I need the firing order and the diagram for a 2002 ford taurus

SOURCE: firing order

Hi..
Your 00 taurus 24v,
Use a Direct ignition, It's mean COIL on PLUG.
Each cylinder use one coil.
The firing order is ; 1-2-3-4-5-6..
The cylinder 1-2-3 are located at the FIREWALL side, starting from the Belt Side..
4-5-6 are Located at the Radiator side, starting from the belt .

Tom Shanks

• 141 Answers
• Posted on Sep 29, 2009

SOURCE: whats firing order diagram of 2002 ford escape v6

Ford V6's - rear bank of cylinders are 1 - 2 - 3. Front bank are 4 - 5 - 6 starting from passenger side (front) of engine.
Your firing order is
1 - 4 - 2 - 5 - 3 - 6

You're welcome.

SOURCE: firing order diagram for 1986 ford ranger

you will find this site usefull , here is the diagram for 1986 ford ranger 2wd 2.9liter v6 firing order .

http://www.autozone.com/N,26200242/shopping/specsSelect.htm

Fix Ya vote is my Reward , thanks .

Greg Bernett

• 2993 Answers
• Posted on Jul 04, 2009

SOURCE: 2002 ford taurus wtaer pump

Removal & Installation 3.0L (2V) To Remove:

1. Drain the engine cooling system.
2. Loosen the water pump pulley.
3. Remove the bolt and the nut and position the roll restrictor bracket out of the way.
4. Remove the accessory drive belt.
5. Remove the generator.
6. Remove the bolt and the accessory drive belt tensioner.
7. Remove the nut, the bolt and the support bracket.
8. Remove the bolts and the water pump pulley.
9. Disconnect the water pump inlet hose and the crankshaft position sensor electrical connector.
10. Remove the bolts and the water pump, and clean the sealing surfaces

1. Install the water pump. Tighten bolts in the sequence shown:
1. Tighten numbers 1-7 to 18 ft.-lbs. (25 Nm)
2. Tighten numbers 8-12 to 89 in.-lbs. (10 Nm)
3. Connect the crankshaft position sensor electrical connector and the water pump inlet hose
4. Install the support bracket.
5. Install the accessory drive shaft tensioner.
6. Install the generator.
7. Install the roll restrictor bracket, bolt and the nut.
8. Install the water pump pulley.
9. Install the accessory drive belt.
10. Connect the battery ground cable.
11. Fill the engine cooling system.

SOURCE: looking for firing order diagram for 2002 ford

2.0L SOHC
2.0L DOHC