Question about 2005 Volkswagen Microbus

Open Question

Remove l/h sliding door handle on vw transporter van 2007

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 341 Answers

SOURCE: Replacing exterior door handles 1998 Safari van

remove door panel.. inside door you will see a rod going to the handle..on the end is a clip ..push the clip up off the rod .slide the rod out..remove 2 ..13mm nuts from handle ..remove handle

Posted on Nov 14, 2008

Ad
  • 94 Answers

SOURCE: Retiming of vw transporter diesel pump

This requires the use of a special VW tool called "the indicator tool". Visit this site to buy it:

http://www.partsplaceinc.com/catalog/vw-specialty-tools-diesel-tdi-timingtools55.shtml

You will also need to buy a repair manual for your car so you can get the appropriate timing setting for the pump. I recommend the Bently manual:

http://www.bentleypublishers.com/vw/eurovan/1992-2003/VW-Eurovan-92-99-Factory-Repair-Manual.html

It's expensive but worth it. If you don't want to spend that much, you may find pump timing information in a Haynes or Chilton manual which can be purchased on Amazon or at your local Autozone.

Good luck.

Posted on Jul 08, 2009

  • 548 Answers

SOURCE: dodge caravan sliding doors

First, keep in mind that as you begin to remove these doors you run the risk of causing serious scratches to the paint and glass, so put some masking tape and/or plastic sheeting around both sides of the door (rear quarter panel and rear glass, front door and front door glass)
I would get a Haynes repair guide since that's what I have to work from and it will tell you step by step with pictures, what to do. It's not hard, but you need to get all of the attach points unhooked to be successful. Suggest you have a helper working with you to keep the door steady.

Posted on Jan 25, 2009

Ajkill
  • 2035 Answers

SOURCE: broken exterior door handle,passenger sider ,sliding

Front

  1. Close the front door glass completely.
  2. Disconnect the negative battery cable.
  3. Remove the door screen.
  4. Disconnect the front door lock actuator connector.
  5. Disconnect the rods and the cables.
  6. Remove the screws, and remove the front door lock.
  7. Remove the screws, and remove the front door lock actuator from the front door lock.
  8. To install, reverse removal procedure.
Sliding Door
  1. Close the front door glass completely.
  2. Disconnect the negative battery cable.
  3. Remove the door screen.
  4. Disconnect the sliding door lock actuator connector.
  5. Disconnect the rods and the cables.
  6. Remove the bolts, and remove the sliding door remote controller.
  7. Remove the screws, and remove the sliding door lock actuator from the sliding door remote controller.
  8. To install, reverse removal procedure.

Posted on Jan 26, 2009

  • 5 Answers

SOURCE: 1994 vw jetta drivers door window crank inside handle removal(man

You'll see a small ring on the inside of the crank where it meets the panel. That ring holds the crank in place. To remove the handle simple push the ring up and the handle will slide right off. Depending on the position of the crank the ring might have to be pushed up down or sideways. Hope that helps.

Posted on Feb 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the door panel on the sliding door of my 2013 Volkswagen Routan?


remove the handle by unscrewing the big phillips head screw.
Carefully pry the vents at the bottom of the door
with the sliding door open halfway carefully slide the panel off the door in the direction of the front of the van

Aug 15, 2016 | Volkswagen Cars & Trucks

1 Answer

Drivers door wont open vw t4 transporter van 1990. mecanism wont work


Well your going to have to remove the door panel to fix it. Your options are, remove the drivers seat to get the door panel off. Or break the door panel into pieces. I'd remove the seat.

Dec 27, 2014 | Cars & Trucks

1 Answer

How to remove exterior door handle 2011 vw jetta


Open door and look where striker is,just above striker towards outer door is a black plastic insert,remove that,looking inside the smaller hole is a little black bar,with a hook pull bar towards yourself,will only move very little,then go to outside of door and pull handle out like to open,and pull the stationary part of handle out,let go of handle,slide handle out towards back of vehicle.

Jan 18, 2012 | Volkswagen Jetta Cars & Trucks

1 Answer

Need to remove outer door handle on an 2009 vw cc.


you need to remove the inner door panel,, you will see a sheet of plastic under that ,, peel it away , look inside the holes on the inner metal door structure,, towards the outside handle,, you will see connecting rods that control the functions, they are held on with little plastic clips,, remove those from the handle side , ( the piece you want to take off, ) there should either be one small bolt head , ( possibly 2 one on each side, the one with just one, has a tab that slides into place on that one) remove that bolt, and the handle will slide off to the outside of the vehicle , make sure to make a note of where each rod goes, and the clips that hold them,

Sep 23, 2011 | 2009 Volkswagen CC

1 Answer

I recently purchased a used 03 Chevy Venture van. The passenger sliding door doesn't open. It worked for 1 week and stopped. The driver side sliding door has a broken handle so I'm able to open that door...


Pain but fixable. Sounds like the linkage is not connected. Even a mechanic will have to remove the door panel and fight with it. If you can remove the rear seat from the drivers side side door then you might have room to remove the passenger side door panel to fix it. Usually clips are the first thing to break on door handle/latch linkages

Apr 06, 2010 | 2003 Chevrolet Venture Passanger

1 Answer

Rear door on 2001 sienna won't open


The door handle might be broken, you need a new part. I got mine online for $40. keywords: 2001 2002 2003 2004 2005 2006 2007 Toyota Sequoia Metal Lift Gate Exterior Door Handle for Rear Outside Van Tailgate Handle. You need to remove the back door panel to replace this.

Mar 06, 2010 | 2001 Toyota Sienna

1 Answer

Dismount door panel VW Golf


To remove the external door handle is not nessecery to dismount the door panel. Just follow my instruction: Open the door. Above the latch you will find small round plastic cover 1 inch of diameter.Remove it.There is screw T35 or T40 head/judish star/.Unscrew.Than slide the handle to the right about 1cm.Carefully pul out left side.That is it.

Jan 14, 2010 | 2001 Volkswagen Golf

1 Answer

Rear door will not open on my 2007 Ford Fusion. It won't open from the inside or the outside. I removed the interior door panel and can look inside the door. I can see the mechanism for the outside door...


use the fob and keep clicking unlock/lock button see if everything is moving.then try banging outside of the door about 6 inches from door handle while pressing unlock.has worked on some other cars like vw audi and vauxhall

Dec 30, 2009 | 2007 Ford Fusion I4 SEL Sedan

1 Answer

Broken door handle - 2001 Nissan Quest SE


first you van order parts at discount from tascafordparts.com.
quest & mecrury villager are the same vehicle made at the same assembly plant. good luck to all. If you were in detroit area, I wold help you.

Trim Panel —Sliding Door Removal
  1. Remove the sliding door trim panel finish panel.
532ac84.gif 2. Remove the sliding door trim panel 2965fbe.gif Latch Remote Control —Sliding Door Removal
  1. Remove the rear sliding door trim panel. For additional information, refer to Section 501-05 .
  1. Position the watershield aside.
  1. If equipped, disconnect the sliding door power door lock actuator electrical connector.
f373e91.gif
  1. NOTE: Mark the position of the sliding door rear latch cable adjusting bracket before removing the bolt.
  2. Disconnect the sliding door rear latch cable.
  3. Remove the bolt.
  4. Remove the sliding door rear latch cable adjusting bracket from the latch remote control.
  5. Disconnect the sliding door rear latch cable from the latch remote control.
b8f2f32.gif
  1. Remove the 4 sliding door front latch bolts.
NOTE: If necessary, transfer parts to the new sliding door latch remote control.
Remove the sliding door latch remote control.
  1. Remove the bolts.
  1. Remove the sliding door latch remote control.
cb5ee71.gif
Handle —Exterior, Sliding Door Removal
  1. Remove the sliding door latch remote control. For additional information, refer to Latch Remote Control—Sliding Door .
  1. Remove the sliding door exterior handle.
    1. Remove the nuts.
    1. Remove the sliding door exterior handle.
0c820f3.gif

Mar 08, 2009 | 2001 Nissan Quest

1 Answer

Replacing exterior door handles 1998 Safari van


remove door panel.. inside door you will see a rod going to the handle..on the end is a clip ..push the clip up off the rod .slide the rod out..remove 2 ..13mm nuts from handle ..remove handle

Nov 14, 2008 | 1998 GMC Safari

Not finding what you are looking for?
2005 Volkswagen Microbus Logo

Related Topics:

1,208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8560 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...