Question about Ford Escape

Open Question

Looking for rear drum brake diagram for 2005 for escape

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76649 Answers

SOURCE: looking for diagram of rear brakes - doing brake job

Pull both wheels off, do one at a time, use the other side as a guide to put it back together, I am a retired auto mechanic and this is the best way to do the job, also remember the larger shoe always goes to the back.

Posted on Aug 20, 2008

Ad
CMV9
  • 594 Answers

SOURCE: Brake drum 2005 Escape

here is a diagram on how to remove your brake drum. please do not forget to rate and comment about your experience with fixya today.

Removal & Installation
CAUTION Dust and dirt accumulating on brake parts during normal use may contain asbestos fibers from production or aftermarket brake linings. Breathing excessive concentrations of asbestos fibers can cause serious bodily harm. Exercise care when servicing brake parts. Do not sand or grind brake lining unless equipment used is designed to contain the dust residue. Do not clean brake parts with compressed air or by dry brushing. Cleaning should be done by dampening the brake components with a fine mist of water, then wiping the brake components clean with a dampened cloth. Dispose of cloth and all residue containing asbestos fibers in an impermeable container with the appropriate label. Follow practices prescribed by the Occupational Safety and Health Administration (OSHA) and the Environmental Protection Agency (EPA) for the handling, processing, and disposing of dust or debris that may contain asbestos fibers.

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove the tire and wheel assembly.

    CAUTION Use of a brake drum puller or a torch is not recommended. Brake drum distortion can result.

    NOTE If the brake drum is rusted to the axle shaft pilot diameter, tap the center of the brake drum between the wheel studs.
  3. Remove the brake drum.
  4. If equipped, remove the brake drum retaining clips.
  5. If the brake drums will not come off, follow these steps.
  6. Move the brake shoe adjusting lever off the brake adjuster screw.
  7. Loosen the brake shoe adjuster screw nut by adjusting the nut upward.
  8. Using the special tool, 134-R0191, measure the brake drum inside diameter.
  9. Install a new brake drum if the maximum inside diameter exceeds the specification shown on the outside of the brake drum.
    67197-esca-g51.gif Drum brake exploded view
To install:

WARNING Whenever a wheel is installed, always remove any corrosion, dirt or foreign material present on the mounting surfaces of the wheel or the surface of the wheel hub, brake drum or brake disc that contacts the wheel. Installing wheels without correct metal-to-metal contact at the wheel mounting surfaces can cause the wheel nuts to loosen and the wheel to come off while the vehicle is in motion, causing loss of control. Failure to follow these instructions may result in personal injury.

  1. Clean the wheel hub mounting surface and wheel pilot.
  2. Install the tire and wheel assembly.

Posted on Apr 16, 2009

  • 20 Answers

SOURCE: how to remove rear brake drums on 2002 frod escape

Behind the brake mounting plate there is a small hole with a rubber plug on the top portion.

Remove the plug. Look from the back of the vehicle and you will see a star wheel in the hole. Stick

a long skinny screw driver with a large blade and rotate it in the direction of risistance.(clockwise).

You will hear a spring poping noise. Rotate a few times and the drums will turn freely.

Then you can slide the drums off.

Posted on Jul 04, 2009

  • 512 Answers

SOURCE: I need a diagram for the rear drum brake for 2002 Ford Ranger

Copy and paste this into your search window: 2002 ford ranger rear brake diagram

You should see four pictures pop up, select the brake parts diagram or the brake picture.

Posted on Sep 03, 2009

canbruce75
  • 1776 Answers

SOURCE: brake diagram and rear drums diagram for 2001

Visit the autozone.com website and register the car information. It's free and will give you access to an online repair manual for the car. Information regarding the braking system should be available there. It's a handy resource. Hope this helped and best wishes.

Posted on Sep 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I need a diagram for rear drum brakes on a 2005 kia sedona van


I have Pictures of my Kea Sedona rear brake assembly and drum I can send you, if this helps or tell me what information your after regarding the rear brake assembly.

AHR

Feb 22, 2015 | 2005 Kia Sedona

1 Answer

Copy and paste this into your search window: 2002 ford ranger rear brake diagram


sounds like you have it apart and not so sure about reassembly. If these are drum brakes try looking at the drum brake change videos on Youtube, ericthecarguy (ETCG) is a good one. Drum brakes are all basically similar with the main difference usually around self adjusters.

Sep 02, 2014 | Cars & Trucks

1 Answer

Rear brakes for 2005 pontiac vibe


try going to autozone website and look up the rear drum brakes and usually they have a diagram link on the right hand side . sorta not bad diagrams on a few things

Nov 25, 2011 | GMC Cars & Trucks

1 Answer

I broke two tire bolts on the rear tire how do we take off the brake drum to change them i tried banging it wont come off


Tapping on the sides is the way. Make sure the hand brake is off. Adjust the brake shoes to loose so that they are not in contact with the drum then tap the outside of the drum while pulling out the opposite side. Do that along the whole circumference of the drum and you will see it coming off.

Sep 22, 2011 | 2005 Ford Escape

1 Answer

How do I get the rear brake drums off my 2005 Ford Escape. Cannot see any hole in bake to turn adjuster?


They may just be froze on. I hvae had to take a small sledge hammer to knock my hubs off before

Mar 19, 2011 | 2005 Ford Escape

1 Answer

How to remove rear brake drums on 2002 frod escape


Behind the brake mounting plate there is a small hole with a rubber plug on the top portion.

Remove the plug. Look from the back of the vehicle and you will see a star wheel in the hole. Stick

a long skinny screw driver with a large blade and rotate it in the direction of risistance.(clockwise).

You will hear a spring poping noise. Rotate a few times and the drums will turn freely.

Then you can slide the drums off.

Jun 27, 2009 | 2002 Ford Escape

1 Answer

Brake drum 2005 Escape


here is a diagram on how to remove your brake drum. please do not forget to rate and comment about your experience with fixya today.

Removal & Installation
CAUTION Dust and dirt accumulating on brake parts during normal use may contain asbestos fibers from production or aftermarket brake linings. Breathing excessive concentrations of asbestos fibers can cause serious bodily harm. Exercise care when servicing brake parts. Do not sand or grind brake lining unless equipment used is designed to contain the dust residue. Do not clean brake parts with compressed air or by dry brushing. Cleaning should be done by dampening the brake components with a fine mist of water, then wiping the brake components clean with a dampened cloth. Dispose of cloth and all residue containing asbestos fibers in an impermeable container with the appropriate label. Follow practices prescribed by the Occupational Safety and Health Administration (OSHA) and the Environmental Protection Agency (EPA) for the handling, processing, and disposing of dust or debris that may contain asbestos fibers.

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove the tire and wheel assembly.

    CAUTION Use of a brake drum puller or a torch is not recommended. Brake drum distortion can result.

    NOTE If the brake drum is rusted to the axle shaft pilot diameter, tap the center of the brake drum between the wheel studs.
  3. Remove the brake drum.
  4. If equipped, remove the brake drum retaining clips.
  5. If the brake drums will not come off, follow these steps.
  6. Move the brake shoe adjusting lever off the brake adjuster screw.
  7. Loosen the brake shoe adjuster screw nut by adjusting the nut upward.
  8. Using the special tool, 134-R0191, measure the brake drum inside diameter.
  9. Install a new brake drum if the maximum inside diameter exceeds the specification shown on the outside of the brake drum.
    67197-esca-g51.gif Drum brake exploded view
To install:

WARNING Whenever a wheel is installed, always remove any corrosion, dirt or foreign material present on the mounting surfaces of the wheel or the surface of the wheel hub, brake drum or brake disc that contacts the wheel. Installing wheels without correct metal-to-metal contact at the wheel mounting surfaces can cause the wheel nuts to loosen and the wheel to come off while the vehicle is in motion, causing loss of control. Failure to follow these instructions may result in personal injury.

  1. Clean the wheel hub mounting surface and wheel pilot.
  2. Install the tire and wheel assembly.

Apr 16, 2009 | 2005 Ford Escape

1 Answer

2005 Escape starter replacement


take the negative side off the battery put the car on ramps secure the rear end so it does not roll and if you need a diagram for removing and installing the starter try autozone

Jan 17, 2009 | 2005 Ford Escape

2 Answers

Removal of rear brake drum 2002 ford escape


make sure handbrake is off take wheel off hit the drum with a mallet not steel,as it will brake,hit on outter diametter face of drum, try and rotate as you twist off

Jan 05, 2009 | 2002 Ford Escape

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...