Question about 2000 Chevrolet Impala

Open Question

I have a 2000 chevy impala 3.8, it cranks but wont start. it has no spark? what is causing this?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 341 Answers

SOURCE: 98 chevy camaro wont start

check fuel pressure regulator

Posted on Dec 06, 2008

Ad
  • 2 Answers

SOURCE: 2000 chevy pick up died while driving and won't restart?

check the crank angle sensor

Posted on Jan 03, 2009

  • 93 Answers

SOURCE: 1996 chevy impala ss

the spark on your engine is controled by a componet called "opti-spark" it is located behind the water bump. it acts as your distribitor and ignition coil. they are a bit time consuming to change out and are very expensive! i would suggest having your local chevrolet dealer diagnose it just to be sure due to the expense involved for this unit. i hope this helps you..good luck

ps as i recall from my chevy dealership days, i beleive it was around $1000 installed..but that was a few years ago..proice could change either way now..

Posted on Jun 17, 2009

  • 10 Answers

SOURCE: 2000 chevy impala a/c low pressure port

PASS SIDE BY THE DRYER NEAR FIRE WALL.

Posted on Jun 28, 2009

  • 1 Answer

SOURCE: Replaced ignition switch 2003 chevy impala and car will not start

After you replace the ignition switch turn the key to start the car and release leave the key were it stops after trying to start wait 10 minutes until security light goes out turn key to full off position then repeat the above procedure two more times for a total of three on the 3rd attempt to start car wait for light to go out then turn key to full off positoion wait 10 seconds then try to start car body control module should learn new pass code and the car should start.
Big john, J@J Automotive

Posted on Mar 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Chevy impala wont start


Pretty sure I know your issue... Its really common in gm cars.. It happened to my buick.. I found a site that has the fix I even did it myself.. when I took it to the mechanic they were trying to charge me 400+.. read over it Im sure it will help

Aug 24, 2014 | 2002 Chevrolet Impala

1 Answer

P1374 code on 2000 chevy venture


This a code for ignition system The 3x pulse is not being received from the crank shaft 18x sensor Very complex testing to correct this problem. Ignition module and crank shaft and cam shaft sensors must agree for the computer to control injection timing and spark advance

Apr 28, 2014 | 2000 Chevrolet Impala

1 Answer

Chevy impala cuts off while driving


Check for any stored engine codes, this may give you an idea of any problems that may cause your complaint. Possible crank position sensor, cam position sensor or ignition module would cause a 'die in flight' situation.

Dec 22, 2013 | 2005 Chevrolet Impala

1 Answer

2003 Chevy Impala wont start


does the engine crank. if the engine cranks ,then it is not the start.there is 3 things to start a car fuel.spark and air. is there a buzzing noise in the gas tank when you turn the key that would be the fuel pump working. now we need to know if you have spark to the ignition coils .this is my link to my garagehttps://www.facebook.com/TedsRepairs

Nov 11, 2012 | 2003 Chevrolet Impala

1 Answer

2000 Chevy Impala smells like gas


Check under the hood on the side of the fuel rail, the fuel pressure regulator value, this is a common problem.

Oct 27, 2017 | 2000 Chevrolet Impala

1 Answer

2002 chevy impala having intermitten starting issues


As with any no start issue, someone will have to figure out if you are dealing with a no spark or no fuel problem to proceed.
If you have to rely on a shop they may have to keep the car for a few days to track down the problem.

Aug 09, 2012 | 2002 Chevrolet Impala

1 Answer

I have a 2000 Chevy Impala and my car only stay crank if my foot is on the gas, when I release , it shuts off. It's not the mass air flow sensor or fuel pump what can it be??


Inspect, clean or replace the Idle Air control valve...about $35 for the part...also how is the air filter? A clogged catalytic converter can cause this too? ( A free check at quality muffler shops. Hope this helps.

Mar 16, 2012 | 2000 Chevrolet Impala

1 Answer

Spark plug diagram for a 2000 Chevy Impala


buy a hanes repair manual and it will have the diagram in it

Mar 20, 2010 | 2000 Chevrolet Impala

1 Answer

2000 Impala:Hard start and couple times Idles extremly high


The car has OBD2 technology, You wont be able to tell without special tools. The ignition components, timing, CKP & CMP sensor, fuel line pressure, misfires, and fuel quality all need to be looked at. But to answer your question, "over 3x cranking' could be timing or fuel pressure. A bad IAC would cause a rough idle, and if the injectors were bad then it would cause a misfire too.

Jun 03, 2009 | 2000 Chevrolet Impala

Not finding what you are looking for?
2000 Chevrolet Impala Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...