Question about Isuzu Rodeo

Open Question

Free repair manual 1995 isuzu rodeo - Rodeo Isuzu Cars & Trucks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: I need the schematics for

4wd, 3.2L 6cyl need to know how to install a timing belt and timing specs thank you.

Posted on Jul 10, 2008

Ad
michigan man
  • 3533 Answers

SOURCE: clutch adjustment on a 1995 isuzu rodeo

try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Posted on Mar 21, 2009

  • 33 Answers

SOURCE: firing order 1995 isuzu rodeo 3.2v6

123456 IS THE FIRING ORDER... RIGHT BANK (RIGHT AS IN SITTING IN THE DRIVERS SEAT NOT STANDING IN FRONT OF THE CAR)STARTING AT FRONT IS CYLINDER 1 THEN 3 THEN 5 THEN THE LEFT BANK IS CYLINDER 2,4,6, FRONT TO REAR... THE COILS FROM LEFT TO RIGHT (STANDING IN FRONT OF CAR) ARE 1,4,6,3,2,5 HOPE THIS HELPS

Posted on Mar 27, 2009

defadad
  • 351 Answers

SOURCE: 1995 isuzu rodeo hood release broken under the hood

if the grille screws are accessable remove the grille which should give you access to the underside of the lock, you may need a screwdriver to push the lever aside to release the hood
Hope this helps

Posted on May 23, 2009

  • 4 Answers

SOURCE: Where is the obd port

d2610cc.jpg
Here is a photo of the obd connector on a 1993 Isuzu Trooper.

The connector is on the transmission hump about 6 inches from the accelerator pedal. It is inside a black hood. Right next to the white OBD connector is an identical green connector that I have not tested.

The OBD port is a white 3 hole plug. Right next to it in the photo is a green 3 hole plug that I believe is for automatic transmission diagnostics. The plug is different from other plugs under the dash as it will not accept a .25" tab connector.

The picture shows a 20 ohm resistor being used to short pin 1 and 3 of the white plug. The resistor is to prevent a melted wire in case the plug shorted is the wrong plug.

To read the error codes from the engine computer, the mechanic is supposed to short pin 1 and pin 3 of the OBD port plug. Then the mechanic turns on the ignition switch and counts flashes of the "check engine" light to determine the error values being reported.

Posted on Sep 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel shut off switch for a 1995 Isuzu Rodeo


Isuzu Rodeo fuel cut off inertia switch Questions & Answers ...

www.fixya.com > ... > fuel cut off inertia switch > Cars & Trucks > Isuz
Isuzu Rodeo cars & trucks fuel cut off inertia switch questions and answers. Ask your Isuzu fuel cut off ... cut off inertia switch. Ad. Question about 1995 Rodeo.

Isuzu rodeo fuel cut off switch location - Fixya


Nov 26, 2015 | Isuzu Cars & Trucks

1 Answer

Firing order for 1995 isuze rodeo


1995 Isuzu Rodeo 3.2 liter SOHC V-6 (6VD1)

8e01b6e.gif


1995 Isuzu Rodeo 2.6 liter SOHC L4 (4ZE1)

5528056.gif

Hope helps (remember rated and comment this).

Aug 26, 2010 | 1995 Isuzu Rodeo

1 Answer

I need complete wiring diagram for 1995 isuzu rodeo willing to pay for the download


Here is a website that a free manual can be down loaded for your vehicle


http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717

May 01, 2010 | 1995 Isuzu Rodeo

1 Answer

Replace clutch kit


go with schucks cheap and good quality for instructions on how to change it go to autozone.com sign up its free then click on repair manuals you will find all of your info there....good luck

Apr 03, 2010 | 1995 Isuzu Rodeo

1 Answer

Where is the computer test port on a 1995 isuzu rodeo


This is straight from Haynes Repair Manual for 1989-1997 Isuzu Amigo/Rodeo/Honda Passport (book # 47017:
The 12 pin Assembly Line Data Link (ALDAL) terminal is located under the dash on the driver's side on 3.1L engines. To retrieve the trouble codes, connect a jumper wire to terminals A and B. It may be covered with a plastic cover. They suggest using a paper clip to jumper the two terminals-then turn ignition switch to ON position (NOT ENGINE START). Check engine light on dash will flash-one flash-a pause-then two short flashes-indicating code 12-diagnostic mode. After self checking-if there are any trouble codes-the light will flash proper codes using mentioned method.Note the flash code then call a shop with your info for what ails your Rodeo.

Mar 31, 2010 | 1995 Isuzu Rodeo

1 Answer

I need to find a diagram for a timing belt for a 1995 isuzu rodeo. I purchased the belt but am having trouble getting it placed on correctly.


We are talking about the Timing Belt and not the Drive/Surpentine Belt?

For the Timing Belt: CLICK on the following Link. It has all the Diagrams you will need for the Timing Belt.
http://www.2carpros.com/car_repair_information/year/1983/make/isuzu/model/pickup/1983_isuzu_pickup_timing_belt_diagram_marks.htm

For the Drive/Surpentine Belt: CLICK on the following Link. It has all the Diagrams you will need for the Drive/Surpentine Belt.
http://www.2carpros.com/car_repair_information/year/1995/make/isuzu/model/rodeo/1995_isuzu_rodeo_drive_belt_routing_diagram.htm

Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

Feb 27, 2010 | 1995 Isuzu Rodeo

1 Answer

Replace timing belton 1995 isuzu 3.2 V6


Click on the following direct Link. It has the Timing Belt Diagrams with Marks for the Camshaft and Crankshaft that you will need. It also has numerous other helpful diagrams for use.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!


http://www.2carpros.com/car_repair_information/year/1995/make/isuzu/model/rodeo/1995_isuzu_rodeo_timing_belt_diagram_marks.htm

Nov 23, 2009 | 1995 Isuzu Rodeo

1 Answer

Isuzu rodeo 2000 repair manual


go to autozone.com and register for full free online repair manual

Sep 11, 2009 | 2000 Isuzu Rodeo

1 Answer

Help replacing radiator support 1995 Isuzu Rodeo


chiltons from any parts store or haynes manual will help you out alot

Jul 15, 2009 | 1995 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

382 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14379 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...