Question about 1997 Mitsubishi Diamante

1 Answer

Low coolant warning light on

Radiator full, reserve container full. Where is sensor located, to be removed, and replaced?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 975 Answers

Coolant sensor is usally located where the thermostat is , the upper hose from radiator to the thermostat at engine block , hope it helps AJ

Posted on May 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Coolant


If you are talking about the low coolant warning light, be sure and check the radiator along with the overflow tank.
If the cooling system is full, the sensor has failed.

Jun 06, 2013 | 1993 Lexus Es 300

1 Answer

The little red water level gauge stays on


The red square shaped warning dash light is an image of a crudely drawn radiator indicating that you are low on coolant. Topping up your coolant bottle reservoir located on the passenger side above the wheel should clear up your issue. If your coolant level is full and is still indicating low coolant via dash warning light, you could possibly have a sensor out in the radiator or air bubbles in your coolant lines that need to be bled out.

May 01, 2013 | 1996 Pontiac Sunfire

2 Answers

Looking for the fill plug on a 200 dodge darango 4 wheel drive front punkin all i see is a vent pipe


COOLANT-ADDING ADDITIONAL
Do not remove radiator cap to add coolant to system. When adding coolant to maintain correct level, do so at coolant reserve/overflow tank. Use a 50/50 mixture of ethylene glycol antifreeze containing Alugard 340-2 y and low mineral content water.
Remove radiator cap only for testing or when refilling system after service. Removing cap unnecessarily can cause loss of coolant and allow air to enter system, which produces corrosion.

COOLANT LEVEL CHECK
The cooling system is closed and designed to maintain coolant level to top of radiator.
WARNING: DO NOT OPEN RADIATOR DRAINCOCK WITH ENGINE RUNNING OR WHILE ENGINE IS HOT AND COOLING SYSTEM IS UNDER PRESSURE.
Remove radiator cap. The coolant level should be to top of radiator. If not, and if coolant level in coolant recovery bottle is at ADD mark, check for:
  • An air leak in coolant reserve/overflow tank or its hose
  • An air leak in radiator filler neck
  • Leak in pressure cap seal to radiator filler neck
TRANSMISSION and OIL LEVEL CHECK TUBES
pctech1_27.jpg

Mar 04, 2011 | 2000 Dodge Durango

1 Answer

1998 buick century low coolant light keeps flashing after I filled overflow container-radiator is full


Change the low coolant sensor. It is located on the radiator. It might be a good idea to get the radiator flushed too.

Feb 16, 2011 | Buick Century Cars & Trucks

1 Answer

Low coolant light stays on. added coolant and is still on.


Did you add the fluid to the Radiator or the Overflow container. The radiator should be full and the overflow container should have a mark on it for full. Make sure both are full. If they are then you most likely have a bad sensor that you will need to locate and replace.

Aug 08, 2010 | 1998 Cadillac DeVille

3 Answers

Where is the drain plug for the radiator


Should be a drain **** at the bottom of the radiator that unscrews out. It looks like a wing nut has been welded to a bolt on the end of it. Another way to do this is just pull off the bottom hose.

Mar 31, 2010 | 2001 Jeep Cherokee

1 Answer

Replaced water pump, alternator, radiator, crank sensor and no coolant leaks and car has antifreeze, but why is low coolant dashboard indicator light keep flashing on 97 saturn sl2


Inside the coolant reserve tank there is a sensor for coolant level.


Over time,this sensor can get stick.


Inspect the coolant reserve tank for crack or leak.

Locate the coolant level switch/sensor and soak it in clean warm water.

Make sure it's free to move up and down the float path.

Top off the coolant tank with coolant only.



Dec 02, 2009 | 1997 Saturn SL

2 Answers

Where is the thermostat sensor


Both the 4.0L and 4.7L engines use 195� thermostats for all model years from 1999-2004. When replacing a thermostat it is very important to install one with the same temperature rating (the only exception might be with certain performance modifications or chips that recommend or require a different temperature thermostat).

