Question about 2007 Mazda Tribute

Open Question

How do you clear the low tire pressure code on a 2008 Mazda Tribute. Checked air pressure..but code is still on...

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: air bag light on and off on a 04 tribute

had the same prob on mine underneath the front seats are seat belt tensioner plugs 1 under driver and 1 under pass. seat unplug them and plug them back in , i found this solution on this site somewhere and it worked saved me a lot of money, almost took it to the dealer

Posted on Mar 27, 2009

Ad
mrgreenz
  • 962 Answers

SOURCE: engine light on mazda tribute 2002

Have it checked again and see what code it is. if it is P0401 it is probably the sensor shown below, The DPFE (Diferential Pressure Sensor)sensor is usually mounted on the engine and is connected to the pipe that runs from the exhaust manifold to the EGR valve with two rubber hoses. When the sensor goes bad, the Check Engine light comes on and typically sets any or all of teh following fault codes: P0171 & P0174 (lean codes), and/or P0401 (insufficient EGR flow). Nine out of ten times, the fault is not a bad EGR valve or a vacuum leak, but a bad DPFE sensor. A replacement costs about $112 at Ford, or about $48 at an aftermarket auto parts store.I hope this helps.

Posted on Nov 08, 2008

  • 1 Answer

SOURCE: lexus ls430 2004 tire pressure indicator

Veve713:
You probably didn't need new tires unless you had some miles on it. Remember that the spare tire also has a pressure monitor as well. It most likely is causing the low tire pressure light on the dash and only needs to be inflated back to what ever your other tires are set to. I had the same problem on my RX and took it back to the dealership where they told me since the spare is exposed to the same elements (it's under the back of the RX - you have to use the tire iron to let the spare down), it will inevidably lose air.

Good luck.

MDGolfHacker

Posted on Dec 06, 2008

rockitman187
  • 2559 Answers

SOURCE: gmc sierra 2008 low tire pressure problem

You can follow this to reset it.
Ignition ON, initiate the TPM Learn Mode
using one of the following procedures:

  1. On vehicles equipped with keyless entry, simultaneously press the keyless entry transmitters lock and unlock buttons until a double horn chirp sounds indicating the Learn Mode has been enabled. The left front turn signal will also be illuminated.
  2. On vehicles not equipped with keyless entry, press and release the driver information center (DIC) INFO button until the TIRE LEARN message appears on the DIC display. Press and hold the SET/RESET button until a double horn chirp sounds indicating the Learn Mode has been enabled. The left front turn signal will also be illuminated.
  3. Increase/decrease the tire pressure for 8-10 seconds then wait for a horn chirp. The horn chirp may occur before or up to 30 seconds after the 8-10 second pressure increase/decrease time period has been reached. Once the horn chirp has sounded, the sensor information is learned and the turn signal in the next location to be learned will illuminate.
    After the horn chirp has sounded and the right front turn signal is illuminated, repeat step 2 for the remaining 3 sensors in the following order:
    3.1. Right front

    3.2. Right rear

    3.3. Left rear

    When the left rear sensor has been learned and a double horn chirp has sounded, the learn process is complete and the RCDLR exits the learn mode.
    Ignition OFF, adjust all tires to the recommended pressures

Posted on Jan 22, 2009

  • 1 Answer

SOURCE: How do you reset a low tire pressure warning on a 2008 Jetta?

Do not..DO Not disconnect the battery ever!
it wll cost you a trip to the vw shop to re set the computer.......

bin there done that $46.00

Posted on May 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the oil pressure sensor location on a 2008 Mazda tribute


Hi there my name is Brandon I am a mechanical n electronic engineering technician I think it is next to the oil filter I have to look it up in my book to be 100 percent sure

Feb 01, 2016 | 2008 Mazda Tribute

1 Answer

How to enter new stereo code


Visit the Mazda website to download the owner's manual.

Dec 22, 2013 | 2008 Mazda Tribute

1 Answer

My 2008 Envoy has the tire sensors that connect to the computer .. I recently had two tires replaced and was having no problems but since the weather has gotten colder when I first start the engine the...


Air pressure in the tires drops when it is cold (as much a 5 PSI), as you drive they heat up and that makes them fall within the correct pressure limits to turn off the low tire pressure warning. I suggest you get an accurate tire gauge and air your tires up to 32 PSI all around.

Dec 13, 2011 | 2008 GMC Envoy

1 Answer

I have a 2008 Mazda CX7 the light on the dash is on saying that my tire is low. I checked each tire the lowest is 23 the rest are about 29. What is the accurate tire pressure?


set all the tire pressures at 32-35 and drive the car as it may take a little time for the system to reset itself.there should be a decal on the drivers door that has the tire pressure on it.

May 05, 2011 | 2008 Mazda Cx 7

1 Answer

A symbol that looks like a small building wiith columns in it keeps popping up after i have driven about 15 miles. Since my used 2001 Mazda tribute did not come with a manual, and I am pretty strapped for...


Please refer to your owners manual, it should have what the symbol stand for as I don't have visual picture to refer to. Thanks. It could be the tire pressure monitoring symbol saying that one of your tire has low pressure. I'm not sure since I cannot relate to "a small building with columns". acutally look like. But I'm sure your owners manual have it and what it is.

Jan 14, 2011 | 2001 Mazda Tribute

1 Answer

2008 mazda 3 "!" light came on. What does it mean?


Low tire pressure. Look at the tire pressure sticker in the drivers door jamb, and set all of your tires to the correct spec. If you have a slow leak, or a bad tire pressure sensor, it won't go away on it's own.

Sep 30, 2010 | 2008 Mazda Mazda3 Hatchback

2 Answers

Warning Light


That exclamation light on the dash board indicates low tire pressure. Check the air in all your tires and make sure they are all filled to proper levels and it should turn off.

Apr 11, 2009 | 2006 Mazda Tribute

1 Answer

Low tire pressure light stays on


Hi there. depending on the outside temperature of where you live , you may encounter this problem. If the temperature goes below -1 C , there is a chance that the tire pressure light will go on. This is because the pressure in the tires decrease in cold temperatures and will increase when it gets warmer. I had this problem with my vehicle too and when the temperature warmed up today the light finally went off.

Dec 29, 2008 | 2006 Mazda Tribute

Not finding what you are looking for?
2007 Mazda Tribute Logo

Related Topics:

743 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...