Question about 2006 Ford Ranger

1 Answer

No heat in 2006 ford ranger could it be thermostat?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 480 Answers

The thermostat is the easyest place to start with but im betting on a pluged heater core your gonna have to back flush the heater core take off the hoses to the heater and some how connect a garden hose then slowly turn the water on watch and observe anything coming out.

Posted on Oct 22, 2010

  • Alvin DePauw Oct 22, 2010

    It turned out to be problems with the blender door actuator.

  • minneman61 Jan 21, 2011

    starting with the thermostat 2-morrow and the core next, but has NO leakage? What could block the hoses with clean fluid in the system?



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2006 ford ranger with automatic transmission downshifts going uphill

It would at first blush appear this would be because you are going at a sufficiently low speed and/or the load is that great that it needs a lower gear for the torque needed to apply to offset that load.

Sep 21, 2014 | 2006 Ford Ranger 3.0

1 Answer

What would cause a 1994 Ford Ranger to heat to the L of 'NORMAL' on the gauge after a new thermostat was installed? It has never been past the r/m consistently.

if it is a genuine ford ranger thermostat it should be the same, however if it is an after market one (non genuine ) that may be the problem as thermostats have different "start to open" & "fully open" temperatures......hope this helps......cheers.

Aug 26, 2011 | 1994 Ford Ranger Supercab

1 Answer

I have a 2006 Ford Ranger and the heat is stuck on on. Even when I move the handle to cool it still heats. Do you have any suggestions, thanks Al Shults.

This problem is caused by one or both of the following parts, one is the air temperature control blend door actuator motor, the next is the actual blend door, the shaft that the electric actuator moves is snapped off due to the door binding, both problems cause no air temperature control and you either get heat or cold with no control to change it. The problem is very common in the Ranger and the Explorer.

Dec 27, 2010 | 2006 Ford Ranger

2 Answers

No heat in cab in ford ranger 2005 tied heater

check if both heater hoses going into firewall are hot.. if only one is hot then your heater core is stopped can take both lines loose and take a water hose and back flush,,, force hose on one inlet of heater core for a minute and then the other.. keep going to you get a good flow...make sure heater valve is open, not just valve position take loose and confirm clear..last make sure your thermostat is not stuck open keeping engine from comming up to temperature

Jan 04, 2010 | 2005 Ford Ranger

1 Answer

Ford ranger 2002 6 4.0 LTR truck over heating.

The water is from the thermostat housing, fairly common leak. The ticking maybe from the timing chain cassette. You may have already had the cam timing slip (the cam gears are not keyed, they are held in place by torque alone. The oil gauge sounds like an electrical problem (either sender or sender wiring).

Oct 24, 2009 | 2002 Ford Ranger Regular Cab

1 Answer

Heater is blowing luke warm heat

Double checking, does fun shut off when switched to heat instead of defrost?

Jan 24, 2009 | 1993 Ford Ranger SuperCab

1 Answer

On heat

could be an air lock to heater radiator

Nov 21, 2008 | 1983 Ford Ranger

2 Answers

2006 polaris ranger 6x6 700 efi fan wont turn on

how to change a thermostat in a polaris ranger XP 700 2006 model

Jul 23, 2008 | Ford Ranger Cars & Trucks

Not finding what you are looking for?
2006 Ford Ranger Logo

Related Topics:

614 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5675 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides