 Snap Ring Pliers
Important: Remove the three adjustable dowels from the J37872 Compressor Clutch Holding Tool.
Install three 5/16 x 1 inch bolts in place of the dowels.
Remove and discard the compressor clutch plate bolt.
Use the J 37872 to hold the compressor clutch plate from turning.
Remove the compressor clutch plate from the compressor.
Remove the compressor pulley snap ring using the J 6083
Remove the compressor pulley from the compressor.
Remove the compressor clutch coil snap ring using the J 6083 .
Remove the compressor clutch coil from the compressor.
google J 37872 - to see tool !
Jan 31, 2016 | 2006 Chevrolet Chevrolet Impala LT
Mar 19, 2017 | 2006 Chevrolet Impala
Nov 14, 2015 | 2006 Chevrolet Impala
Oct 11, 2014 | 2000 Chevrolet Impala
Oct 21, 2013 | 2010 Chevrolet Impala LT
Jun 01, 2012 | 2000 Chevrolet Impala
Sep 02, 2011 | 2007 Chevrolet Impala LS Sedan New Cars
Apr 20, 2010 | 2000 Chevrolet Impala
Apr 04, 2010 | 2000 Chevrolet Impala
430 people viewed this question
Usually answered in minutes!