4.0L engine - Draining the cooling system WARNING: DO NOT REMOVE THE CYLINDER BLOCK DRAIN PLUGS OR LOOSEN THE RADIATOR DRAINCOCK WITH SYSTEM HOT AND UNDER PRESSURE. SERIOUS BURNS FROM COOLANT CAN OCCUR.

1. DO NOT remove radiator cap first. With engine cold, locate radiator draincock on the right lower side of radiator facing to rear of vehicle.
2. Attach one end of a hose to the draincock. Put the other end into a clean container. Open draincock and drain coolant from radiator. This will empty the coolant reserve/overflow tank. The coolant does not have to be removed from the tank unless the system is being refilled with a fresh mixture. When tank is empty, remove radiator cap and continue draining cooling system. To drain the engine block of coolant, remove the cylinder block drain plug, located on the side of cylinder block below the exhaust manifold.

4.0L engine - refilling the cooling system Coolant recommendations and cautions: The recommended mixture is 50/50 ethylene-glycol and low mineral content water. Never use pure antifreeze. Only Mopar Antifreeze Coolant, 5 Year/100,000 Mile Formula (glycol base coolant with corrosion inhibitors called HOAT) is recommended. This coolant offers the best engine cooling without corrosion when mixed with 50% distilled water. Antifreeze mixture must always be at least 44%, all climates year round. Maximum protection (-90d) is provided with a 68% mixture protection. If the percentage is lower than 44 percent, engine parts may be eroded by cavitation, and cooling system components may be severely damaged by corrosion. CAUTION: Mopar Antifreeze/Coolant, 5 Year/100,000 Mile Formula (MS-9769) may not be mixed with any other type of antifreeze. Mixing of coolants other than specified (non-HOAT or other HOAT), may result in engine damage that may not be covered under the new vehicle warranty, and decreased corrosion protection.

CAUTION: Do not use coolant additives that are claimed to improve engine cooling. 4.0L coolant capacity: 1999-2000: 13.0 qts. (including 2.3 qts. for resevoir) 2001-2004: 15.0 qts. (including 1 qt. for resevoir)

1. Tighten the radiator draincock and the cylinder block drain plug(s) (if removed).
2. Fill system using a 50/50 mixture of ethyleneglycol antifreeze and low mineral content water. Fill radiator to top and install radiator cap. Add sufficient coolant to the reserve/overflow tank to raise level to FULL mark.
3. With heater control unit in the HEAT position, operate engine with radiator cap in place.
4. After engine has reached normal operating temperature, shut engine off and allow it to cool. When engine is cooling down, coolant will be drawn into the radiator from the reserve/overflow tank.
5. Add coolant to reserve/overflow tank as necessary. Only add coolant to the reserve/overflow tank when the engine is cold. Coolant level in a warm engine will be higher due to thermal expansion. To purge the cooling system of all air, this heat up/cool down cycle (adding coolant to cold engine) must be performed three times. Add necessary coolant to raise tank level to the FULL mark after each cool down period.

For more details, you can refer to the Jeep WJ Service Manual Section-07-Cooling-System-Ewj7

Hope helped.

Nov 02, 2009 | 1999 Jeep Grand Cherokee

2 Answers

Low coolant light is on with full radiator


Check the coolant top up reservoir. Low coolant sensor is usually in the overflow/reserve container.
Wash out and clean any dirt or corrosion from the sensor prong.
Refill to correct level with fresh coolant, then recheck alarm operation.

Jul 17, 2009 | 1997 Pontiac Sunfire

3 Answers

I have a 1998 chevy caviliar and this light keeps coming. it has a arrow with water underneith what is that


1 IT IS OVER HEATING 2. THE RESERVE IS LOW NO COOLANT OR A DEFECTIVE SENSOR I THE RESERVE TANK

Dec 04, 2008 | 1998 Chevrolet Cavalier

Not finding what you are looking for?
1997 Mitsubishi Diamante Logo

Related Topics:

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...