Question about 2007 Dodge Ram Truck

Open Question

How do I remove my dash on 2007 dodge ram pickup to get at the radio

Posted by on

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1 Answer


The bezel around the radio and the two center a/c vents pops off pretty easily, just get a hook tool and start from a corner. Once off, there are 3 8mm bolts to be removed (2 on one side and 1 on the other side of the radio). Then just pull the radio out.

Posted on Apr 07, 2009

  • 75817 Answers

SOURCE: radio removal 1995 dodge ram pickup

Removal of the original unit is quite simple. Just remove the two phillips screws holding the cup holder in place and pull out the cup holder. Remove the two screws holding the ash tray in place and remove the ash tray. The entire front bezel on the dashboard can now be removed by grasping and pulling forward. It is held in just with clips at this point. Remove the leads from the auxilliary plug and cigar lighter. Using a socket set and a 10 mm socket, remove the two 10 mm bolts holding the head unit in place. Slide the head unit forward, disconnect the two flat wire connectors, the antenae, and the ground connection (requires 10 mm socket as well). The head unit can now be removed. Replacement head units direct from Dodge are VERY expensive as are repaired units which I haven't had very good luck with. Your best option is to try and find a used unit for a good price. Fitting an aftermarket system will be pricy and tricky as the original system utilized an external amplifier located in the panel behind the drivers seat (some models have other amp locations) and a component type speaker system. Good Luck!

Posted on Aug 10, 2009

  • 631 Answers

SOURCE: 1999 Dodge Ram 1500 Pickup error code p0171

This code means that system to lean, bank 1.
some of the possible causes to make this code set are
1. intake or exhaust leak,
2. problem with the air system.
3. MAF (Mass Air Flow sensor)VAF sensor (Volume air flow sensor)
4. fuel pressure/pump
5. injector(s)
6. HO2S (Oxygen sensor)

Posted on Sep 16, 2009

  • 548 Answers

SOURCE: Need to know how to remove dash from 1999 dodge

removing a dash is NEVER an easy task, and requires alot of hidden screws and clips and to try and explain it here would be almost impossible, but if you go to your local library and repair manual you can get pictures that you can copy or take the manual with you and it will be of great service in finding those hidden clips and screws and such

Posted on Sep 19, 2009

Testimonial: "thanks for the good information;it was very helpful. Don"

  • 593 Answers

SOURCE: Remove headlight assembly from a 2001 Dodge Ram

On the upper grill side of the headlight assy. there
should be 1 or 2 push pins that hold the seal on the
headlight assy to the front of the fender. Also check
for a guide/push pin on the inner top of the assy on
the outer fender side. That should be all there is to
hold the headlight in place. Hope this helps.

Posted on Apr 10, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Do you know where i can get some illustration for removing the dash cover from a 2001 Dodge Ram pickup truck

got to you tube and type in dashcap instructional to remove dash cover. You must have the infamous problem every other dodge ram owner (94-01) crack in dash cover. hope this helped

Jan 10, 2011 | Dodge Ram 1500 Cars & Trucks

1 Answer

How to remove the spare tire on my 2007 dodge ram hemi pickup truck?

on your rear bumper or just above it there should be an access hole that you can stick the jack handles through ,then you should be able to lower the tire, its like a winch unwinding

Sep 26, 2010 | 2007 Dodge Ram Truck

1 Answer

How to remove radio

just did 1 u gotta take the whole dash apart it a pain in the *** good luck

Feb 24, 2010 | 2009 Dodge Ram Pickup 1500

1 Answer

How do you remove radio from 2007 dodge ram 1500

the trim around the radio just pulls off and then the stereo is screwed in

Oct 04, 2009 | 2007 Dodge Ram Truck

1 Answer

Trying to find the cab filter 04 dodge ram pickup

everything i know about the truck indicates they dont have one

Aug 22, 2009 | 2007 Dodge Ram 2500 Mega Cab Laramie

1 Answer

Radio volume will not adjust.

Hello. If this is repairable, the radio will have to be removed anyways. Some radios can be removed with a butter knife. If you pry off the front dash panel, there will be 4 screws holding on the radio. If you don't have the 4 screw type look for and tabs on the radio that are pryed up on the insides, pry them down with butter knife. Pull out stereo and disconnect the clip on wire harness.

You can try blowing out the unit and the knob if you purchase a can of "Air Duster" (compressed air and c02 in can)
If this radio is equipped, remove screws and cover to gain access to inside. Blow out the entire unit, especially the knob. The knob should also come off to spray inside.

If cleaning doesn't help, I suggest going to the junk yard and get another one for $15, otherwise WalMart, Kmart, sell them for $35+

Jul 17, 2009 | 1996 Dodge Ram

1 Answer


The bezel around the radio and the two center a/c vents pops off pretty easily, just get a hook tool and start from a corner. Once off, there are 3 8mm bolts to be removed (2 on one side and 1 on the other side of the radio). Then just pull the radio out.

Apr 04, 2009 | 2004 Dodge Ram 1500

1 Answer

Radio installation in 1983 dodge ram van

remove screws from dash face, remove dash face. two 10mm bolts hold stereo in place,remove bolts, gently pull stereo out. unplug stereo. install new stereo by reversing the directions

Oct 19, 2008 | 1983 Dodge Ram Wagon

Not finding what you are looking for?
2007 Dodge Ram Truck Logo

Related Topics:

295 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides