Question about 1999 Hyundai Sonata

Open Question

Where is the canister purge valve located on a 2000 hyundai sonata?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
TDISLine
  • 1874 Answers

SOURCE: 1999 hyundai accent canister purge

There is a purge solenoid for the EVAP system and it is item no.# 1 shown in the diagram below. You have to follow the purge valve vacumn hose to find the charcoal cannister if you need to inspect.

tdisline_101.jpg
I have included a description of the EVAP system for your understanding.

EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM
The EVAP and on-board refueling vapor recovery (ORVR) system consists of a fill vent valve, fuel shut-off valve, fuel cut (roll-over) valve, fuel liquid/vapor separator, EVAP canister, EVAP canister purge solenoid valve, EVAP canister close valve, vacuum relief filler cap, and connecting lines and hoses. ORVR system is designed to prevent the release of fuel vapors during refueling. During refueling, as fuel enters the fuel tank, a vacuum is created in filler pipe, drawing air into the filler pipe and tank. Fuel vapor in fuel tank is then forced to the EVAP canister via the fill vent valve and the fuel liquid/vapor separator. A fuel tank pressure sensor is used for detecting EVAP system leaks by comparing pressures inside and outside of fuel tank.

EVAP Canister Purge Solenoid Valve
Fuel vapors are vented into the EVAP canister during refueling and when ignition is off. When engine is at normal operating temperature and engine speed is greater than idle, a thermovalve opens and allows vacuum to open the purge control valve. Canister vapors are then drawn into the intake manifold for burning during combustion. The purge control valve is kept closed during idle and engine warm-up to reduce HC and CO emissions.

Posted on Dec 16, 2010

Ad
Dak408
  • 277 Answers

SOURCE: 2002 hyundai sonata. where is

underneath the car in the rear on or next to the drivers side rail ...

Posted on Oct 15, 2010

c_dyer01905
  • 27 Answers

SOURCE: need location of vapor canister and purge valve in

The Canister Is located on the rear drivers side under the car (Big black box with 3 rubber lines). And the purge valve is located on the in the center on the back of the intake manifold (2 rubber lines and 1 plug).

Posted on Nov 15, 2010

  • 501 Answers

SOURCE: Where is the vapor canister

Usually the vapor canister's are located on most vehicles on the driver's side fender. You can otherwise follow the vapor lines from the gas tank to it and the valve which usually gets stuck in place by a residual vapor/moisture build up can sometimes be freed up by using a can of carb cleaner and a small screwdriver. Depress the valve which is plunger and spring activated more or less and spray the carb cleaner into it. Do this several times (you can do this for egr or other faulty valves that are stuck SOMETIMES) then start your vehicle and see if trouble code persists if it does then replace the valve and you're only out about 4 dollars for carb cleaner

Posted on Apr 23, 2011

ghost45
  • 1280 Answers

SOURCE: I AM TRYING TO GET

Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop manuals, service bulletins, illustrations and procedures, etc.

Posted on Sep 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where canister sonata


im quoting another



The Canister Is located on the rear drivers side under the car (Big black box with 3 rubber lines). And the purge valve is located on the in the center on the back of the intake manifold (2 rubber lines and 1 plug).

May 03, 2015 | 2010 Hyundai Sonata

1 Answer

Where is the engine coolant temp. circuit high input located on a 2001 hyundai sonata...code p0441


Trouble code P0441 indicates EVAP emiddion control system incorrect purge flow.
Possible faulty purge valve or circuit.
Possible causes: purge line plugged, vacuum hose failure, EVAP purge solenoid failure and/or emission canister clogged.

The coolant sensor is a 2 wire sensor located in the thermostat housing.

Oct 04, 2011 | Hyundai Motor 2002 Sonata

1 Answer

Where is the vapor canister purge valve located on a 2005 Hyundai Sonata 2.7L V6?


Usually the vapor canister's are located on most vehicles on the driver's side fender. You can otherwise follow the vapor lines from the gas tank to it and the valve which usually gets stuck in place by a residual vapor/moisture build up can sometimes be freed up by using a can of carb cleaner and a small screwdriver. Depress the valve which is plunger and spring activated more or less and spray the carb cleaner into it. Do this several times (you can do this for egr or other faulty valves that are stuck SOMETIMES) then start your vehicle and see if trouble code persists if it does then replace the valve and you're only out about 4 dollars for carb cleaner

Apr 23, 2011 | Hyundai Sonata Cars & Trucks

2 Answers

Codigo p1440


EVAP System Vent Circuit Malfunction

This diagnosis detects leaks in the Evaporative Emission (EVAP) purge line using of vapor pressure in the fuel tank. The EVAP canister vent control valve is closed to shut the EVAP purge line. The vacuum cut valve bypass valve will then be opened to clear the line between the fuel tank and the EVAP canister purge volume control solenoid valve. The EVAP control system pressure sensor can now monitor the pressure inside the fuel tank. If pressure increases, the Engine Control Module (ECM) will check for leaks in the line between the vacuum cut valve and EVAP canister purge volume control solenoid valve.

Possible causes
- Incorrect fuel tank vacuum relief valve
- Incorrect fuel filler cap used
- Fuel filler cap remains open or fails to close
- Foreign matter caught in fuel filler cap
- Leak is in line between intake manifold and EVAP canister purge volume control solenoid valve
- Foreign matter caught in EVAP canister vent control valve
- EVAP canister or fuel tank leaks
- EVAP purge line (pipe and rubber tube) leaks
- EVAP purge line rubber tube bent
- Blocked or bent rubber tube to EVAP control system pressure sensor
- Loose or disconnected rubber tube
- EVAP canister vent control valve and the circuit
- O-ring of EVAP canister vent control valve is missing or damaged
- EVAP canister is saturated with water
- EVAP control system pressure sensor
- Absolute pressure sensor

Possible solution
- Loose fuel filler cap
- Leaking fuel filler cap


Hope helps (remember to rate this answer).

Jan 05, 2011 | 2000 Hyundai Sonata

1 Answer

2002 hyundai sonata. where is the purge valve canister located


underneath the car in the rear on or next to the drivers side rail ...

Oct 15, 2010 | 1999 Hyundai Sonata

1 Answer

Need location of vapor canister and purge valve in 1999 sonata v-6. any help with evap system is appreciated.


The Canister Is located on the rear drivers side under the car (Big black box with 3 rubber lines). And the purge valve is located on the in the center on the back of the intake manifold (2 rubber lines and 1 plug).

Sep 14, 2010 | 1999 Hyundai Sonata

1 Answer

Check engine warning light is on 2001 hyundai sonata


Purge Control Valve Problem

The "Purge Control Solenoid Valve" is the "Purge Control Valve".

Rough idle is a typical symptom of something amiss with the purge control portion of the evaporative emissions system. It could be the valve itself is not operating correctly, the evap canister (vapor canister) may be leaking, or full of raw gas instead of vapor, or maybe even the purge control valve is getting a faulty signal from the ECU.

The soleniod is checked by applying a voltage to it and checking to see if it closes, or opens (I'm not sure if its un-energized state is normally open, or normally closed). If the valve is bad it is a no-brainer to replace.

The vapor canister can be removed and checked to see if it is full of raw gas (not supposed to be), but checking it for leaks is a bit involved, and probably requires equipmet not normally owned by a home mechanic. Vapor canister failure on cars with a lot of miles is common. Replacement is the fix.

Of course if the ECU is not sending a purge signal to the valve correctly, figuring out why may proove difficult, and possibilities could even include a faulty ECU. I expect this is unlikely though.

It's a $20 part. I first would change pcv valve because it can give same error if it's plugged up. You can always remove it and shake it. It should rattle around real easy. If not, it should be repalced

Apr 17, 2010 | 2001 Hyundai Sonata

2 Answers

What is he code 455 for a 2006 hyundai sonata means


CODE PO455 EVAPORATIVE EMISSION SYSTEM LARGE LEAK DETECTED.POSSIBLE CAUSES CANISTER VENT SOLENOID MAY BE STUCK IN OPEN POSITION / EVAP CANISTER TUBE EVAP CANISTER PURGE OUTLET TUBE OR EVAP RETURN TUBE DISCONNECTED OR CRACKED OR CANISTER IS DAMAGED / EVAP CANISTER PURGE VALVE STUCK CLOSED OR CANISTER DAMAGED / FUEL FILLER CAP MISSING LOOSE NOT TIGHT OR THE WRONG PART / FUEL VAPOR HOSES TUBES BLOCKED OR RESTRICED OR FUEL VAPOR CONTROL VALVE TUBE OR FUEL VAPOR VENT VALVE ASSEMBLY BLOCKED /FUEL TANK PRESSURE SENSOR HAS FAILED MECHANICAL FAULT /FUEL TANK CONTROL VALVE IS CONTAMINATED DAMAGED OR HAS FAILED.

Oct 21, 2009 | 2006 Hyundai Sonata

3 Answers

04 sonata hard tostart after fueling


Sounds like the 'Purge Control Solenoid Valve' to me. The evaporative canister (charcoal canister) absorbs the vapors from the fuel tank).. sometimes this canister becomes 'saturated' and the 'PURGE CONTROL SOLENOID VALVE' sucks RAW fuel into the intake manifold (causing a 'flooding' fuel condition).. but ONLY if this valve is STUCK OPEN or LEAKING. Replace this valve.. go from there.

Jul 12, 2009 | Hyundai Motor 2004 Sonata

1 Answer

Hyundai Sonata 2000, sluggish to start only after fueling


Purge control solenoid valve is suspect. After refueling, the charcoal canister can become 'saturated' and this valve (if stuck OPEN) sucks air through it and can draw raw fuel into the intake manifold creating a 'flood' condition.




7d93f9f.jpg

6219918.jpg

Feb 14, 2009 | 2000 Hyundai Sonata

Not finding what you are looking for?
1999 Hyundai Sonata Logo

Related Topics:

874 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...