Question about 2007 Pontiac G5 Gt Coupe

Open Question

Replace headlight bulb on a 2007 Pontiac G5

Owners manual states "Remove the two plastic fastners from the fascia". Please clarify.
Thanks

Posted by on

6 Suggested Answers

bunnydawg
  • 5158 Answers

SOURCE: pontiac torrent headlight burnt out? Can I replace it myself?

yes you can replace it. the bulb is removed from inside the engine compartment. if the burnt out bulb is on the battery side you will likely have to take the battery out. the socket generally turns about a quarter turn or so... have a look to see if there is a large ring that you turn and remove first.
One important detail do NOT touch the bulb with your fingers as it shortens the bulbs lifespan.

Robert

Please take a moment to rate this solution thanks

Posted on Jan 28, 2009

  • 14036 Answers

SOURCE: Where is the fuel filter on a 2007 Pontiac G5

THE 2007 G5 MODELS WITH CALIFORNIA PZEV EMISSION SYSTEMS IS PART OF THE FUEL PUMP MODULE IN FUEL TANK.ON THE REGULAR G5 MODELS. FUEL FILTER IS NEAR THE GAS TANK.

Posted on Sep 04, 2009

BCAS1298
  • 3092 Answers

SOURCE: I have a 2007 Pontiac G5 with a headlight problem.

Check the bulb out. Take it out, look at the little spring in the bulb, if it don't look nice and clean ( no breaks ) replace it.Bad bulb.Hopes this helps.

Posted on Nov 23, 2009

theautoguy
  • 69 Answers

SOURCE: i have a 2007 pontiac g6, 4 door. i changed the

Check the wiring on the headlight. You may have a damaged wire or bad ground.

Posted on Dec 30, 2009

  • 81 Answers

SOURCE: Have a 2007 Pontiac G5 and need to add power steering fluid.

its tricky. its behind the engine. If you pop the hood and you go to the left side, look behind the block and it chould be about half way down or so. You should see the cap for it. I think that was a horrible idea on pontiacs part. Happy motoring!

Posted on Jan 21, 2010

  • 1 Answer

SOURCE: 2007 pontiac vibe gear shift light replacement.

On the 2004 Pontiac Vibe that I owned, I ended up taking it to the dealer. Perhaps this advice can avoid having you end up at the same place!

Remove the middle environmental control knob (fan blower speed, I think) by tugging on it until it comes off. Underneath you will find a single Phillips screw. Remove the screw and gently (so you don't mar it), pull at the plastic trim surrounding the environmental control area. It should pop out. You may also want to remove the two-prong AC outlet by prying it gently out with a small slotted screwdriver before attempting to pry out the trim panel.

After that panel is out of the way, you are ready to tackle the plastic trim surrounding the shift knob. Begin by removing the small holding compartment at the base of the shift knob. There is a single Philips screw holding the plastic piece to a supporting brace on the lower end. Four additional screws on the upper end are revealed by the removal of the environmental control trim piece as previously described.

Okay, from there, you're ready to gently pry loose the trim panel surrounding the shift knob.

The bulb can be located on the driver's side. It's a 'funny' looking bulb that is integrated into a two wire bundle. You may end up having to replace the bulb+wire bundle as a unit. The electrical connector is on the opposite side of the shift knob.

Good luck!


Posted on Feb 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HOW TO REMOVE A HEADLIGHT FROM A 2007 SATURN OUTLOOK XE


Hi Carol , your going to have to remove the headlamp assembly to replace the bulb !


Remove the headlamp assembly. Refer to Headlamp Replacement.



1



Headlamp Bulb Accessory Covers (Qty: 2)



2



Headlamp Bulb Assembly (High Beam)




Caution: Refer to Halogen Bulb Caution in the Preface section.




Tip

Disconnect the electrical connectors and remove the bulbs.



3



Headlamp Bulb Assembly (Low Beam)


Callout

Component Name

Preliminary Procedure

Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement .




Headlamp Assembly Bolt (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tighten

6 N?·m (53 lb in)







2





Headlamp Fascia Brace Fender Reinforcement Bolt




Tighten

6 N?·m (53 lb in)







3





Headlamp Cam Adjuster




Procedure

Set the headlamp adjusters at the nominal setting of 6 turns off fully seated.







4





Headlamp Cam Locking Nut







5





Headlamp Assembly




Tip

Disconnect the electrical harness as the headlamp assembly is being removed from the vehicle.

Apr 08, 2015 | 2007 Saturn Outlook XE

1 Answer

Replacing headlights


look in owners manual in back index for bulbs replacement it will show and tell you how to remove replace head light bulbs also wear clean gloves when handling the head light halogen bulbs because oils from skin or fingers will cause halogen bulbs to over heat and blow.

Nov 29, 2011 | 2007 Pontiac Torrent AWD

1 Answer

How hard is it to change a bulb on the headlight of a pontiac g5


Look in your owner's manual. They'll tell you which bulbs to buy and how to replace one.
It's a very simple procedure. Lift up your hood and look at your headlights. You can see the connector on the back of the headlight.

Jan 19, 2011 | 2007 Pontiac G5 Gt Coupe

1 Answer

How to change headlight lamp in 2005 Pontiac g6


To change the bulbs you need to first remove the 5 plastic pop screws on the front bumper. They're spread out at the top of the bumper right under the hood. Once you get those out, you have to remove the two hex bolts on each headlight. Then it gets tricky. You need to pull the light towards the front of the car until it pops out of the ball-bearing type mount on the fender. Once that pops out, you have to pull the front bumper forward while maneuvering the headlight out towards the front.

As per the manual it says as follows:---

Open the hood.

Hold the headlamp to prevent damage to the headlamp or to the fascia. Remove the bolts from the headlamp assembly. Remove the push-in-retainers across the front fascia. Remove the headlamp assembly. Lift the headlamp upward to release the locating tab from the front edge of the fender.

Disconnect the electrical connector from the headlamp assembly.

Remove the headlamp bulb access cover by rotating the headlamp bulb access cover counterclockwise, if necessary.

Remove the headlamp bulb from the housing by rotating the socket counterclockwise, if necessary.

Disconnect the headlamp bulb electrical connector, if necessary.

Remove the park/turn bulb access cover by rotating the cover counterclockwise, if necessary.

Remove the park/turn bulb from the housing by rotating the socket counterclockwise, if necessary.

Gently pull the park/turn bulb from the socket, if necessary. Install the park/turn bulb into the bulb socket.

Install the park/turn bulb socket into the headlamp housing by rotating the socket clockwise.

Install the park/turn bulb access cover by rotating the cover clockwise.

Connect the headlamp bulb to the headlamp electrical connector.

Install the headlamp bulb into the headlamp housing. Rotate the socket clockwise until locked.

Install the headlamp bulb access cover by rotating the cover clockwise.

Position the headlamp assembly to the vehicle. Lift the headlamp upward to release the locating tab to the front edge of the fender.

Install the bolts to the headlamp assembly. Tighten the bolts to 2 N·m (18 lb in).

Install the push-in-retainers across the front fascia.

Close the hood.

----------This will help.thanks.Helpmech.

Dec 25, 2010 | Pontiac G6 Cars & Trucks

1 Answer

Need to replace the headlight assembly on front passenger side do i have to take off the bumper? for ponitac vibe 2003 also have dent on the area


Yes you do. This is the steps to do that to replace the entire headlight assembly:


Remove the front fascia.
  • Remove the front fascia extensions, if equipped.
  • Remove the front fender liners.
  • Remove the fog lamps.
  • Remove the bolts (4) from the front bumper fascia (3) at the fender.


506bafd.gif

Remove the bolts from the front bumper fascia at the fender



  • Remove the push-in retainers (2) from the bumper fascia using J38778.
  • Remove the fascia bolts (1) from the fascia.
  • Remove the fascia from the vehicle.
  • Remove the 3 bolts which secure the composite headlamp.


  • 7f1ec16.gif

    Remove the 3 bolts which secure the composite headlamp



    1. Remove the sidemarker bulb electrical connector.
    2. Remove the sidemarker bulb, if necessary.
    3. Remove the composite headlamp assembly from vehicle.

    To install:

    1. Install the sidemarker bulb to the composite headlamp, if removed.
    2. Connect the sidemarker bulb electrical connector.
    3. Secure the composite headlamp to the vehicle with the 3 bolts. Tighten the headlamp mounting bolts to 89 inch lbs. (10 Nm).
    4. Install the front fascia.
    5. Install the headlamp bulb to the composite headlamp, if removed.
    6. Fasten the headlamp bulb retainer clip.
    7. Install the socket to the headlamp bulb.
    8. Install the rubber cover to the composite headlamp.
    9. Aim the headlamps.
    10. Close the hood.

    Oct 12, 2010 | 2003 Pontiac Vibe

    1 Answer

    I have a Pontiac Wave 2007. I cannot figure out


    Here is a link for you to get a copy of your Manuel to your Vibe.
    Thank you for using fixya and keep me posted if you still need help on to replacing your bulb.
    http://www.ownersmanualsource.com/pontiac/pontiac-vide-owners-manual/

    Jun 03, 2010 | 2006 Pontiac G5

    2 Answers

    I have a 2007 Pontiac G5 with a headlight problem. My driver's side headlight(low beam) works when i hit "unlock" from my keypad, but when i start my car, it goes out. When i turn my brights on, they both...


    the problem is not the bulb, cause it does go on, so your problem is caused by any of the other components involved, get a wiring diagram and work with that to fix the problem.
    hope this helps

    Nov 23, 2009 | 2009 Pontiac G5

    2 Answers

    Replace headlight


    You'll need bulb #9007,

    1. Open the hood and remove the two headlight mounting screws.
    2. Remove the push in fasteners by prying under the head of the fastners with a flat blade tool.
    3. Gently pry the headlight assembly away from the fender.
    4. Turn the retaining ring counter clockwise to remove the bulb.
    5. Pull the bulb out of the socket and replace.
    6 Reverse the procedure to put the housing back in.

    This is outlined on page 241 of your owners manual. If you don't have one you can download one here: http://www.dodge.com/en/owners/manuals/index.html

    Sep 12, 2009 | 2006 Dodge Stratus

    1 Answer

    Headlights on a Saturn Aura


    The easiest way is to remove the front wheel and the then the plastic inner fender liner. You'll have access to the bulbs then.
    The other method is to remove the front bumper fascia.
    Also, just a note that these "new" blue lights are illegal in many states and generally aren't DOT approved. I'd recommend sticking to major, reputable brands.

    Jul 23, 2009 | 2007 Saturn Aura XR Sedan

    2 Answers

    Pontiac torrent headlight burnt out? Can I replace it myself?


    yuo dont need headlight. the bulb is removable from inside under the hood.. just pull the connector off and remove the plastic hold down. you should be able to pull the bulb out.i hope it was helpfull. thanks

    Jan 28, 2009 | 2006 Pontiac Torrent

    Not finding what you are looking for?
    2007 Pontiac G5 Gt Coupe Logo

    Related Topics:

    1,283 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Pontiac Experts

    yadayada
    yadayada

    Level 3 Expert

    61168 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6812 Answers

    Are you a Pontiac Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...