Question about 2007 Kia Sedona LX Minivan

Open Question

Where is rear window washer fluid reservoir for 2010 sedona

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: Rear washer fluid 2004 srx

there shouldn't be any rear washer fluid reserve for you back window there's only one reserve and that's under the hood which controls the front and back. but also you can call your local dealer and ask them.

Posted on Jan 25, 2009

Ad
MrScary66613
  • 1990 Answers

SOURCE: Can't find the rear washer reservoir in 2000 kia sportage

Your Rear Reservoir is the Same as the Front. Is has a Line that supplies Both the Front and Rear Washers. Please Rate my Response, I need all the Help That I can Get! Thanks!

Posted on Jan 27, 2009

  • 512 Answers

SOURCE: front widshield washer fromm 1999 Cherokee doesn't work

the same reservoir is used for both ...it uses separate pump motors.....if the wipers are working the fuse for the washer pump is good...check the power and ground for the pump...

Posted on Nov 03, 2008

  • 139 Answers

SOURCE: Rear window washer not working.

it could a blockage at the spayer outside .take a safety pin and poke in the small hole outside.
to check the button remove,it from the dash take a
12volt tester check to make sure you have poweon one side

Posted on Apr 12, 2009

  • 29 Answers

SOURCE: 1999 Jeep Cherokee rear window washer

There are two separate washer pumps underneith the washer res. behind the front driver quarter panel. The exact pumps are hard to find. I have the same prob with my 99, but both are out. I had a 98 that the front worked but not rear. I had to get a "universal" washer pump. I'm still trying to find a factory replacement for this one before I do that. No luck so far.

Posted on Apr 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does the 2005 Nissan Murano SE have rear window washer? If so, where do I fill the rear wiper fluid?


Yes it does and the washer fluid reservoir under the hood is for both the front and rear. The following is a diagram of the washer pump and hoses so you can check for operation or leaks.

http://www.nissanmurano.org/forums/attachments/problems/15059d1233342517-rear-washer-fluid-not-squirting-washer-motor.jpg

Feb 21, 2013 | 2005 Nissan Murano SE

1 Answer

Fill 2008 nissan pathfinder windshield washer fluid


Just one.Check the lines and the pump at reservoir,

Jan 14, 2013 | Nissan Cars & Trucks

1 Answer

What is reservoir at top left hand corner of kia sedona - also where can I pick up a manual for a 2002 model?


after market manuals are much better than dealer owner books, they have much more info,, they are at any parts store, and run between 20 and 25 bucks,, Haynes has a better electrical section than Chiltons manuals do,, as far as the reservoir , I don't have that info, But its either going to be brake fluid, washer fluid,, or power steering. I'll see if I can find out for you

Jun 21, 2011 | 2002 Kia Sedona

2 Answers

How do I fix my window washer pump on my 2000 dodge caravan?


One can get a repair kit that includes a new motor pump and wiring clips, or

one can get the original motor that plugs into the windshield wiper fluid reservoir.

---
Windshield wiper reservoir (gives idea of how to change the windshield wiper fluid pump motor) Removal & Installation To Remove:
  1. Disconnect and isolate the negative battery cable.
  2. Raise and safely support the vehicle.
  3. Remove the right front wheel and splash shield.
  4. Disconnect the electrical connectors from the pumps and detach the rear washer hose.
  5. Place a drain pan under the reservoir if it contains fluid.
  6. Disconnect the front washer hose at the wiper unit in the engine compartment. NOTE: The front hose will be removed with the reservoir.
  7. Let the fluid drain from the reservoir.
  8. Remove the mounting screws and the reservoir.
To Install:
  1. Install the fluid reservoir with the mounting screws.
  2. Connect the front washer hose in the engine compartment.
  3. Connect the electrical connectors and rear washer hose.
  4. Install the splash shield.
  5. Install the right front wheel.
  6. Lower the vehicle.
prev.gif next.gif

Aug 27, 2010 | 2000 Dodge Caravan

1 Answer

Where do I find the rear window washer fluid reservoir for 1995 Chevy Tahoe


the front reservoir is the same reservoir for the front and rear, you should see two pumps on the reservoir

Aug 26, 2010 | 1995 Chevrolet Tahoe

3 Answers

Where do you add fluid for rear window washer


I believe that if you add it in the front, it makes it to the back. I have never had to add any to anywhere else and I use it all the time.

Jun 20, 2010 | 2005 Chrysler Town & Country

1 Answer

Rear window washer fluid fill


check in the cargo area of the vehicle, there should be an access panel on either the right or left panel in back. if it has a separate reservoir that's the most probable location
hope this helps

Feb 22, 2010 | 2004 Honda Pilot

1 Answer

Mercury villager 1994 washer pump not working


the pump motor likely is bad. get a used washer fluid reservoir at a pick n pull yourself or at car-part.com. page with * is lowest cost.

Pump and Reservoir, Windshield Washer Removal
  1. Disconnect the battery ground cable (14301).
  2. Raise and support the vehicle.
  3. Remove the RH wheel (1007).
  4. Remove the RH front fender splash shield (16103). Refer to Section 01-02 for the removal procedure.
  5. Remove the windshield washer reservoir top bolt.

  6. Disconnect the windshield washer reservoir fluid level sensor electrical connector.
  7. Disconnect the rear window washer pump electrical connector from the rear window washer pump.
  8. Disconnect the windshield washer pump electrical connector from the windshield washer pump (17664).
  9. Place a suitable drain pan under the windshield washer reservoir (17618) and drain the washer fluid.
  10. NOTE: The rear window washer hose end is color-coded, matching the connector on the rear window washer pump. Match the colors to ensure proper installation.

    Disconnect the washer hoses from the windshield washer pump and the rear window washer pump on the windshield washer reservoir.

  11. Loosen the two windshield washer reservoir side bolts.
  12. Remove the windshield washer reservoir by sliding it out of the side slots.
  13. Remove the windshield washer pump.

    Installation
To install, reverse the removal procedure. Tighten the lug nuts (1012) to 98-118 Nm (72-87 lb-ft).

Sep 09, 2009 | 1994 Mercury Villager

1 Answer

Odyssey rear window washer fluid not spraying where is reservior


The reservoir is the same one for the front washers. There are two electric pumps on the base of the reservoir (one for front and one for rear). You probably need a new pump. It is accessible behind the panel in front of the front right wheel.

Jan 02, 2009 | 2001 Honda Odyssey

Not finding what you are looking for?
2007 Kia Sedona LX Minivan Logo

Related Topics:

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...