Question about 1996 Mercury Grand Marquis

Open Question

How to replace heater core in 1996 Mercury Grand Marquis

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 328 Answers

SOURCE: mercury grand marquis

it is on the fender near the battery and is also referred to as the starter solenoid (if you follow the large wire from the positive terminal of the battery at the other end will be your relay/solenoid)
hope this helps!

Posted on Feb 28, 2009

  • 178 Answers

SOURCE: Heater Core Replacement

hello your heater core is normally in the heaterbox pass side some fords had a access plate behind the glove box wich i hope you have how to find out remove your contents out of glove box undo holders if wire unscrew if rubber stoppers reach in bend in so glove box lid drops all the way down now look straight in is there a rectangled plate similar to a car radio size with hold down bolts usaull 6 or 8 1/4 hex if not you have a internal you have to look at the front off your heaterbox facing pass side there will be a area that splits apart held in with 1/4 inch or 5/16 hex bolts all have to come out lower part of dash board needs to be unbolted to get the face out if you have ac wich you most likely do it is a lot harder all lower duct work needs to be removed goodluck

Posted on Sep 13, 2008

  • 77544 Answers

SOURCE: Cost to replace and repair heater core in 99 Grand Marquis

about $1200 US, this requires the dash be pulled out, about 12 hours of labor.

Posted on Mar 24, 2009

  • 1 Answer

SOURCE: rear shocks on a 1996 Mercury Grand Marquis

Raise car under frame then put jack under axle before removing the shock.
Can use locking pliers to hold the shaft from turning (may have to cut away dust boots). Top nuts are accessed and can be seen from the wheel wells or from the gap between the trunk and mount frame (can't see nut from this angle). Take care with fuel lines near the driver side nut.
Preventing shafts from turning on new shocks will be tough. Make sure you have a proper tool to fit top of shaft with enough room between top of shaft and trunk (gap decreases as the nut is tightened) so the tool can be removed.

Posted on Mar 30, 2009

old marine
  • 2039 Answers

SOURCE: quote to change heater core

If you're in the US, you can use this web site to get an estimate.

Posted on Nov 30, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Is there a diagram for the removal of a heater core from a 1996 Grand Marquis?

idk but if you go to a garage they might be abel to print you one off

Nov 02, 2011 | 1996 Mercury Grand Marquis

1 Answer

1998 mercury grand marquis heater doesnt work only cold air comes out the air cond works fine the enginecoolant is new, the engine doesnt overheat.

Either your heater control valve is not properly operating or your heater core is clogged. Locate the heater control valve under the hood, should be close to firewall on heater hose, have someone adjust temperature from hot to cold and see if you can see the heater control valve operating if so replace the heater core, if its not doing anything replace it(heater control valve).

Feb 19, 2011 | 1998 Mercury Grand Marquis

1 Answer

I do not have any heat in my 1996 grand marquis

could be heater control or plugged heater core.. heater core could be cleaned out by unhooking heater hoses and running water through or a radiator flush.. if its your valve youll need to replace..

Feb 06, 2011 | 1996 Mercury Grand Marquis

1 Answer

Where is the heater core located in a 1996 Grand Marquis with a 4.5 liter engine? Is it difficult to change or labor intensive?

Above the passenger's feet inside the dashboard. they are a pain in the *** to replace. have it done at a shop where they specialize in car heating and A/C systems. if you pull a dozen dashboards out every month you get good at it and know any short cuts.

Dec 13, 2010 | 1996 Mercury Grand Marquis

1 Answer

Is it difficult to replace the heater core in a 97 mercury grand marquis?

It's time consuming. you have to drop the whole dashboard and steering colum in order to get to the heater core. In a scale of 1-10 with 10 being the hardest, i say it's an 8.

Feb 08, 2010 | 1997 Mercury Grand Marquis

1 Answer

Cost to replace and repair heater core in 99 Grand Marquis

about $1200 US, this requires the dash be pulled out, about 12 hours of labor.

Mar 24, 2009 | 1999 Mercury Grand Marquis

Not finding what you are looking for?
1996 Mercury Grand Marquis Logo

Related Topics:

291 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

77514 Answers


Level 3 Expert

5627 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides