Question about 1992 Mitsubishi 3000GT

1 Answer

Computer my verada 1992 has always had memory loss i have had coolant sensors put in and told the computer but it doesnt hold that memory . my brakes also dont work proply and have no dash lights for brake warning?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Mitsubishi Master
  • 1,224 Answers

Ok couple simple fixes
bad computer wareing out
reset computer at dealership
did you wire in new sterio cause if you did this can cause these elements
some wire vehicle harnesses run certain things threw a single wire i dont know why manufacture did this but it happens

Posted on May 26, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Doesn't overheat, but losses coolant. also has oil in resivior. heater doesnt blow hot air

sounds like bad head gasket or intake manifold need compression test thing that scares me is oil in water resivoir

Jan 10, 2014 | 1992 Cadillac DeVille

1 Answer

E320 starts but will eventually stall and wont turn on until 30 minutes to 1hour. put a fuel pressure gauge and when vehicle works goes up to 50 but when it doesnt turn on it wont show anything. told to...


The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.

Sep 19, 2012 | 1995 Mercedes-Benz E-Class

2 Answers

How are you supposed to add antifreeze to a 1997 Pontiac Grand Prix

the plastic jug is an overflow container when the vehicle gets warm excess coolant from the radiator flows to it there is a sensor somewhere on the jug or in it for coolant level if it doesnt hold coolant it is most likely cracked as it is only plastic and should be replaced

Aug 04, 2012 | 1997 Pontiac Grand Prix

1 Answer

I have a 92 wrangler 4 cyl. it only after warming up misfires and idles really rough. it doesnt do it when its cold. i have replaced the cap,rotor,plugs,wires,02 sensor,and coil. i was just on this site...

Well if it does it after warm up then yes it is more than likely a coolant temp sensor gone whacko or its the thermostat that may be stuck when trying to expand. Other than that the stuff that you replaced should have fixed it. Have a good one!

Feb 21, 2011 | 1992 Jeep Wrangler

2 Answers

1992 f250 occasionaly surges and dies when i stop at lights

there is a pressure feed back sensor going bad all the times
also check the two hoses connected to this sensor for crack or blockage
check the pipe that goes to the egr valve for crack
it won't hurt to pull the egr valve back out to check to see if there is any thing cause the valve to stay open

Mar 07, 2010 | 1992 Ford F250

2 Answers

Stalls while driving. no good reason from

you need to have the engine coolant switch checked,since the computer relies solely on sensors,the ect tells the computer how cold or hot it is so the computer will make it a rich or lean mixture to start the engine,if it tells the computer that it is 75 degrees the computer will lean the mixture like starting a car in the winter without a choke.

Jan 03, 2010 | 1992 Subaru Legacy

2 Answers

Where is the computer located in a 1992 isuzu amigo?

Because the ambient temperature is more likely to be tolerable for the semiconductors in your ECU, these4 are normally installed inside the passenger compartment, often under the dashboard.
It shouldn't be too difficult to locate, look for a box with a large number of wires in the connector(s) attached to it.

Oct 25, 2009 | 1992 Isuzu Amigo

1 Answer

Cooling fan always runs with ignition on

try putting the electrical connector on the other way

Jul 29, 2008 | 1992 Saturn SL2

1 Answer

Ford maverick

i have the same problem. im told its the abs sensor ring. £300 to fix

Jul 14, 2008 | 2003 Ford Ranger Regular Cab

Not finding what you are looking for?
1992 Mitsubishi 3000GT Logo

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8729 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides