Question about Lincoln Town Car
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1997 lincoln towncar
not neccessarly true there could be several reasons for the a/c clutch not to ingage. 1 the clutch relay is bad(it is located in the junction box under the hood,switch it with the heater relay if it kicks on the relay was bad) 2 the system is under charged(the binary switch will sense this and keep the compressor off) 3 a blown fuse fore the climate control(the fuse is located in the panel under the dash on the drivers side) there is a blockage in the system(this will cause the high side pressure to rise to a point where the high pressure switch cuts the circuit. My suggestion is to first check that the wire going to the a/c clutch is not coroded or broken. then check the relay, then have the system recharged provided that there are no leaks. if the guages when hooked up initially show that the low side pressure is 35 psi and the high side is 130-150 psi then you know it was an electrical problem. if those are not the pressure it could be a blockage (most likely in the drier) or the expansion valve is bad( this regulateds the system. hope these options are of help to you good luck and please rate this thanks
Posted on Sep 06, 2008
Is the noise coming from wiper area when you are driving on the highway? If it is the most likley solution is to replace the plastic peice at the bottom of the windshield that goes all the way across, on the outside between windshield and hood. when the wind hits it it makes noise.
Posted on Jan 01, 2009
Open the hood and make sure the car and the lights are off.
Remove the plastic protective cover.There are 3 knobs,turn halfway and pull.Put aside and out of the way.
Remove the three pins that are holding the light assembly in place.These are flat rods with a little bend at the end.
Twist and un-plug the lights,now you can remove the whole lens.
The light bulbs can also be removed and replaced from this point.
Make sure all the bulbs are working before you put it back together.
Posted on Mar 13, 2009
Tips for a great answer:
Apr 09, 2015 | 2001 Lincoln Town Car
Jan 24, 2015 | Lincoln Cars & Trucks
Feb 26, 2013 | 1998 Lincoln Town Car
Aug 11, 2011 | 1997 Lincoln Town Car
Sep 10, 2010 | 1997 Lincoln Continental
Jul 18, 2010 | 1997 Lincoln Town Car
Dec 06, 2009 | Lincoln Town Car Cars & Trucks
Mar 10, 2009 | 2004 Lincoln Town Car
Nov 17, 2017 | Lincoln Cars & Trucks
34 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: