Question about 1999 Chrysler 300M

1 Answer

I started my car (2002 Chrysler 300M) this morning. It ran for a few seconds then died. I started it two more times with similar results. Then all of a sudden the starter won"t turn over at all. I have full battery power. Help!

Posted by on

  • prayboca Oct 02, 2010

    Okay. I went and held the key in the on position for about 30sec, moved the gear selector to drive then back to park. the headlights came on then the car started. The car ran normally. I turned the ignition off then restarted and the same sequence as before occurred. Could the fuel pump be going?

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

It sounds like to me that the starter did in fact go out. but as for the car dieing twice, that sounds like you have a different problem

Posted on Oct 02, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2002 chrysler 300m with a 3.5. I started it this morning and it ran rough. I hit the gas and it cleared out. It ran for 5mins then shut off and smoke was coming from under hood. I checked and one...


check for fuses to the ECM
code p2008 refers to intakemanifold air control actuatoror solenoid bank 1---open circuit====causes wiring open circuit--intake manifold air control actuator/solenoid
IF the coil was melted , it is possible that the wiring for the p2008 fault is in the same harness and has burnt through causing the open circuit. or melted out in the connection causing the open circuit.

Feb 21, 2015 | 2002 Chrysler 300M

1 Answer

Why isn't my 2002 Chrysler 300m not going into manual shift?


  • The linkage could be jammed. You may need to access the linkage by removing the console.
  • Sometimes shifting to drive and park a few times will release it.
  • Get a OBD reader hooked up and read any tranny faults.

Feb 18, 2015 | 2002 Chrysler 300M

1 Answer

Car dies without warning


The symptoms you describe are similar to what I experienced on a 1994 Fiat 900cc. Sometimes it would just die and immediately restart, just to die again. Other times it would surge, almost like a misfire. There were no dashboard lights or error codes.

I disconnected the electrical wire on the MAF (Mass Airflow Sensor) and the car ran pretty ok... so I then replaced the MAF.

Try cleaning your mass airflow sensor to see if that makes any difference. You'll probably find a video on Youtube.

The link below is a generic google search:
chrysler 300 maf Google Search

Mar 25, 2017 | 1999 Chrysler 300M

1 Answer

2001 Chrysler 300M treble, mid, bass Flashing Amber


You have to go to the dealer with your registration and they will give you the code for your radio but you will need a good battery you will need to leave your key on the acc side and wait for 15 min then put your code in

Dec 22, 2012 | 2001 Chrysler 300M

1 Answer

I have a 2002 crhysler 300m with a 3.5 high


Hello, Had the same problem but i did just the opposite I put a 2002 engine in a 2000. I found out that the cam sensor spocket (for the timing belt) Has the holes for the cam sensor in a different spots causing all kinds of problems also they did the same with the flex plate so I hope you took the one off the 2002 and used it or you will have to pull it back out and change it. Good luck

Nov 27, 2009 | 2002 Chrysler 300M

1 Answer

Chrysler 3.5 won`t rev past 2500 rpm?


remove the aircleaner intake hose and, check the intake air control flap for free movement

Apr 22, 2009 | 2002 Chrysler 300M

1 Answer

2002 chrysler 300 wont go into park


It sounds like your linkage is binding. Hold the brake down and shift between drive and reverse a few times and then into park. I had the same problem with my 2002 300m. It went away after working the shifter a number of times. DO NOT FORCE IT.

Apr 02, 2009 | 2002 Chrysler 300M

5 Answers

Starting issues 1999 chrysler 300 m


get a starting and charging system diagnostic. I am the owner of a 99 300M and I had a similar problem. It took about 3 months before my car would not start at all. But sometimes, I would get this clicking when turning the key in the ignition. It turned out to be a short in the starter. The starter and the alternator had to be replaced.

Jan 30, 2009 | 1999 Chrysler 300M

1 Answer

Dies at all diff times


Hello krh60, What i would suggest is opening your hood, disconnecting your battery and then cleaning the terminals. Typically when there is a bad connection (your terminals have oxidized) you may experience a dying motor. Of course there are many other solutions to this problem but this is what i suggest to start with. -Please post and let us know what you decide to do.

Nov 11, 2008 | 1999 Chrysler 300M

Not finding what you are looking for?
1999 Chrysler 300M Logo

Related Topics:

320 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...