Question about 1988 Buick Century

1 Answer

Where is the blower motor and how is it replaced on a 1988 Buick Century?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Buick Master
  • 8,567 Answers

First make sure the blower is bad. Please see my tip at http://www.fixya.com/cars/r6234839-doesn_t_heater_or_air_conditioner_blow .
Below are instructions from autozone.com for replacing your blower.


REMOVAL & INSTALLATION See Figures 1, 2 and 3
This procedure is applicable for vehicles, with or without air conditioning.

  1. Disconnect the negative cable at the battery.
  2. On the 3.1L (VIN M) you will need to remove the serpentine belt and move the alternator aside. See Engine & Engine Overhaul for removal and installation.
  3. For the 2.2L (VIN 4), disconnect the air inlet resonator, then remove the torque strut from the engine. Rotate the engine slightly forward.
  4. Working inside the engine compartment, disconnect the blower motor electrical leads.
  5. Remove the motor retaining bolts. If there is a hose disconnect it, then remove the blower motor.
where is the blower motor and how is it replaced - 051b335.gif

Fig. Fig. 1: Remove the blower motor retaining bolts ...
ab5f5fc.gif

Fig. Fig. 2: ... thwhere is the blower motor and how is it replaced - 5204077.gifct the hose
5204077.gif

Fig. Fig. 3: The blower motor can now be removed


To install:

  1. Position the blower motor on it

Posted on Oct 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Anyone have the wiring diagram for a 1988 buick century window switch, drivers door ?


Enter this string in your web browser under the images search bar"wiring diagram for a 1988 buick century window switch"
and you also look at this web page:
http://ricksfreeautorepairadvice.com/window-goes-up-but-not-down-window-goes-down-but-not-up/

Feb 05, 2015 | 1988 Buick Century

1 Answer

I have a 1988 Buick century that the passenger front window will not work.


ensure the motor has a good electrical ground, check wiring for breaks and solid connections to and from switches, check power is getting to motor, check action of motor is in the correct direction for down.

Feb 05, 2015 | 1988 Buick Century

1 Answer

1998 buick century when air or heat is on I hear a squilling noise , what is it?


Replace the heater blower motor or the caged fan attached to the blower motor, or both.

Oct 28, 2013 | 1998 Buick Century

1 Answer

1998 Buick Century w/ manual control, smelled burning odor and blower motor quit working. Control Module?


blower resistor is common to burn causeing smell. check with dealer, there may be a campain on this problem. if not. replace resistor and harness (pig tail) and blower motor..

Jan 21, 2013 | 1998 Buick Century

2 Answers

98 century heater blower motor resistor location


look under the passenger side of the dash. There will be a plastic trim panel that will need to be removed. Once its out of the way you will see the blower motor. The resistor will be just to the drivers side of the blower motor.

Nov 15, 2011 | 1998 Buick Century

1 Answer

2000 Buick Century. Blower quit working for


I had the same problem. It turned out to be the ignition switch. i have no idea how that is connected to the fan but... it worked, got me my fan speeds back, although it is not working again...

Jul 16, 2010 | 2000 Buick Century

1 Answer

1988 Buick Century, not getting gas


by pass relay to see what happens.

Apr 05, 2010 | 1988 Buick Century

2 Answers

Blower motor stays running


by now u figured out that you pull the 30amp fuse from the panel on passanger door size of dash
the lower blower motor operates on another 15amp fuse

Jun 26, 2009 | 2000 Buick Century

Not finding what you are looking for?
Cars & Trucks Logo

316 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...